Question about 2005 Chevrolet Avalanche

Open Question

Performance Chip Installation

I have a 2.0l SOHC VTEC Honda Accord 4cyl SE yr 2000
F Series engine (F20B6)
I received a performance chip with black and red wires. I need to splice between the IAT sensor wires. My IAT sensor has red/yellow, green/white and red/green wires. Which wire/s do I connect the red terminal to and which wire/s do I connect the black terminal to?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whats the name of the wiring harness thats needed in a swap from non vtec to vtec


92-00 Honda Engine Swap Wiring Guide VTEC AND NON ...

honda-tech.com/.../92-00-honda-engine-swap-wiring-guide-vtec-non-vt...
Oct 8, 2011 - 92-00 Swap Wiring Guide for VTEC and Non-VTEC ... try to compile one thread that would try to answer pretty much 95% of all questions ... I wanted to do this because often times I end up posting the same thing to ... to ECU harness so using an EX/SI 92-95 engine harness will make VTEC plug and play.

97 accord non VTEC to VTEC ' HondaSwap

hondaswap.com > Model Specific > Accord
Jan 16, 2010 - 15 posts - ‎6 authors The distributors may be different on the vtec/non vtec. .... As was previously stated, allyou need to do is add wiring for VTEC. ... that connect to the ecu to the connectorsthat wire in your engine harness while the engine is out... f22b2 non vetec swap to f22b vtec need help asap
3 posts
Sep 22, 2012
96 accord head swap non vtec to vtec
10 posts
Jun 1, 2012
1990 USDM CRX Si D16A6 to ZC SOHC non-VTEC ...
20 posts
Mar 7, 2012
99 Accord non-vtec to vtec engine swap, need help
5 posts
Sep 27, 2011
More results from hondaswap.com

Nov 03, 2015 | Cars & Trucks

1 Answer

I have 96 honda accord ex 4 cylinder vtec engine the engine will no Rev past 3500 rpms


maybe a sensor? cam position or flywheel? assume b series? my cars d series theres a chip in the distributer that fails though u may be onsparkless ign.get a fault code reader

May 23, 2015 | 1996 Honda Accord

2 Answers

Donde se encuentra el filtro de gasolina en mi honda odyssey 1999


For 1999 Honda Truck Odyssey 3.5L MFI SOHC VTEC 6cyl the Fuel Filter is located under hood, driver side, rear side of strut tower, mounted in corner.

994d0bf.jpg

Fig. 1: The outlet line on a firewall-mounted fuel filter uses a banjo bolt type fitting- CRV and 4-cylinder Odyssey models

Hope helps (remember rated this).

Jul 09, 2010 | 2000 Honda Odyssey

1 Answer

What Performance Engine modifications can i get done to it


The possibilities are limitless, I have done many many swaps. My favorite is the H22A, thats a 1992-1996 Prelude into this vehicle. But you can pick almost any fast 4-cylinder front wheel drive honda, the integra GSR is pretty awesome, uses a B16 Vtec engine. The only thing you need is money. :)

Jun 19, 2010 | 1988 Honda Accord 4 Door

3 Answers

Location of speed sensor on 97 honda accord


think its on the gearbox diff unit

Nov 10, 2009 | 1997 Honda Accord

1 Answer

Connector for Speed Sensor on1996 Honda Accord Auto Trans.


If you are talking about just plugging into the speed sensor yes. A VTEC and NON-VTEC are one and the same.

Dec 13, 2008 | 1996 Honda Accord

2 Answers

Diagnostic codes


Please rate me solved...thanks!
DTC P1259: VTEC SYSTEM MALFUNCTION
1. Perform PCM reset procedure. See SELF-DIAGNOSTICS - INTRODUCTION article. Start engine
and run at 3000 RPM with no loads and transmission in Park or Neutral until radiator fan comes on. Road
test vehicle. Accelerate in 1st gear to an engine speed over 4000 RPM and hold that engine speed for at
least 2 seconds. If DTC P1259 is not indicated during first road test, repeat road test 2 more times. If DTC
P1259 is indicated, go to next step. If DTC P1259 is not indicated, problem is intermittent. System is
okay at this time. Check for poor connections or loose wires at VTEC solenoid valve connector and PCM.
See ENGINE PERFORMANCE WIRING DIAGRAMS article. Repair as necessary.
2. Turn ignition off. Disconnect VTEC pressure switch 2-pin connector. Check for continuity between
VTEC pressure switch terminals. If continuity exists, go to next step. If continuity does not exist, replace
VTEC pressure switch.
3. Turn ignition on. Measure voltage between ground and VTEC pressure switch harness connector terminal
No. 2 (Blue/Black wire). If about 12 volts exist, go to next step. If about 12 volts do not exist, check for
an open or short in Blue/Black wire between VTEC pressure switch and PCM 31-pin connector "C"
terminal No. 10. Repair as necessary. If wire is okay, substitute a known-good PCM and recheck. See
SUBSTITUTING PCM in SELF-DIAGNOSTICS - INTRODUCTION article. If symptom or problem
goes away, replace original PCM.
4. Measure voltage between VTEC pressure switch harness connector terminals. If battery voltage exists, go
to next step. If battery voltage does not exist, repair open in Brown/Black wire between VTEC pressure
switch and ground connector located on left side of engine, under throttle plate, between end of radiator
hose and cooling fan switch. See ENGINE PERFORMANCE WIRING DIAGRAMS article. If wire is
okay , substitute a known-good PCM and recheck. See SUBSTITUTING PCM in SELFDIAGNOSTICS
- INTRODUCTION article. If symptom or problem goes away, replace original PCM.
5. Turn ignition off. Disconnect VTEC solenoid valve connector. Measure resistance between ground and
VTEC solenoid valve connector. See ENGINE PERFORMANCE WIRING DIAGRAMS article. If
resistance is 14-30 ohms, go to next step. If resistance is not 14-30 ohms, replace VTEC solenoid valve.
6. Remove VTEC pressure switch and install Pressure Gauge Adaptor (07NAJ-P07010A) and A/T Low
Pressure Gauge (07406-0070300). Reinstall VTEC pressure switch into adaptor. Connect tachometer.
Start engine and with no loads and transmission in Park or Neutral until radiator fan comes on. Because
engine is running with no load, oil pressure must be checked within one minute. Check oil pressure at
engine speeds of 1000, 2000 and 3000 RPM. If oil pressure is less than 7 psi (48 kPa), go to next step. If
oil pressure is 7 psi (48 kPa) or more, check VTEC solenoid valve. See SYSTEM & COMPONENT
TESTING article.
7. Turn ignition off. Disconnect VTEC solenoid valve connector. Connect a fused jumper wire between
battery voltage and VTEC solenoid valve connector. Start engine and check oil pressure at 3000 RPM. If
oil pressure is more than 57 psi (393 kPa), go to next step. If oil pressure is 57 psi (393 kPa) or less,
check VTEC solenoid valve. See SYSTEM & COMPONENT TESTING article.
8. Ensure jumper wire is still connected to VTEC solenoid valve connector. Start engine and allow it to idle.
Set engine speed to more than 4000 RPM and measure voltage between ground and PCM 31-pin
connector "C" terminal No. 10 (Blue/Black wire). See ENGINE PERFORMANCE WIRING
DIAGRAMS article. If battery voltage exists, go to next step. If battery voltage does not exist, replace
VTEC pressure switch.
9. Turn ignition off and disconnect jumper wire. Check for continuity between VTEC solenoid valve
harness connector and PCM 25-pin connector "B" terminal No. 12 (Green/Yellow wire). See Fig. 2 . See
ENGINE PERFORMANCE WIRING DIAGRAMS article. If continuity exists, go to next step. If
continuity does not exist, repair open in Green/Yellow wire between VTEC solenoid valve connector and
PCM 25-pin connector "B" terminal No. 12.
10. Check for continuity between ground and VTEC solenoid valve connector. See ENGINE
PERFORMANCE WIRING DIAGRAMS article. If continuity exists, repair short in Green/Yellow
wire between VTEC solenoid valve connector and PCM 25-pin connector "B" terminal No. 12. If
continuity does not exist, substitute a known-good PCM and recheck. See SUBSTITUTING PCM in
SELF-DIAGNOSTICS - INTRODUCTION article. If symptom or problem goes away, replace original
PCM

Jun 21, 2008 | 1999 Honda Accord

Not finding what you are looking for?
2005 Chevrolet Avalanche Logo

Related Topics:

201 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...