Question about 1997 Mercury Sable

Open Question

1997 mercury sable service engine light staying on running warm

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 60 Answers

SOURCE: 2003 mercury mountaineer

get it read at autozone for free probably related

Posted on Aug 13, 2008

  • 958 Answers

SOURCE: Where is the starter located on a 1993 mercury sable engine

trace the big cable that came from the positive terminal of your battery. at it's end is the starter.

or if it passes trough a big relay, then there is another big cable from that relay that would go down to the side of the engine, either left or right, that would be the starter.

tnx 4 using fixya,

drcool

Posted on Oct 04, 2008

  • 14 Answers

SOURCE: 2003 Mercury Sable gas cap light stays on!

make sure that the gas cap have a rubber gasket in it if it has accidentaly dropped off while you removed to fill the tnk it will not seal properly and create a vacum leak causing the ecm to turn on the light.

or did you have an accident or did you run over any thing that could have damaged the vapor canister at the bottom of the vehicle and if this is the case you will see the light on because a damaged canister can cause a vacum leak

Posted on Nov 11, 2008

emissionwiz
  • 75822 Answers

SOURCE: 1997 Mercury Sable Misfire

they may have done a relative compression test which is done electronically by measuring the RPM drop of each cylinder when the test is running, but not sure anyone but the dealer can do this test. This low compression you mentioned is not good, suggest u run the test yourself, the compression test guage kits are cheap u can buy them on line for about $25 US, also tank added chemicals don't do anything in the short term and noting if the injector is badly clogged, do u understand what I mean about a high pressure factory cleaning? it is quite a different animal.

Posted on Jan 21, 2009

greg_margo
  • 1959 Answers

SOURCE: mercury sable 2001 duratec engine DOHC I get check engine light and diagnostic code PO401". Any suggestions?

Barring any vacuum leaks, P0401 is indicative of a bad EGR valve. Hope this answers your question. Best of luck.
Greg

Posted on May 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Xtra long warm-up time 1997 mercury sable gs


Could be a weak thermostat thats not closing when the engine is cold.

Jan 31, 2014 | 1997 Mercury Sable

1 Answer

1997 Mercury Sable coolant cap pops off when engine is warm


Is the filler neck worn or you may need a new cap

Jan 14, 2013 | 1997 Mercury Sable

1 Answer

My 97 mercury sable 3.0 is very hard to start once started runs really rough for a second then smooths out


My first guess would be a dirty throttle body or a faulty idle air control valve.
Also one of the injectors could be leaking fuel into the cylinder when you stop the engine.
Is the check engine light on when the engine is running ?

Jul 09, 2012 | 1997 Mercury Sable

3 Answers

2001 MERCURY SABLE ENGINE LIGHT ON. WAS COLD


tuen ignition key from off to "ON" 4o times to rest light. If it comes on again, go to AUtozone for free scan and get fault code

Dec 22, 2009 | 2001 Mercury Sable

1 Answer

97 sable daytime running lights


This could be caused by a relay that is staying closed when the key is turned off. The contacts fry over time and stick closed. Replacement is usually easy.

Mar 21, 2009 | 1997 Mercury Sable

1 Answer

01 mercury sable traction control & low coolant lights stay on.


check for something stuck in the wheels and as for the coolant light get the car running and up to warm temp and start adding coolant to the reserviour bottle until it is up to hot level because there maybe a bubble in the line but also if might be a bad switch in the reservior bottle itself

Jan 11, 2009 | 2001 Mercury Sable

Not finding what you are looking for?
1997 Mercury Sable Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...