Question about 2008 Mitsubishi Raider

1 Answer

How do you remove spare tire - 2008 Mitsubishi Raider

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 869 Answers

U can see the spare tire at the rear or in the cargo of the vehicle. with the help of a wrench remove the nuts and you can take it out

Posted on Dec 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cannot remove spare tire from undercarriage


Hello, this vehicle has a locking device to keep the spare tire from falling down. you will have to perform these steps to remove spare tire.

  • Turn the folding wrench clockwise to raise the jack until it lifts the secondary latch device under the wheel plate.
  • Keep raising the jack until the compact spare tire stops moving upward and is held firmly in place. This lets you know that the secondary latch has released.
  • Lower the jack by turning the folding wrench counterclockwise. Keep lowering the jack until the compact spare tire is resting on the folding wrench
  • Aug 20, 2011 | 2008 Chevrolet Uplander

    1 Answer

    How do i release the spare tire on my 2005 Kia Sedona


    Hi, the spare tire is stored on the underside of the vehicle, under the right-side cargo door. The bolt is located in a recessed area that is protected by a small square plastic covering. To remove the spare tire, find and remove the bolt cover, then use your lug nut wrench to loosen the bolt holding the tire.
    Remove the spare tire fastener's plastic cover, place the lug nut wrench onto the lug nut holding the tire onto the bolt, turn the wrench in a counter-clockwise direction until the tire is released and reaches the ground.

    Jun 20, 2011 | 2005 Kia Sedona

    2 Answers

    Where is the spare on the 1997 Blazer


    Welcome to FIxYa.com


    rear of truck under neath frame


    Regards, Lee Davidian


    Thank you for using FixYa,com.

    Oct 23, 2010 | 1997 Chevrolet Blazer

    2 Answers

    Where is the spare tire located on a 1995 ford aerostar?


    Section 00-02: Lifting, Jacking and Spare Tire Stowage 1995 Aerostar, Ranger, Explorer Workshop Manual
    TIRE STOWAGE Tire, Spare, Removal, Aerostar If the Aerostar is a standard length vehicle the spare tire is mounted inside to a carrier at the left rear quarter panel. To remove the spare tire, remove the wing nut and plate. A flat tire can be temporarily stowed in the same location.



    If the Aerostar is the bus with a standard length body or extended length (all models), the temporary spare tire is stowed at the rear of the vehicle under the body. The Aerostar standard length E-4WD bus spare tire is mounted on the floor.
    1. Insert lug nut wrench into the actuator hole and turn counterclockwise until the cable extends to allow the spare tire to be pulled rearward from under the vehicle.
    1. Slide spare tire to the rear and remove the retainer from the wheel.
    1. To stow cable/retainer with spare tire removed, insert cable fitting into carrier rear wall slot, place wheel retainer against the carrier, and turn lug nut wrench clockwise until slack is removed.
    please rate, thanks

    Jul 09, 2010 | 1995 Ford Aerostar

    1 Answer

    How to open spare tire mounting of montero xls 2002?


    First...... remove spare wheel cover..2 small plastic srewheads on the bottom of tire. open and pull gently on the tire cover
    Second... Remove wheel nuts and there is your spare tire!

    Mar 06, 2010 | 2002 Mitsubishi Montero

    1 Answer

    I can't get the spare tire out of the rack? 2004 yukon


  • Rotate the hoist shaft counterclockwise in order to lower the spare tire to the ground. Continue to rotate the shaft until the spare tire can be pulled out from under the vehicle and removed. If the spare tire does not lower to the ground, the secondary latch is engaged causing the tire not to lower.
  • If the secondary latch is engaged and the cable end is visible, perform the following procedure: 3.1. Tighten the cable by rotating the hoist shaft clockwise until you hear 2 clicks or feel it skip twice. You cannot overtighten the cable. 3.2. Loosen the cable by rotating the hoist shaft counterclockwise 3 or 4 turns. 3.3. If the spare tire can be lowered, repeat steps 1 and 2 to see if the spare tire can be removed. 3.4. If the spare tire cannot be lowered, rotate the hoist shaft counterclockwise until approximately 15 cm (6 in) of cable is exposed. 3.5. Raise and support the vehicle. 3.6. Place a transmission jack, or equivalent, under the spare tire. 3.7. Position the center of the transmission jack under the secondary latch release button at the center of the spare tire. Arrange the arms of the transmission jack so they will support the tire after it has been released. 3.8. Raise the jack until the spare tire stops moving upward and is firmly held in place, releasing the secondary latch. 3.9. Lower the tire. If the spare tire is hanging by the cable, rotate the hoist shaft counterclockwise until the tire is low enough to remove.
  • Feb 28, 2010 | 2009 GMC Yukon XL

    2 Answers

    What key do i need to get our spare tire off our 1994 ford explorer


    The spare tire key/lock on Ford trucks and SUVs is not the same a wheel locks.

    This is a very common problem -- Ford's spare tire key being missing in a used truck, van or SUV. Ford has discontinued this spare lock model, because it obviously sucks. Unfortunately, this means your dealership probably can't order the new spare key for you. The company that made them is still around, and you can find out what size it is and re-order, but this is not the best solution.

    Here is the best answer I found, for what it's worth.

    Remove the spare tire lock completely, and you don't need a key at all. Problem solved. You must first remove the black plastic guide that leads to the spare lock. Then, with a screwdriver push our the lock, or you can pull it out with pliers. Afterwards and forevermore, you can use the black rod extension to turn the spare tire winch mechanism, and it will work beautifully every time.

    If you want to read more details about how to remove the lock, and pictures to guide you, check here: http://www.ford-trucks.com/forums/333925-used-truck-has-no-spare-tire-key-2.html

    Also, if you don't want to drive around with your spare unlocked (because, apparently, people steal spare tires), you can get an aftermarket tire lock for a very reasonable price -- and it will work, and be a heck of a lot better than the stock spare lock/key discontinued nightmare.

    Jan 07, 2010 | 1998 Ford Explorer

    2 Answers

    How does one remove warning for low tire pressure on 2007 Lexus RX400h (Metal caps still in pocket, so that may be issue)


    Are all tires at correct pressure? Some of the cars also use one in the spare tire. if the spare has a tire valve like the other 4 tires it has a sensor.

    Oct 27, 2009 | 2008 Lexus Rx 350

    1 Answer

    Cant release spare tire from under car of 2002 mercury villager. no owners manual available.


    Location of the spare tire and tools
    The spare tire and tools for your vehicle are stowed in the following
    locations:
    Item Location
    Spare tire Under the vehicle, just forward of
    the rear bumper
    Jack assembly Under the third row bench seat in
    the tool bag
    Removing the jack and tools
    1. Lift the 3rd row seat cushion.
    2. Remove the jack assembly from the bag under the seat.

    Removing the spare tire
    1. Open the liftgate, locate the U-shaped slits in the carpet, and flip up
    the piece of carpet to expose the hex nut.
    2. Insert the lug nut wrench on the
    hex nut in cargo floor.
    3. Turn the wrench
    counterclockwise until tire is
    lowered to the ground and the cable
    is slightly slack.
    4. Remove the retainer from the
    spare tire. It may be necessary to
    lift one end of the tire to disengage
    the retainer

    Jul 12, 2009 | 2002 Mercury Villager

    Not finding what you are looking for?
    2008 Mitsubishi Raider Logo

    Related Topics:

    297 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Mitsubishi Experts

    yadayada
    yadayada

    Level 3 Expert

    76649 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8518 Answers

    Are you a Mitsubishi Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...