Question about 1999 Dodge Ram

1 Answer

I put a tranny in and it starts in drive its fine in reverse its fine but it won't idle if u give it gas its ok but not when i leave it alone i broke an o2 sensorwould that do it????

Posted by on

  • chad reeves
    chad reeves Oct 06, 2009

    i went and bought one at oriellys and put it in and it still doesn't work now it tries to start it stumbles and then dies what do i do

  • chad reeves
    chad reeves Oct 06, 2009

    thanks

×

1 Answer

Yes, replace the broken O2 sensor and everything will go back to normal. A faulty O2 sensor would cause the idle to run rough because it is the primary measurement device for the fuel computer control in your car to know if the engine is too rich or too lean

Here is a link to buy a replacement:
http://www.autopartswarehouse.com/details/QQDodgeQQRam_2500QQWalker_ProductsQQOxygen_SensorQQ19971999QQ25024080.html?apwcid=P1135867996W43b3f85c7ab9e&gan=1

Posted on Oct 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Car will start but put it in gear engine will die


engine starts with no problem; but, when I put in gear and ...

www.cargurus.com > Questions > Hyundai > Sonata

CarGurusNov 15, 2012 - The engine just fall dead when you step on the gas; it seems to jerk before ... My car does the same thing but i put it in neutral n it starts up. ... I have a 2004 kia optima it jerks when I go into reverse it was driving ... start and run fine butwhen I put it in drive or any other gear it dies! ... 2002 Hyundai Elantra GT.

Engine stalls when tranny put in Drive or Reverse - Kia Forum

www.kia-forums.com/kia-carnival...2002.../43407-engine-stalls-when-tr...

Feb 28, 2008 - 10 posts - ‎3 authors
Give it a little gas before putting in D or R and it will go. .... When I start the van cold and shift the tranny into drive or reverse.....the whole front ... won't run in forward gears - Kia Forum
10 posts
May 25, 2012
Intriguing problem - engine rough idle & hesitation ...
10 posts
Aug 31, 2011
2006 Kia Spectra engine stalls and bad idle, cleaning the ...
10 posts
Aug 30, 2010
2002 Kia Spectra Won't Go Out of Park - Kia Forum
3 posts
Oct 28, 2008
More results from www.kia-forums.com

Dec 17, 2015 | 2002 Kia Rio

1 Answer

2004 chevy cavalier goes in reverse fine but when put in to drive it will not go unless you push the gas pedal for a minute or two giving it gas.


Fluid level OK in tranny. Was fluid and filter changed lately. Are there any tranny leaks from gasket area or lines or out that back.

Oct 11, 2014 | 2004 Chevrolet Cavalier

1 Answer

Stalls put reverse drive


Have the computer scanned for codes. Bad gas?

Jun 25, 2014 | 1997 Nissan Pathfinder

1 Answer

Engine revs but no acceleration


Clutch plate and pressure plate seem to be too weak to pull the car. Or one of the CV joints is detached from the gear box. To test the clutch plate, park the car on flat surface. Pull the hand brake up, start the car, depress the foot brake pedal, depress the clutch pedal, put the car in 1st gear, press the gas pedal and leave the clutch pedal at once, while keeping the brake pedal depressed.
Follow one of the two following statements:
1. Engine does not shut down and remain start. (Clutch plate, pressure plate and clutch bearing defective - Replace all as a set)
2. Engine shuts down. (Clutch system is OK and does not require any repair).

May 22, 2013 | Honda Civic Cars & Trucks

1 Answer

Dies when i put it in drive or reverse


knowing pontiacs it's either something with the electrical system, or the transmission.

May 20, 2012 | 1997 Pontiac Grand Prix

2 Answers

My 98 chevy k1500 5.7 vortec started up fine i put it in reverse to bak up when i released brake it died an started bak up fine a few days later i died while driving so i replaced battery an altenator it...


Check your fuel pressure it should be 60-66 psi with key on engine off.If its not within these specs then replace the fuel pump and filter.Sounds like the pump might be weak.

Jan 08, 2012 | 1999 Chevrolet Silverado 1500

1 Answer

My '94 Ford Taurus stalls whenever its idling in neutral or drive, in park its completely fine. When I give it gas in drive or neutral its completely fine and runs perfect but if i come to a light, or slow...


Disconnect your battery black wire off for 1/2 hour reconnect turn on all assesorys lights radio blower start car leave run for 5 min shut off for 5 min idle is controled by the computer the load
brings the idle up. Should be ok if not you may have to ajust the idle screw a little and then do this all over

Feb 01, 2011 | Ford Taurus Cars & Trucks

1 Answer

Fine idle on startup can stall when warm


change your oxygen sensor thet is whyoillight lights on

Oct 23, 2008 | 1992 Lexus Sc 400

Not finding what you are looking for?
1999 Dodge Ram Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...