Question about 1995 Toyota Pickup

1 Answer

Hard to start. chokes out when starting acts like it is not getting enough gas. ok once it gets going.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 347 Answers

Check maf sensor

Posted on Oct 09, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Maruti gypsy


You know how you have to mash the gas to the floor to set the choke? Every time you do that, a little jet of gas is sprayed downward into the air stream going down the throat of the carburetor. I think the accelerator pump inside the carburetor is doing that. But it should be enough gas to start a cold engine if your choke is adjusted right. You can observe the gas going down the carburetor... bore, I guess is the right word. (Throat is a common term, air horn is the correct term.) But to observe it, you have to take the air breather off, hold the choke valve open, and look down the throat while you pull the throttle lever to wide open throttle. Just try it a couple of times, and see if gas is being sprayed down the carburetor's air horn. It may help to use a flashlight. Of course, this is all done with the engine off.
You didn't say how it ran once started and warmed up. Is the power and performance satisfactory? Hard to say if it's a fuel problem. If the problem is only hard to start when cold, it could be your choke not adjusted or working right. You could put in a manual choke, pretty simple kit. People often do this when they don't want to fool with the automatic choke. I'm an old geezer, but I for one am glad that carburetors are a thing of the past (even though my daily driver at present has a carburetor -'87 sentra). Fuel injection is much simpler, and easier to diagnose.

Dec 22, 2013 | 1989 Suzuki Samurai

1 Answer

Starts but dies


run fault codes to find which sensor is faulty --check for MAP/MAF sensor problems.

Nov 17, 2013 | 1999 Ford Ranger SuperCab

1 Answer

Runs ruff and hard to start


Don't need to be here

Explain all that at a repair shop

Dec 17, 2012 | 1995 Chevrolet Lumina

1 Answer

When my 1972 chevrolet 350 4 barrel is warmed up it acts like its not getting gas and jerks and eventually dies. if i wait a few minutes it will start up but after slight acceleration it starts it aga


Good chance it is not getting fuel, or enough fuel.
When the rig is cold, the choke is closed. As it warms up, the choke opens.
If the metering jets inside the carb are dirty, they may not be letting enough fuel into the barrels. You could also have a vac leak that is masked by the choke until the engine warms up.

Jul 21, 2012 | Cars & Trucks

2 Answers

Will start but it won't stay on once I step on the


not getting air or exhaust ....its being 'choked'

Nov 01, 2011 | 1989 Jeep Cherokee

1 Answer

Hard starting '88 samarai


check all of your fuel lines for possable leaks. also on the front of your carb there is a vacuume port that con come loose adn allow air into the float bowl causing the fuel to siphon back to the tank. any other questions check out www.zuwharrie.com

Mar 29, 2009 | 1987 Suzuki Samurai

1 Answer

My beretta wont start after I buy gas or it acts like its going to quit once i do get it started. It seems to run ok once i finally get it started. it only seems to act this way each time i buy gas.


check for water in the tank...When adding fuel it gets stirred up and enters the system. There is space beneath the fuel pickup that allows contamination to remain there. Eventually it will get to a point that it becomes critical or rusts tank from the inside. Check inside filter, pour contents into a glass jar. If you find any water drop tank and clean.

Mar 18, 2009 | 1995 Chevrolet Beretta

Not finding what you are looking for?
1995 Toyota Pickup Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...