Question about 2004 Nissan Armada

Open Question

When car goes into drive position the car turns off

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause an 04 Tahoe LT to die and not restart while driving down road won't turn over either


I would double check cables at battery and make sure all are tight. if that goes nowhere then try pulling on some of the wiring harnesses around engine to see if you can pinpoint problem... sounds more like a wiring issue than inputs to the computer.

Sep 29, 2014 | 2004 Chevrolet Tahoe

1 Answer

Could po320 be drive shaft speed sensor


code p 0320 refers to crankshaft position (CKP) sensor /engine speed (RPM) sensor---circuit malfunction====causes --wiring--CKP/RPM sensor ---ECM check the wiring to the crank position sensor
replace the crankshaft position sensor

Apr 16, 2017 | 2004 Jeep Grand Cherokee

1 Answer

2000 ford explorer 5r55E stuck in second gear and all gear positions


It sounds like the linkages have let go. If this is the case, then drive it to a repairer straight away. If you turn the vehicle off you might not get it started again.

Oct 10, 2012 | 2000 Ford Explorer

1 Answer

Emission light on. but can drive. I already drive it over 1000km. why the light on??


Hello and welcome to FixYa!
If that's the case then you may need to replace the O2 sensor. If the sensor is new and the light is still on, try to remove the positive battery connector and let it sit for at least 5mins. After 5mins. reconnect the positive battery connector and turn on the engine. Observe how it goes, this can reset the codes on your car.
Hope this helps and thank you for using FixYa! Have a good one!

May 05, 2011 | Renault Fuego Cars & Trucks

1 Answer

2003 GMC Sierra 5.3L (has 2004 engine) Drive by wire. Reduced engine power (Limp Mode). Following error codes - P1516, P2135, P0120. Checked all connections at throttle body(Wiggle tested the individual...


CODE PO120 - TP SENSOR 1 SIGNAL RANGE PERFORMANCE. CODE P1516 - TAC MODULE THROTTLE ACTUATOR POSITION PERFORMANCE. CODE P2135 - THROTTLE POSITION SENSOR 1 - 2 CORRELATION ERROR. THIS IS A DEALERSHIP FIX YOU HAVE PROBLEMS OR FAULTS IN THE THROTTLE POSITION SENSOR.

Oct 24, 2010 | 2004 GMC Sierra 1500 Crew Cab

1 Answer

Maintenance light flashing


h) Engine Oil Replacement Reminder
Light (for vehicles sold in U.S.A.)
This light reminds you when to replace
the engine oil.
This light will come on when the ignition
key is turned to “ON” and will go off after
about a few seconds.
When you drive for about 8000 km (5000
miles) after the engine oil replacement,
this light illuminates for about 3 seconds
and then flashes for about 12 seconds
with the ignition key turned to “ON” position.
If you continue driving without the
engine oil replacement, and if the driving
range exceeds 12000 km (7500 miles), the
light will come on after the ignition key is
turned to “ON” position. The light will remain
on thereafter.
If the light is flashing, we recommend that
you replace the engine oil at an early
opportunity depending on the driving and
road condition. If the light comes on, replace
it as soon as possible.
You need to reset the light after the engine
oil replacement. Reset the light by
following the procedure below:
1. Turn the ignition key to the “OFF” position
with the odometer reading shown.
(For details, see “Odometer and two
trip meters” on page 136 in this Section.)
2. Turn the ignition key to the “ON” position
while holding down the trip meter
reset button.
Hold down the button until the light goes
off. Before the light goes off, it illuminates
for 3 seconds, flashes for 2 seconds and
illuminates for 1 second.
If the system fails to reset, the light will
remain flashing.


I copied this from page 143 of the owners manual for the 2004 4Runner

Jun 04, 2009 | 2004 Toyota 4Runner

1 Answer

'02 Montero 4wd problem


position switch stock remove and check operation by pressing contact in and out set gear leaver in 2h position and reinstall

Jan 05, 2009 | 1995 Mitsubishi Montero

Not finding what you are looking for?
2004 Nissan Armada Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...