Question about 1990 Nissan Pulsar

1 Answer

Car is shaking above 60kph. below this it is barely felt. can't drive higher than 80kph. It is a 1990 nissan pulsar. Seems to lessen when turning to the left. Worse going up hills and when slowing car down from around 60 to 70 kph.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Adjust the shake absorber.

Posted on Oct 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission slow to up shift


sounds like normal behavior

Apr 18, 2014 | 2001 Mazda Tribute

1 Answer

My 1990 nissan pulsar 1600 wont change into fourth sometimes when driving


could be bad throwout bearing or cluctch linkage needs to be adjusted.

Nov 12, 2009 | 1990 Nissan Pulsar

2 Answers

Nissan Pulsar 1992 is overheating when I travel at 100 kmh and air con is on. It seems to running fine at lower speeds. When we turned air con off the temp did still rise but at a slower rate. Took it to...


Check for collapsing radiator hose on suction side of waterpump when motor revs raised above idle.
Check collant resevoir pressure cap is serviceable,
Check coolant system is properly filled - carry out any bleed off procedure specified to clear any air locks.
Check condition of radiator core:-
1) for blockage of air flow to (bugs/grass etc),
2) and internal blockage to coolant flow,

Replace the thermostat, if all above ok.

Oct 07, 2009 | 1990 Nissan Pulsar

1 Answer

Correct grade of oil for 1996 nissan pulsar


Hi there! Nissan recommends 5w-30 for there vehicle. 10w40 will work in warmer climates as well. Thanks

Apr 08, 2009 | 1990 Nissan Pulsar

1 Answer

Nissan pulsar wont start


Replace the sparks plugs, if the car is failing on one cylinder it will be hard to start.
Check the air intake and the air filter, if air filter is dirty replaced, only to test the car try starting with intake open and no air filter, if it starts it is an air intake problem.
Check the fuel filter and check that fuel have pressure, if fuel has no pressure it is either a faulty pump or an obstructed pipe.

Common cause for car not starting is distribution, with distribution rotor you often have to replace distributor cap or coil.
If it is electronic distribution you have to scan distribution module.

If you have an anti theft system, this can also cause the car not to start, usually you unlock anti theft with car key.

If it is none of the above, it can be a car computer problem, the car computer module (ECU) can be scanned using a code reader at any good garage, in this case the mechanic will get error codes from car ECU and be able to troubleshoot further the problem.

Aug 28, 2008 | 1990 Nissan Pulsar

Not finding what you are looking for?

Open Questions:

See all 1990 Nissan Pulsar Questions

1990 Nissan Pulsar Logo

Related Topics:

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...