Question about 2002 Suzuki Grand Vitara

Open Question

Where is the plug in point for engine management.

Posted by on

  • jakirajakir May 11, 2010

    Find your solution from bellow



    » Mazda ( 3781 Solution )

    » Mercury ( 8762 Solution )

    » Mitsubishi ( 4765 Solution )

    » Nissan ( 7654 Solution )

    » Oldsmobile ( 2467 Solution )

    » Pontiac (1986 Solution )

    » Saturn ( 3997 Solution )

    » Subaru ( 4225 Solution )

    » Suzuki ( 4832 Solution )

    » BMW ( 3876 Solution ) » Buick ( 2987 Solution ) » Chevrolet (12345 Solution )

    » Chrysler ( 3456 Solution ) » Dodge ( 4765 Solution )

    » Ford ( 11345 Solution )

    » GMC ( 6754 Solution ) » Honda ( 8943 Solution )

    » Hyundai ( 4187 Solution )

    » Jaguar ( 2876 Solution )

    » Lincoln ( 3346 Solution )

    » Toyota ( 9761 Solution )

    » Volkswagen ( 4681 Solution )

    » Volvo ( 2875 Solution ) 167.12

×

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2008 Ford Focus won't start no fuel delivery to filter is this the fuel pump if so where is it located on the car?


is the filter plugged to the point of not allowing fuel flow. if its good then the problem is with the fuel pump either the pump itself or an electrical problem with the wiring or plug.

Feb 21, 2015 | 2008 Ford Focus

2 Answers

I have a daihatshu charade 1000cc 3 cylinder wich has no power that goes to the spark plugs i have changed all the fuses but still no luck can anyone please assist me in this matter


There are fuses in the engine bay , as well as in the cabin , that control engine management. As well as relays. have you done any electrical work on it recently?

Jan 24, 2015 | Cars & Trucks

1 Answer

Vito 2006 109cdi. fuse number 41 is blowing (engine fuse)


engine light stays on
the ecu will have fault codes stored to be read
that will point to the cause and a fix of the over load

my best information on a vito if diesel..says
10 amp fuse 41 . glow plugs


you must need the van on the road very badly
30 amp in a 10 amp fuse position can
melt the wiring even a fire


index-ldszvhuomwkbtubxskurqnxk-1-0.jpg

Apr 06, 2017 | Cars & Trucks

1 Answer

My 92 rodeo will crank but wont start im afraid of flooding it...does it mean its out of gas??


It may mean the engine is not getting enough fuel, if fuel is in the tank. This no start condition could be related to other issues; no spark to the plugs, poor fuel pressure or defective engine management component(s). Hard to say at this point.

Feb 23, 2011 | Isuzu Rodeo Cars & Trucks

1 Answer

1992 Buick Century misses at all speeds, will occasionally die while at idle, but starts immediately and runs well except for the misfires. New air filter and plugs installed. Thinking plug wires and fuel...


At this point, replacing the plug wires is a great idea, especially if they are worn or over due for replacement, Always start with the basics...then proceed with diagnostics with possible engine management causes.

Feb 22, 2010 | 1992 Buick Century

1 Answer

Engine managment light flashes (glow plugs light)


the car is going into limp mode due to an engine management fault. have to check what the fault is with a code reader. if the milage is high 100,000+ could be a turbo fault (overboosting), as this will put the car into limp mode.

Feb 21, 2010 | 2005 Volkswagen Passat

1 Answer

1988 toyota camery firering order i need the diagram of the engine and how the spark plugs go on the engine


THE spark plugs are 4 and the firing order is from the front (thats were the fanbelts are )and they are 1342
so the distributor the timing mark on the bottom pully and the rotor button point to the No1 plug lead and points just about to open,and the next lead will point to No3 lead ,and if so then you have the correct timing,,but the points set at 0.012" and the plugs to 0.025" ..And when engine idleing adjust timing on the distributor to advance (thats the oppersite to the way it fires and do it with the vacuum pipe off ,,then when engine runs good ,then tighten calmp and refit the vac pipe and test run.

Nov 15, 2009 | Toyota Camry Cars & Trucks

1 Answer

Engine idling rough after spark plug replacement on a 92 Toyota Pickup V6 3.0L


I would guess that you instaled non-Toyota plugs,The OEM plugs are >>>critical<<< to proper performance. As a Toyota Service Manager, I cannot stress that point enough.

Feb 03, 2009 | 1992 Toyota Pickup

2 Answers

4.3 L Vortec problem, can anybody point me in the right direction


check the temperature sensor for the computer. it may be telling the computer that the engine is still cold and causing the engine to run too rich at warmer temps

Jan 16, 2009 | 1994 GMC Jimmy

Not finding what you are looking for?
2002 Suzuki Grand Vitara Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...