Question about 2004 Chrysler Voyager

Open Question

2005 Caravan Ft. heater don't work any time checked fuse and relay OK . Where do you access hester motor? haven't been able to check current at motor..

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 51 Answers

SOURCE: Heater Control Switch Only Works on High

I would Replace the blower Resister aka temperature heater fan resister.

Posted on Oct 08, 2008

dgjtex
  • 405 Answers

SOURCE: Front blower motor doesn't work, rear does

yes, all blower motors have them to control their speed, High, medium, low.. etc. I earn nothing by helping you, but my rating, a fixya rating and I will walk you through this

Posted on Dec 20, 2008

  • 1596 Answers

SOURCE: 2005 Town Country front blower motor inop fuse/relay ok

Break Down And Replace The Blower Motor


REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIR-BAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN AN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY OR DEATH OR DEATH.

NOTE: The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed from the vehicle without having to remove the HVAC housing.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the passenger side cowl trim panel.
  3. Position the carpet to access the front upper screw that secures the air inlet housing.
  4. Remove the recirculation door actuator.
  5. Disconnect the blower motor wire lead connector from the blower motor resistor or power module, depending on application.
    1. Remove the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing.
    2. Remove the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and remove the lower HVAC housing.
    3. Push the rubber grommet through the opening in the lower air inlet housing.
    4. Route the blower motor wire lead through the opening in the lower air inlet housing and remove the lower air inlet housing from the vehicle.
    5. Position the recirculation-air door as necessary to access and remove the three screws that secure the blower motor to the lower half of the HVAC housing.
    6. Gently flex the recirculation air door downward to gain access to remove the blower motor from the HVAC housing. NOTE: To aid in installation, note the position of the blower motor mounting tabs prior to removal
      1. Remove the blower motor from the HVAC housing by rotating and tilting the blower motor as necessary.
      INSTALLATION

      1. Gently flex the recirculation-air door downward to gain access to install the blower motor into the HVAC housing.
      2. Position the blower motor to the HVAC housing and tilt and rotate the blower motor as necessary to install it into the HVAC housing.
      3. Align the blower motor mounting tabs to the locations noted during removal and install the three screws that secure the blower motor to the HVAC housing. Tighten the screws to 2 N·m (17 in. lbs.).
      4. Route the blower motor wire lead through the opening in the lower air inlet housing and seat the rubber grommet.
      5. Position the recirculation door pivot shaft into the lower air inlet housing and install the inlet housing.
      6. Install the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and the lower HVAC housing. Tighten the screws to 2 N·m (17 in. lbs.).
      7. Install the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing. Tighten the screw to 2 N·m (17 in. lbs.).
      8. Connect the blower motor wire lead connector to the blower motor resistor or power module, depending on application.
      9. Install the recirculation door actuator.
      10. Reposition the carpet.
      11. Install the passenger side cowl trim panel.
      12. Reconnect the negative battery cable.
      13. Perform the heater-A/C control calibration procedure.

Posted on Feb 07, 2009

  • 490 Answers

SOURCE: 2005 sebring convertible- horn goes off by itself for 30 seconds

FIrst off the horn's ground works through the steering wheel,so the wire is bare or the end is broken and grounding in a place where it should not. You will have to check the wires for the horn from the fuse box up to the wheel.
your power feed to the headlights and the door locks has an open ( the power is not connected somewhere ) Perform a wiggle test turn on the headlights and lift the hood,find the power distribution box and begin to wiggle the wire harness.Sometimes the chrysler fuse box under the hood get loose inside the power distribution box,it will have to be broken down all the way to the heavy wires comming out of hte box,you can tighten these connections your self.

Posted on Aug 08, 2009

  • 100 Answers

SOURCE: 2001 Town & Country lxi. Front blower

Ummm if the blower motor is bad it's a ***** to replace, I'd spring for a dealership repair to replace the motor
try this (But I doubt it) look under the hood on the firewall near the far right side, if you see the back of the blower motor, whack it with a hammer, this may work and it's tmporary at best, if you're very lucky the blower can be unbolted and removed on he engine side, but that's rare
Sorry

Posted on Aug 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Front blower stopped working, where is the resister?


A resister would only cause it not to work on 1or2 speeds, Not all of them, The Blower motor is shot (Probally) They don,t last for ever, There is allso a relay for them in the fuse block in the engine compartment, That might be defective,

Dec 01, 2012 | 2005 Dodge Grand Caravan

1 Answer

The front a/c blower does not work, all fuses are good. please help


J, I am sending you some info to read but it appears that the most likely cause is the blower motor relay. Give the following notes a read and if you need some more help give me a buzz... Best of Luck..

