Question about 1994 Chevrolet S-10 Blazer
Located on the intake manifold just follow the upper radiator hose to the engine should be 2 bolts holding the thermostat housing down.
Posted on Oct 05, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
follow the upper radiator hose to the engine, under the nipple that the hose attaches to on the engine is the thermostat, 2 bolts and maybe a bracket VERY EASY TO DO.
Posted on Feb 10, 2009
SOURCE: spark plugs
Your going to need a spark plug socket with a swivel, extension, and a spark plug wire pliers. You can access the spark plugs through the wheel well. you can from the top but that takes too long and you can't get to all of them from there. You can raise the front end just enough to give you some room in the wheel well with out removing the front wheels. To get to the spark plugs, move the wheel well splash guard up and out of the way so you can access the spark plugs on the side of the engine. One the passenger side is the easy one to work out and should take you under 20 min to do all three, change them one at a time so you don't mix the spark plug wires. On the drivers side is work on the #1plug (towards the front) and #5 (towards the fire wall) first and do #3 plug last. Spark plug #3 is behind the shock tower mount, you need to loosen it first with the socket, then remove the socket and remove and install the plugs by had. It should take you almost 10 min just to do that plug and a cramped hand. When replacing the spark plugs, use anti seize so it's easier to remove the plugs next time and use platinum plugs so your good to go for 100,000 miles unless you have a plug failure due to running too lean or rich. Bring the truck down and place the ignition to the run position for 30 seconds and turn off for 10 seconds and then start and let idle for 1 min then go for a test drive to reset all the engine management sensors. Good luck and hope this helps. Keep me posted, be glad to help.
Posted on Jun 20, 2009
Tips for a great answer:
Apr 08, 2013 | 1994 Chevrolet S-10 Blazer
Dec 08, 2012 | 1994 Chevrolet S-10 Blazer
Dec 22, 2011 | 2004 Chevrolet Blazer
Jun 19, 2011 | 1994 Chevrolet S-10 Blazer
Sep 23, 2010 | 1994 Chevrolet S-10 Blazer
Apr 27, 2010 | 1994 Chevrolet S-10 Blazer
Feb 28, 2009 | 1994 Chevrolet S-10 Blazer
126 people viewed this question
Usually answered in minutes!