Question about 2004 Chrysler PT Cruiser

Open Question

Car won't turn over and fuel pump not coming on

Replaced battery. Now PT cruiser wont turn over. I crossed the starter and engine turned over but won't run. red light in gage cluster on. I'm thinking its a factory anti-theft. I didn't get any key pads when I bought the car. Looking for a procedure to reset it w/out the key pad.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: 03 pt cruiser

Go to this web site. It will tell you what the code is.
http://www.ptcruizer.com/computer-codes.html

Posted on Oct 06, 2008

  • 512 Answers

SOURCE: 01 PT Cruiser window won't go up Can hear motor

sounds like he broke the regulator and it will need replaced

Posted on Jan 05, 2009

vortash
  • 431 Answers

SOURCE: a boiling sound comes from where I put my anti freeze

Hi I am Vortash the first thing you should check is the fluid level ( water ) in the radiator bottle .. and the oil to see if there is any water in it if you have a heat problem the head gasket can leak allowing water to mix with the oil .. this causes the oil to turn creamy white and reduces it's protection to the engine .
The best thing for you to do is have the vehicle checked over now as if the head cooks you could be looking at a couple of thousand dollars for repair in this country The UK it would cost about a thousand pounds to have a head skimmed and the gaskets replaced due to overheating and at todays currency exchange thats a lot of dollars ..Have a compression test done on the cylinders this will tell you if you have a gasket problem , The readings per cylinder should be between 130 to 150 per cylinder any lower and you have a problem .. regards Vortash

Posted on Jul 13, 2009

  • 5 Answers

SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...

GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP

Posted on May 26, 2010

  • 510 Answers

SOURCE: My pt cruiser won't start... Not because of the

Programming
When
System malfunction. Key added or replaced.
How
NOTE: Two programmed keys necessary. Complete each step within 15 seconds. NOTE: Some models - replacement key can only be programmed using diagnostic equipment.
Obtain all keys to be programmed. Using first programmed key, proceed as follows: Switch ignition ON and OFF within 15 seconds. Using second programmed key, proceed as follows: Switch ignition ON and OFF within 15 seconds. Within 10 seconds: Immobilizer LED flashes. Programming mode activated (acoustic signal will be heard). Proceed as follows: Within 50 seconds: Insert first key to be programmed into ignition switch. Switch ignition ON and OFF. Within 10 seconds: Single acoustic signal will be heard and immobilizer LED stops flashing and illuminates for 3 seconds to indicate correct programming. Repeat complete procedure to program remaining keys. Keys can also be programmed using diagnostic equipment.

Posted on Jun 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Pt cruiser wont start. checked battery, starter , releighs and ignition, and they seem fine. no codes come up when turning the key 3 times


To do self diag on a pt u need to start with ignition off. Hold trip button in for the odometer keeping trip button held down turn ignition key to run then release trip. This will also run a self test on instrument cluster. Codes will be displayed in the odometer at the end of test

Nov 01, 2016 | Chrysler PT Cruiser Cars & Trucks

1 Answer

2006 pt cruiser. It ran, stood for around 2month and won't crank up. I hear the fuel pump, the starter will not move, I replaced the starter and still no crank or move on the starter.


Can you hear a relay clicking when you turn the key over to "Start"? if not then a faulty relay could be the reason the starter motor is not cranking over. Is the starter solenoid "clicking in" but the engine not turning over? if so , can you turn the engine over by hand?

Oct 15, 2016 | 2006 Chrysler PT Cruiser

1 Answer

2003 pt cruiser, ran fine, went in for clutch replacement, mechanic called said clutch work completed, car wont start, claims the engine would turn over, but would not start, turns over fast like no...


Has ALL the wiring been put back ? sounds like he missed a few wires....check high amp fuses too (in case starter fuses blown due to incorrect reassembly).... one more thing.... any fuel in there ?

Apr 07, 2014 | 2003 Chrysler PT Cruiser

1 Answer

Everything in the car comes on but the engine won't crank up.


ON THE PT CRUISER, IF IT WILL TURN OVER CHECK YOUR FUSES UNDER HOOD AND RELAYS, STARTER,IGNITION SWITCH,AND FUEL PUMP PSI.,IF IT TURNS OVER TAKE IT TO TUNE A CAR.THEY ARE CHEAPER THAN THE DEALERS BUT THEY ARE GOOD.

Apr 23, 2013 | Cars & Trucks

1 Answer

My 2002 PT Cruiser won't start and I have changed all the spark plugs and the wires; I have checked the starter; I have checked and changed the fuel filter; I have checked the fuel lines and all o


check fuel pressure,if not 30psi or more then remove fuel filter and turn ignition on and fuel should come out with a little pressure,if not fuel pump is bad.

Sep 26, 2012 | 2002 Chrysler PT Cruiser

1 Answer

2005 pt cruiser won't start won't crank, everything works


When you turn the key on the ASD relay should turn on the fuel pump and power the injector, Do this lets cheat the system go to the ASD rely open the cover expose the inside have some one turn the key on does the ASD make contact? If not turn the key on collpase the ASD so it make contact do you hear the fuel pump come on? Now try this just as how you iopen the ASD do the same to the starter relay. Put the car in gear e brake on someone in the vehicle in case the car start and you are in front of it and it runs you over so at least they step on the brakes. Key on ASD exposed as your collapse the starter relay does the ASD relay turn on? Here why if you can control all the relay from under the hood you will need a ignition switch (the eletrical part)

Feb 22, 2012 | 2005 Chrysler PT Cruiser

1 Answer

My 2001 chrysler pt cruiser stalled out on me in the middle of the road, I was able to start it again but it died on me again a day later going to the shop. We decided my alternator was bad and I have a...


OK, the starter turns the engine over, and you can hear (?) the fuel pump. Check
* is there any spark? Use a timing light to check. If no spark, then the spark generation system (coil(s), igniter or other) is not working.

If there is spark, then pull the timing belt covers and check that you have not slipped a few teeth. If the PT has an interference engine (as I suspect), you may have bent some valves.

If the timing belt is OK, do a compression test.

When you turn on the ignition, does the Check Engine light flash then turn off? Could be a failing / failed ECU.

SD

Sep 16, 2011 | 2001 Chrysler PT Cruiser

1 Answer

I have a 2002 pt cruiser touring. I was driving and the oil light came on and then the car slowed down and died on me. It won't start and it sunds like it wonts to but it won't and the oil light...


Don't try start the engine when the oil light turn on, it would harm your piston, camshaft and crankshaft
It should be the oil pump has broken and need to replace, tow your car to the nearest service center

Jun 28, 2011 | 2002 Chrysler PT Cruiser

1 Answer

My 2003 pt cruiser wont start sometimes if i start it drive for a 1/2 hour then shut it off come back in 5 to 10 min it will not start but it will turn over. I will wait then shift into neutral and back to...


Is the check engine light on? Try spraying carb. cleaner in FI. and start. If it starts and runs until fluid is dry, might be fuel pump. If engine light on and has been for awhile, could be cat. converter stopped up and engine can't breathe so it shuts it off.

Jun 05, 2017 | 2003 Chrysler PT Cruiser

Not finding what you are looking for?
2004 Chrysler PT Cruiser Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...