1996 Chrysler Town & Country 3.3L, Vin R 1996 Dodge Grand Caravan ES 3.8L, Vin L 1996 Chrysler Town & Country LX 3.3L, Vin R 1996 Dodge Grand Caravan LE 3.8L, Vin L 1996 Dodge Caravan LE 3.8L, Vin L 1996 Dodge Grand Caravan SE 3.3L, GAS, Vin R, Eng Cfg V6 1996 Dodge Caravan Sport 3.3L 1996 Plymouth Grand Voyager SE 3.3L, GAS, Vin R, Eng Cfg V6 1996 Dodge Grand Caravan ES 3.3L, Vin R 1996 Plymouth Voyager Rallye 3.3L Customer Concern: Front blower does not work; no power to it. Fuse is OK. Tests/Procedures: 1. At the blower motor, there is a Dark Blue wire. This wire should have battery voltage whenever the key is in the "on" position. Power for the blower motor comes from the blower relay.

2. Access the front blower relay, it is located on the driver's side under the dash, near the junction block. There will be four wires going to it. The Dark Green wire should have battery voltage all the time. The Dark Blue wire is going to the motor. The Black/Orange wire should have battery voltage with the key in the "on" position. The Black wire should be grounded at all times. On this circuit, the relay is energized whenever the key is in the "on" position. Potential Causes: Front Blower Relay
Front Blower Relay Wiring
Heater Ventilation Air Conditioner (HVAC) Control Head
Tech Tips: The front blower relay is located under the dash, on the driver's side. It may be necessary to remove the junction block (fuse and relay box) in order to see it. Diagnostic Codes: None

Aug 28, 2011 | 1996 Chrysler Town & Country

1 Answer

Blower not working on heat or ac 2005 dodge caravan sxt not fuse or relay what else ?


Thanks for choosing FixYa and welcome. If you are positive that is not the fuse or relay that is the issue, it is either a bad wire/connection to the blower or the blower is bad. I would use a voltage meter to check the current going to the blower. If it is getting power, change the blower motor itself.

Aug 21, 2011 | Dodge Caravan Cars & Trucks

2 Answers

My 2005 Dodge Caravan front heater blower does not work. What are you suggestions?


check the fuse first with a test light, then, check the voltage to the 2 wires for the blower motor also with ignition on without running the engine. let me know how that turns out for the rest of the instructions

Dec 29, 2010 | 2000 Dodge Caravan

2 Answers

2005 Dodge CaravFront defroster fan wont blow (rear is ok), fuses


check the switch most used part usualy wears out if you know there is no power at the fan motor wires yes the twisted wires, then i would look at switch next.

Jan 16, 2010 | 2005 Dodge Grand Caravan

2 Answers

2005 grand caravan; rear blower motor is working, but the front blower is not even though the lights on the swith are working. Is this the resistor?


Access the blower motor resistor board located behind the glove box. Take a jumper wire and ground each of the Dark Blue wires that have tracers on them one at a time. Caution: do not ground out the plain Dark Blue wire or a fuse will blow. As each wire (with the tracer) is grounded, the blower motor should run at a different speed. If it does not, the resistor board has failed.

Jan 06, 2010 | 2005 Dodge Grand Caravan

1 Answer

Heater in my 2005 dodge caravan is not working.


check the fuses and the blower motor relay,I believe the relay box is still under the hood in those vehicles and the under side of the cover should have a skematic of what the all are if not the owners manual will.

Jan 04, 2010 | 2005 Dodge Caravan

1 Answer

My ac and heat not working in 2005 Dodge Grand Caravan


There may be a fault in the control group in the dash--there is a resistor that controls motor speed as well as the speed switch.

Jul 17, 2009 | 2005 Dodge Grand Caravan

1 Answer

I have a 2005 dodge caravan. the blower for the heater quit working . I tested it and I am not getting power to fan control switch .


There is 3 things you can check: the fuse, the relay switch,and the resister block. If these are ok, check the wiring from the blower to the fuse block, to the control switch. good luck.

Jan 22, 2009 | 2003 Dodge Caravan

1 Answer

2005 dodge grand caravan


check the fan blower relay. this is the one powering up the blue wire going to the motor.

maybe it has a separate fuse. check from other locations. could be in the passenger kick panel.

tnx 4 using fixya,

drcool

Oct 19, 2008 | 2005 Dodge Caravan

Not finding what you are looking for?
2004 Chrysler Voyager Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...