At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: 91 landcruiser 80 series gxl replacement drivers seat
You can get a replacement seat from a wrecking yard and would guess you would pay around $75.00 to $100.00 for the seat or you could go to a reupholster and have it redone like new for somewhere around $150 to $200.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The cost depends on the fault.
If the speedo is faulty, could be a complete board required. If there is a sender unit faulty on the output from the main drive shaft could depend on spare parts required and labour charge. Maybe there is a broken wire, maybe there is a blown fuse.
Sorry I do not know how long that piece of string that I can't see is.
sound like you have a bad ground our pwr or short in you wireing sounds like some ine pinched a wire in the door and caused a direct short to ground or your alternator regulator went bad the wrong way supplying youcar with over 14.4 v max 12v reg when you dbl voltage you cut amperage in half and that will fry all electronics and no fuse will blow there for frying B.C.M ,E.C.M P.C.M MULTIFUNCTION SWITCH WIPERS TURN SIGNALS HEAD LIGHTS TAIOL LIGHTS ECT
check that the ac clutch is connected up to get power to the clutch. Check the gas level as too much and not enough will not allow the compressor to work. You should have replaced the receiver drier as well as they block up. Did you vacuum down the system before you put the gas in. IF not then the TX valve may be blocking up from the water vapour that was in the lines when you put in the gas.. Suggest you visit an auto air conditioner shop to fix the problems.
Replace it. Most switches are mounted to plastic snap clips than can be removed with a simple Flathead screwdriver.A $5 plastic pry tool set is the best, but a butter knife or two works wonders sometimes.
replace front diff centre on 100 series landcruiser
spindle torque settings
×