Question about 2000 Chevrolet Venture

1 Answer

I have a 2000 chevy venture ....hole on the muffler but just replaced ...do i have to reset anythin g for the engie light to go off?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 104 Answers

You will have to get the ecm scanned to turn off check eng light-it may not be the muffler that causes light to come on

Posted on Oct 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to reset the fuel pump on chevy venture


No you need reset your self,turn the key until all dash light come on leaves the switch like that for 30 sec.an then go back and tried

Mar 29, 2014 | 2000 Chevrolet Venture

1 Answer

I have a 2000 Chevy Venture van and the heat when turned on blows cold. For a while it was still blowing out warm air thru the back vents but now it is all cold. The van wouldn't warm up at all e


needs the water system back flushing out, heater being cold is its blocked up some time a few back flushes and forward flushes with a hose pipe should free up the dirt inside, same with the engine and radiator. there are meany videos on you tube to help you understand how to back flush you engie. but do the radiator and engine and heater separate so the muck does not go back into the engine.

Aug 16, 2017 | 2003 Chevrolet Venture Passanger

1 Answer

How do you replace crankshaft sensors on a 2000 chevy venture


Why would you change a crank sensor

It failed a test?

How was it tested?

No parts get changed just for something to do

Dec 22, 2012 | 2000 Chevrolet Venture

1 Answer

How do reset the security system on a 2002 chevy venture van? and it will not start


Good morning, I am having a problem starting my 2000 chevy venture. I believe its the security system acting up, can anyone tell me how to reset the vechile's security system?

Jul 16, 2010 | 2000 Chevrolet Venture

1 Answer

How do i reset the change oil light on a 2000 chevy


On my 2007 Saturn Outlook the instructions are in the owners manual.I would go look for you but my wife is gone in it and I may never see it again!!! I am only joking,but the instructions are in there if you have it handy.If you dont have it I can check it later when she comes back from the grandkids basketball game!

Mar 20, 2010 | 2000 Chevrolet Venture

1 Answer

How do i reset change engine oil light on a 2000 chevy venture


1. With the ignition key in RUN but the engine off, fully push and release the accelerator pedal slowly three times within five seconds.

2. Turn the key to off.

IF the CHANGE ENGINE OIL light comes back on, the engine life monitor has not reset. Repeat the procedure.

I have noticed personally that I have press my accelerator 5 times. Each vehicle has it's own idiocyncracies

Sep 26, 2009 | 2000 Chevrolet Venture

1 Answer

Trying to reinstall belt tensoner on a 2000 chevy venture van with 3.4 engine has two bolt holes can not remember what goes where as far as bolt and doel pin


THERE SHOULD BE A HOLE WHERE THE DOWEL PIN GETS INSERTED. I BELIEVE THE PULLEY GOES ABOVE THE TENSIONER. HOPE THIS HELPS. GOOD LUCK. THANK YOU IN ADVANCE FOR AN HONEST RATING AND FOR USING FIX-YA. KEEP ME POSTED PLEASE

May 09, 2009 | 2000 Chevrolet Venture

2 Answers

Need to know my wheel base so i can buy a new muffler


get a tape measure, and have someone hold it and the very center of the front wheel.and measure to the rear wheel very center. thats your wheelbase.

Mar 15, 2009 | 2000 Chevrolet Venture

1 Answer

Tail lights on my 2000 chevy venture arent working. i replaced the multifuncion switch, but it didnt help. any advice on this could help. thanks


The circuit boards are a very common problem on these vans, moisture gets in them and creates a bad connection, check if you have power in the rear light socket and go from there, you often need to replace the circuit board in the rear light.

Feb 24, 2009 | 2000 Chevrolet Venture

2 Answers

Lights dimming and brightening on 2000 Chevy Venture


2000 chevy venture run good but my lights flickers and have to jump. After I jump the van and put my meeter on the battery its reading 14.volts at idle. I can drive around to store cut the van off come out it starts fine leave it overnite and it don't started.

Nov 21, 2008 | 1999 Chevrolet Venture

Not finding what you are looking for?
2000 Chevrolet Venture Logo

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...