Question about 1989 Ford Bronco II

1 Answer

My 89 ford bronco 2 doesn't want to turn over.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Master
  • 578 Answers

Battery terminal connection clean?
Starter selenoid clicking? - if not, wire from battery has a bad connection. If yes, starter has bad connection.
Try bypassing the starter relay (selenoid) with a jumper cable... does it turn over? If yes, replace the relay, if no, check the starter. A junkyard replacement should be a cheap fix.

Posted on Oct 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wireing ford 89 bronco 2 solenoi setup


I've had this problem. I replaced the battery cables and ends and solved my problem.

May 02, 2014 | 1989 Ford Bronco II

1 Answer

89 ford bronco 2 it i turn the key on and it starts then it just dies after 2 sec


I think this may , just may , be a coil failure , the oil insulation breaks down as the heat increases , whuch allows the system to work until the oil reaches it critical temperature
Check the coil !
its a guesolution ?

Aug 05, 2013 | 1989 Ford Bronco II

2 Answers

I have 89 bronco 2 my brake lights turn signals both work my tail lights don't work have check fuse n blubs what might be the problem


The turn signals and brake lights use the same circuit and filament in the bulbs. The tail lights are on the other circuit which comes from the headlight switch.
Do you have power on the tail light fuse ?

Feb 25, 2013 | 1987 Ford Bronco II

2 Answers

1989 Bronco: 89 ford bronco i put a new starter new battery new...


Check the battery cables for corrosion near the battery terminal end. Sometimes it builds up under the rubber insulation. I would check the ground wire that runs from the battery to the engine block.

May 16, 2010 | 1989 Ford Bronco

2 Answers

How do ichange out the ignition switch on a 1989 ford bronco II


turn ign to on position and the is a button on the bottom that you push and it will allow the ignition key cylinder to slide straight out. real simple. turn the new on in thon position and press the pin in on the side and slide it in the column

Apr 07, 2010 | 1989 Ford Bronco II

1 Answer

I have a 89 bronco 2 with a 2.9 engine. I have


Try replacing the Throttle Positioning Sensor
Have the codes checked
You may need to clean the Mass Air Flow Sensor
this is best done by a professional as it contains some very sensitive wires and they are easily broken
The MAF is very expensive to replace

Mar 29, 2010 | 1986 Ford Bronco II

1 Answer

Which 5 speed transmissions will work with an 89


all the early rangers up to the genII and maybe even more will work in you bronco....join the ranger station forums for a lot of insight on your bronco...

Mar 01, 2010 | 1989 Ford Bronco II

1 Answer

Bronco fuel pump 89 to 88


i dont think they will. you would be better off finding the right one versus trying to make something work and then you might have even more problems to deal with

Jan 05, 2009 | 1989 Ford Bronco

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

281 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...