Question about 2003 Subaru Legacy

1 Answer

2003 subaru legacy the air conditioner does not emit cool air, is there a test to tell where the leak is?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 507 Answers

Look to see if the front of the compressor under hood is working when you switch it on and off,if it is you need to get the system leak tested,not really able to do at home though,it may be the compressor isnt working through a fuse or switch fault

Posted on Oct 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Antifreeze leaking in my 2003 subaru outback


You must have a shop run a cooling system pressure test with a special tool to determine the origin of the leak. It is likely the problem is the water pump

Jun 08, 2012 | 2002 Subaru Legacy

1 Answer

Engine won't start after hot but will after cools some


ENGINE FLOODING REPLACE AIR FILTER AND CLEAN FUEL INJECTORS DIRTY LEAKING FUEL INJECTORS WILL LEAK CAUSE ENGINE TO FLOOD OUT.

Oct 30, 2011 | 1996 Subaru Legacy

2 Answers

1990 subaru legacy- overheats, I"ve


Most likely you put the thesmostat in upsid down. Good luck

Aug 17, 2011 | 1990 Subaru Legacy

1 Answer

How to change water and timing belt on my 2005 subaru legacy gt turbo, pump is leak or stains below the centre of the eng. near and alen key eng, plug?


Unless you have really high milage on this vehicle the pump is not likely to go. Pump on front of engine and if it leaked would run down front and sprinkle towards center. However a weak heater hose or cooling hose clamp could give you the same results.
Before you spens a fortune ( cause this job is basically a timing belt job with a water pump, and eng seals ) Have the vehicles cooling system pressure tested for leaks. The techn will know how to check pump if he thinks its bad.

Apr 29, 2010 | 2005 Subaru Legacy

1 Answer

2003 subaru legacy- loosing coolant and apparent overheating. How do I check for a blown head gasket or other related problem. No coolant leaks on the floor in garage. After trip to town,20 miles total,...


check oil colour(milky indicates water)check radiator,can you smell fumes in there,get it tested with and exhaust gas annaliser,which picks up engine fumes in the radiator if you cant tell for sure,it does sound like you have a head gasket problem,you would need to do both heads not 1

Sep 24, 2009 | 2003 Subaru Legacy

1 Answer

Subaru legacy gt twin turruns like it only running on 3 cylinders


nee to test fuel injectors and watch engine electronics thru a scanner? another thing you might check is the airintake rubber bellows goes from air cleaner to engine for cracks or leaks? if all that checks out run a compression test ?

Aug 27, 2009 | 1996 Subaru Legacy

2 Answers

1990 Subary Legacy engine miss at idle


If you are getting a CEL (Check Engine Light) then figure out the code. This is an OBD-I engine so you need to connect the appropriate test connector and count the blinking lights. (Google Subaru OBD-1 codes).
Now as for your problem. Most common cause is the MAF (mass air flow sensor). The square box on the air intake. Try tapping it with a screw driver, the connect inside is joined only with solder and years of stress can crack the solder joint. If your engine stalls whenever you tap it, get a new one or rip off the cover and resolder the connect. Also check the IAC (Idle Air Control solenoid).

Aug 17, 2009 | 1990 Subaru Legacy

2 Answers

What is required in the service of a 3.0l subaru liberty at 100000kms?


your owners manual will tell you exactly. usually all filters should be changed (oil, air, auto transmission if equipped, fuel, cabin air etc) as well as spark plugs and wires, distributor cap and rotor if equipped, check the belts and hoses as well as the charging system. All fluid levels should be checked and topped off. Check your tire p.s.i. as well.

Mar 20, 2009 | 2004 Subaru Legacy

2 Answers

1990 subaru legacy


Both head gaskets have to be replaced and the heads need to be resurfaced, be sure you go thru the torque specs and sequence correctly, it is a strange process, but has to be done. subaru puts out a product called cooling system conditioner, it's advised to install this.

Sep 21, 2008 | 1990 Subaru Legacy

Not finding what you are looking for?
2003 Subaru Legacy Logo

Related Topics:

281 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...