Question about 2000 Ford Crown Victoria

1 Answer

I have been fighting a no start issue on my 00 crown vic.

I replaced fuel pump 1 month ago. car was running fine. now car quit running today. I connected a fuel pressure gauge to the rail and tested it but I only get 2 psi. When I crank engine the pressure gauge goes backwards. Can someone tell me if I trully have another bad fuel pump or has the regulator gone bad. Or something else that I might be missing.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 432 Answers

I hope you have replaced the fuel filter. Every 30000. I took the one off my moms Vic.and we could not blow through it.
I hope this helps you.

Posted on Oct 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine cranks, runs for 1 or 2 seconds and then stops.


Two items to check. The crankshaft sensor will reduce fuel pump pressure if it miscounts the RPM. The plastic strainer in the fuel tank can break apart and clog the pump intake in the tank. When the engine quits, the fuel pump is stopped and the loose particles are returned to the tank bottom.

In either case, try checking the fuel pressure at the test tap on the fuelrail.

Feb 03, 2014 | Ford Crown Victoria Cars & Trucks

1 Answer

'99 Ford Crown Vic LX: #12 30A Maxi fuse blows seconds after starting or ignition turned on.


i had this problem with my 1999 jeep grand cherokee laredo with the brake lights it kept popping fuses right after the ignition was turned on try putting a higher amp fuse in place of the old one that keeps blowing then check for shorts to the starter and check grounds and wires and also the transmission issue check the fluid and then if the fluid is fine change the transmission filter the filter may have not gotten replaced when the transmission was rebuilt and may be clogged or dirty

Oct 04, 2012 | 2002 Ford Crown Victoria

3 Answers

2000 Crown Vic cranks but won't start.


Check the fuel pump reset switch again, if it is popped back out then replace that little switch in the trunk, any ford one will do. it works off a magnet and a bearing to close the circuit for the fuel pump. easy fix.

Oct 05, 2009 | 2000 Ford Crown Victoria

2 Answers

We have a problem with a 1992 crown vic. It bogs


run a presher test on your fuel pump.check your fuel filter. have nice day

Apr 02, 2009 | 1992 Ford Crown Victoria

1 Answer

2005 Crown Vic Police Interceptor: Starts then stalls


Have you checked the fuel filter. Fuel pump will pressure up, but fuel filter could be clogged and not work without the pressure of the fuel pump.

Nov 27, 2008 | 2005 Ford Crown Victoria

1 Answer

1996 Crown Vic, Valve noise under heavy acceleration


No use what's in there, but have the engine de-carboned by a Ford dealer, or remove the octane adjust shorting bar located near the ignition module (retards timing 2 degrees), this will in most cases cure the issue unless there is allot of carbon in the cylinders. There are also methods of ing this de-carbon procedure at home, check on the internet for tips.

PLEASE RATE THIS SOLUTION

Oct 22, 2008 | 1996 Ford Crown Victoria

Not finding what you are looking for?
2000 Ford Crown Victoria Logo

232 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...