Question about 1998 Plymouth Breeze

2 Answers

Need diagram for the vaccum line on the throttle body and where it goes 1998 Plmouth Breeze 2.4 liter DOHC 4 cyclinder. The car idles real bad and rich fuel. The vaccum line that comes off of the throttle is not hooked up to nothing and i need to know where it goes.

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Plymouth Master
  • 6,674 Answers

For 97, but should help.need diagram for the vaccum line on the throttle - dc6deb5.gif

Posted on Oct 06, 2009

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

There should also be a map under the hoood, right above the radiator

Posted on Jul 17, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Taurus vacuum diagram

it would usually be the tps (throttle positioning sensor) but you can also check the icv (idle control valve)

Dec 31, 2013 | Cars & Trucks

1 Answer

I have a 2000 plmouth neon dohc 2.0 it idles fast in park and n when you put it in drive it tries to pull its self ived already changed the idle control valve.

Sounds like a leaking intake gasket. while its running, spray brake cleaner where the intake bolts to the block. If it idles up while spraying its either the intake gasket or a vaccum line. Good Luck.

Aug 01, 2011 | Plymouth Neon Cars & Trucks

1 Answer

Yes ihav e 2003 envoy with 4.2 liter an it has started idiling rough

There are a few things that you can do, do get it idling correctly, and it's fairly inexpensive.

1. Clean your throttle body with throttle body cleaner, with the battery disconnected. Needs to be shiny. When finished, drive around for 20 minutes or so with all accessories turned off, so the computer can relearn the newly cleaned TB. About $7 for the cleaner

2. Replace your spark plugs with A/C Delco 41-103, will idle better with this plug. Around $7 ea
3. Replace your upstream 02 sensor, the one right after the exhaust comes out of the engine, easy to replace. Between $67 and $80, try to stay away from Bosch.
4. Replace your fuel filter around $15 or less.
5. Check your vaccum lines for leaks.

Jan 31, 2011 | 2003 GMC Envoy

1 Answer

I need the firing order of a 1998 dodge stratus 2.4 4 cyclinder

For 1998 Dodge Stratus 2.4 liter DOHC L4 VIN "X" check...


Hope helped (remember rated this). Good luck.

Feb 17, 2010 | 1998 Dodge Stratus

1 Answer

Vaccum hose diagram for 88 chevy truck. I put a 350 motor in my 88 chevy 1500 truck from a 95 suburban. I cant get the throttle body to stop idaling to high. I may need a vaccum line diagram for this motor...

it may not be a vacumn leak from a line,check the throttle shaft for movement,for example,i had a 89 1 ton 350 and my throttle shaft was moving around a lot and in order to keep it from idling high,i had to kick the throttle pedal.But also check the idle air control valve,which is the round sensor on the side of the throttle body.

Sep 10, 2009 | 1985 Chevrolet Chevy

1 Answer

I have a 1994 Chevy Corsica with a 3.1 liter engine. The engine dies every so often when it hot and wont restart until 4-5 minutes later. Have checked vaccum lines, map sensor, and replaced temp sensor. I...

the idle flare up is when u start it the rpms go above normal idle speed for about 3-5 seconds then comes down to normal idle speed,if this car is stalling in park then all u need to do is remove the air cleaner from the throttle body and clean the the throttle blade and bore with a rag with some throttle plate cleaner on it that u can buy in a spray can at all auto parts stores and also take the idle control solenoid offhte side of the throttle body which is near the oil cap and has 2 t20torx head screws holding it on and clean the cone shaped plunger on the end of it with the same cleaner,after these two things are cleaned,reassemble the air cleaner and take it for a short ride so it can relearn idle,hope this helps

Sep 06, 2009 | 1994 Chevrolet Corsica

1 Answer

Rough idle

when was the last time you had a good tuneup sparkplugs,wires if needed and fuel filter and replace the drive belt and also make sure all of the vaccum lines are on and the one behind the throttle body

Feb 11, 2009 | 1996 Ford Ranger SuperCab

1 Answer

1986 Mustang LX 4 cycl won't idle.

check all of the vaccum lines and the one behind the throttle body and the EGR valve and the vaccum pump.

Feb 08, 2009 | 1986 Ford Mustang

1 Answer

Engine idles at 2400 rpm:

You sucking air somewhere!

Jan 19, 2009 | 2000 Saturn SL

Not finding what you are looking for?
1998 Plymouth Breeze Logo

171 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides