Question about Hyundai Motor 1996 Elantra

1 Answer

When drivin slow it stalls when in trvellin it jerks changed the TBS sensor no change

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,280 Answers

Did the 'Check Engine' Light come ON? Whenever the 'CHECK ENGINE' light comes on, the ECU (Engine Control Unit) sets a Diagnostic Trouble Code (DTC). These codes identify the particular engine management system which caused the light to come on.
You'll need to use/find an OBDII (On-Board Diagnostic) Scanner to retrieve any code which have been stored in the ECU computer. Afterward, we might be able to help you DIAGNOSE and perhaps eventually fix the problem.

Posted on Oct 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Stalling and skipping rav 4


going to ask a scary question, no insult intended. have you checked the OIL when was it last changed. Air filter fuel injected system uses air filter was it changed last... fuel filter, not sure how many it has, may want to have that checked. spark plugs have them checked look at them, they maybe fowled. so here is a link that address the issue.....

http://alvinalexander.com/news/toyota-rav4-throttle-lag-hesitation-stalls-acceleration-2006

air flow mass sensor is flowed up dirt gets in and causes it to respond very slow... good luck..........

Oct 03, 2014 | Cars & Trucks

1 Answer

Knock sensors location


The knock sensor is located under the intake manifold. Not an easy job to change without some experience.

Aug 04, 2014 | 2000 Mercury Villager

2 Answers

How do i change transmission speed sensor?


It is located in the tailshaft housing of the transmission. You simply unbolt the retainer, un-plug the wires, and pop out the old sensor. Stick the new one in, bolt down the retainer, and plug in the new one.

Aug 02, 2014 | 2000 Ford Crown Victoria

1 Answer

My 2006 kia optima stalls and jerks when i drive it, i have changed the crank shaft sensor and oil valves, now they say it the pcm, what should i do or check on the car


PCM? did they even check coil voltage? You are a coil on plug the coil plug may have shorted to ground there are times the valve cover enters the coil in the valve cover and oil soaks the boot causing stalls and jerks, I never heard a PMC stall and **** a car, you would be the first

May 07, 2011 | 2006 Kia Sedona

1 Answer

Stalling and Jerking


I would check the fuel pressure and replace the fuel filter if it hasn't been replaced for awhile. The last 2 fuel filters I changed, the gas coming out of it looked like black ink.

May 24, 2010 | 2006 Kia Sedona

1 Answer

Car wants to stall changed injecter,egr valve iac


hi
check the all vacuum pipes is their any leaks.

Feb 21, 2010 | 1994 Saturn Sl

1 Answer

2002 Honda Accord - slow engine start and jerking


Most likely a dirty idle speed control system follow the guidelines below to clean it.

Throttle Body Cleaning on vehicles without electronic throttle control (most 2003 and down)

You can in most cases repair this slow speed stall or unstable idle by cleaning the engine throttle valve and the idle speed control valve using a product called CRC Spray Throttle valve cleaner. Spray the cleaner into the air intake of the engine with the hose removed from the throttle body, the engine will try to stall so hold up the idle speed manually. Once you have used up about 1/2 can of the cleaner stall the engine out while spraying and turn the key off, disconnect the negative battery cable for 5 minutes and then reconnect and drive the car for a about 25 miles of varied driving modes. If this doesn't cure the problem you may need the fuel injectors professionally cleaned by the dealer service dept.

Jul 11, 2017 | 2002 Honda Accord

Not finding what you are looking for?
Hyundai Motor 1996 Elantra Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...