Question about 1991 Toyota Camry

1 Answer

I am trying to locate the resistor for the blower motor on a 91 camry i have stood on my head under the dash and cant locate it, i have the glove box out so i can see pretty good. any help would be greatly appreciated.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 254 Answers

You're on the right track. The blower resisitor is located underneath the box, right next to the blower motor. This photo should better help you find it, provided by Toyota Nation: I hope this helps! :)


i am trying to locate the resistor for the blower - 27399d4.jpg

Posted on Oct 05, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Blower motor resistor located on 2004 buick century


Does your Buick have manual or automatic cilmate control ? Could have a blower motor control module or processor ! It , if it had a resistor it would be near the blower motor . It's located under the dash below the glove box . To get at it you need to remove the panel under the dash . Video on youtube showing how to test blower motor electrical circuit .

Dec 28, 2016 | Buick Cars & Trucks

1 Answer

My heater blowers dnt work and i need to knw where i can locate the resister blocks for my heater blowers so i can ghange them


Its located under dash,or near glove box.

The dash panel lower side has to be out.

HEATER BLOWER MOTOR


Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.


It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.


=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

Nov 28, 2012 | Cars & Trucks

2 Answers

I cant find the blower motor


If you mean the climate control blower motor, it's usually under the dash on the passenger side on Hondas.

1990-93 Accord
  1. Disconnect the negative battery cable. If so equipped, disable the Supplemental Restraint System (SRS).
  2. Remove the glove box.
  3. Remove the glove box frame (lower support) Fig. 2: Remove the glove box and frame 86806004.gif

  4. If not equipped with air conditioning:
    1. Remove the three screws and remove the heater duct.
    2. Remove the blower mounting nuts. Unplug the wiring from the blower motor, resistor and recirculation control motor, then remove the blower assembly.
  5. If equipped with air conditioning:
    1. Lift the carpet in the passenger compartment. Remove the side cover (kick panel).
    2. Remove the control unit bracket nuts; unplug the five connectors and remove the control unit bracket.
    3. Remove the retaining band, then remove the blower lower covers. Do not break the tabs on the lower covers.
    4. Remove the retaining nuts and remove the blower assembly. Fig. 3: Air conditioned models require the removal of the control unit. Handle it carefully 86806005.gif
      Fig. 4: Remove the lower covers from the blower unit 86806006.gif
      To install:
  6. Install the blower unit and tighten the retaining nuts.
  7. On air conditioned vehicles:
    1. Install the lower covers and the retaining band.
    2. Install the control unit bracket and carefully engage the wiring connectors to their proper location.
    3. Install the kick panel and reposition the carpet.
  8. Connect the wiring to the blower assembly. For non-air conditioned vehicles, install the air duct and tighten the screws.
  9. Install the glove box frame and install the glove box. Note that some of trim on the frame is held with 2-sided tape; replace the tape when reassembling as necessary.
  10. If applicable, enable the SRS.
  11. Connect the negative battery cable.
1988-91 Prelude
  1. Disconnect the negative battery cable.
  2. Remove the glove box and frame (lower support).
  3. Remove the 4 screws and remove the heater duct. Fig. 5: The glove box and frame are secured by several small screws 86806007.gif

  4. Remove the 3 mounting bolts.
  5. Unplug the wiring connectors from the blower motor, resistor and recirculation controller. Remove the blower motor assembly.
  6. Reinstall in reverse order. Make certain the blower mating surfaces are tightly sealed.

Jan 08, 2011 | 1992 Honda Accord

1 Answer

How to replace blower motor resistor


The blower motor resistor is located behind the glove compartment adjacent to the blower motor.There is a access door under the dash right below the glove box, There are few screws that you will have to remove to take the door out. The blower motor resistor, is to the left of the blower motor in the air conditioning case.The blower motor resistor is held by screws,remove the screws to take the resistor out. Keep updated with any further queries.Thanks.

Oct 12, 2010 | 1998 Chrysler Town & Country

3 Answers

Heater works only on high speed on a 1999 toyota camry CE 4 cyl. Please advise what may be the problem.


I just fixed this problem on my 99 Camry. The fan only worked on high. It was the resistor. Bought it for $29.99. It is under the dash on the passenger side. Just above where the passengers left foot would be. You DO NOT need to take out the glove box. The resistor is located just above where the carpet ends. It is held in place by a plug with about 6 wires. It has two phillips head screws. Get a short elbowed phillips head and switch it out.

Jan 24, 2010 | 1998 Toyota Camry

1 Answer

2001 Dodge Grand Caravan heater blower motor not working at all...worker off and on during a cold spell....now not at all ....dealer suggested replacing blower motor and resister...cost $1000....due to the...


The Blower Motor Resistor is located behind the glove box on the dash. Remove the whole glove box to access. The Resistor is mounted against/sort of into the fire wall.
1. Disconnect the negative side of battery.
2. Disconnected the Electrical Connection to the Resistor.
3. Remove the bolts/screws. I believe they have 8mm heads, there should be 2 of them.
4. Replace with new one/Replug electrical connection.
5. Reconnect the negative side last.
6. Test System before putting the glove box back in!
The Blower Motor is easy (compared to $1000) to remove and replace.

Jan 01, 2010 | 2001 Dodge Grand Caravan

2 Answers

Where is fan blower motor located on 99 toyota camry


The blower motor for the inside of the car is located on the passenger side of the dash under the glove box. Should have a lower panel under the dash to remove. Remove the panel and you will see the blower motor mounted under it.

Sep 14, 2009 | 1999 Toyota Camry

2 Answers

Exact same problem, AC Blower motor only runs on setting 3 or 4


under the dash on the right hand side behind blower moter

Jul 14, 2009 | 2003 Chevrolet Tahoe

2 Answers

Where is the heater resistor switch for a 1995 gmc sierra


Its located behind glove box on top of heater just to the left of blower motor. If you take off the glove box door ( glove box and door one unit) you will see it on top of heater box.

Jun 20, 2009 | GMC Sierra 1500 Cars & Trucks

2 Answers

1998 Pontiac Transport Blower resistor


on the blower motor under dash passanger side good luck pierre

Jul 13, 2008 | 2003 Pontiac Montana

Not finding what you are looking for?
1991 Toyota Camry Logo

Related Topics:

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8825 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...