Question about 2005 Chevrolet Avalanche
I have a 2005 chevy silverato. I need to remove the u-joint it does not have any bolts. how does it come off.
Posted on Aug 13, 2011
Go to link to watch a video of the job
Posted on Oct 04, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Apr 01, 2017 | 1999 Jaguar XJ
Jan 11, 2015 | Cars & Trucks
Aug 05, 2012 | 1995 Pontiac Firebird
Lift the rear end of the Explorer with a floor jack. Place jack stands underneath the rear axle, by the leaf spring perches and lower the Explorer onto the stands. Pull the floor jack out of the way. mark both ends of the shaft for reinstalation.
Crawl under the rear end and unbolt the universal joint retaining straps from the rear differential yoke.
Pull the drive shaft and universal joint away from the rear differential yoke by hand.
Remove the retaining rings that hold the universal joint into the drive shaft with needle-nose pliers.
Support the end of the drive shaft on a jack stand and place the socket extension against the universal joint cap in the drive shaft yoke. Tap the socket extension with the dead blow hammer until the universal joint cap comes out of the yoke.
Clean the sockets in the drive shaft yoke with the tip of a pocket screwdriver to remove any built up road dirt or other gunk.
Remove two of the caps from the opposite ends of the replacement universal joint. Be careful to keep the bearings in the caps.
Position the replacement universal joint in the drive shaft yoke and put the cap on the outside. Use the socket extension and dead blow hammer to tap the cap through the yoke far enough to expose the retaining ring groove. Put the retaining ring on that side with the needle-nose pliers. Repeat this for the other cap.
Move the drive shaft back up to the differential yoke, line up the new universal joint with the differential yoke and reinstall the universal joint retaining straps with the wrench. Lower the rear end off the jack stands with the floor jack.
Sep 22, 2010 | 1996 Ford Explorer
Apr 22, 2010 | 2004 Dodge Ram 2500
Oct 12, 2009 | 1995 Ford F150 Styleside Regular Cab
May 08, 2009 | 1995 GMC Sonoma
May 03, 2009 | 1999 Pontiac Firebird
719 people viewed this question
Usually answered in minutes!