Question about 1997 Oldsmobile Achieva

1 Answer

Where is starter locater 97 4 cyl acheiva - 1997 Oldsmobile Achieva

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Oldsmobile Master
  • 76,691 Answers

Bottom of the engine at the transmission bell housing, you change it from under the car.

Posted on Oct 06, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low side a/c charging port location on a 97 Oldsmobile Acheiva


The low side service port is located on the low pressure line coming off the back of the compressor. Its not easy to see or get to.


26214558-hoedyifrnzupfxfowgwvgd2b-5-0.gif

Jun 08, 2016 | 1997 Oldsmobile Achieva

1 Answer

1997 OLDS ACHEIVA NUM. 1 CYL MISSES


Need to have a compression test, possible a valve burnt out or not working (stuck open)? Take rocker cover off, turn engine over by hand, see if you can see movement in the valves on NO1 cylinder

Aug 27, 2012 | 1997 Oldsmobile Achieva

2 Answers

Where is the crank position sensor located on a 1996 oldsmobile acheiva 4 cyl



  • Near the oil filter on the front side of the block. (See diagram)
  • Just pull the connector.
  • Then remove the screw from the sensor.
  • Add a little engine oil to the new sensor "O: ring for lubrication.
  • Install new Cam Sensor.
  • Attach screw.
  • Attach connector.
  • Job complete.

ironfist109_23.gif


Regards, Tony

Jun 01, 2011 | 1996 Oldsmobile Achieva

1 Answer

Where are the oxygen sensors located on a 97 olds acheiva? I bought two. One has longer wire than the other. Which one goes where?


The sensors screw into threaded flanges on the exhaust pipe. There will be one before the catalytic converter called the "upstream" sensor. It will have the short wire. The second, or "downstream"sensor has the long wire and is located after the catalytic converter. You can purchase a special tool for removing the sensors. If the sensors are positioned so as to allow the use of regular hand tools, you may be able to change them without the special tools. It is best to change the sensors while the exhaust pipe is cold. A hot exhaust pipe will cause the threaded flange to expand, making removal more difficult.

Mar 14, 2011 | 1997 Oldsmobile Achieva

1 Answer

Im trying to locate the starter on a 1996 oldsmobile acheiva


take it to a local muffler shop, ask them to put your car up on a lift when they get a free moment and point out the starter to you. access is almost always easier when the car is up on a lift. starters are all in the same place, parallel to the crankshaft, and bolted into the transmission bell housing. if you think it is bad, give them forty bucks and they will most likely swap it for you, just takes a few minutes if you have the tools and the car is up on a lift.

Dec 09, 2010 | 1996 Oldsmobile Achieva

1 Answer

Sometimes my starter just clicks-other times starts right up 97 acura tl 6 cyl-any suggestions


either the SOLENOID or loose battery cables(either at the battery side or the starter side)

Nov 13, 2010 | 1997 Acura TL Series

1 Answer

Random/multiple missfire on 97 olds acheiva 2.4l error code 300


Replace the cap and rotor with the spark plug wires

Jul 15, 2009 | 1997 Oldsmobile Achieva

1 Answer

97 buick skylark wont start


if starter fluid made it chug, I would suspect fuel pump fuse, relay or pump, also fuel filter.

Dec 29, 2008 | 1997 Buick Skylark

Not finding what you are looking for?
1997 Oldsmobile Achieva Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...