Question about 1998 Chevrolet Cavalier

1 Answer

Left fron axle needs replacement - 1998 Chevrolet Cavalier

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

Pretty good do it yourself job.take off wheel.loosen axle nut in the center.seperate table from ball joint.give the shaft a few shots with an extension and a hammer to loosen it.loosen the clips around the inner axle boot.pry it out of the tranny.shaft should come out.inspect splines on tips of the shaft.is damaged also take note that the spindle bearing and tranny output bearing might have damage on the teeth.

Posted on Oct 04, 2009

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 6982 Answers

SOURCE: fron axle replacement

Sometimes they can be on there really tight. If you don't have a good air-impact gun available, you can use an impact socket attached to a one piece breaker bar (no swivel or flex head ones...they will snap) with a five foot black pipe slipped over it for more leverage.

Posted on Apr 06, 2009

Blackberry_U
  • 223 Answers

SOURCE: axle seal leak after replace transmission axle

its just the seal. not the axle.

Posted on Jun 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Diagram of 4wheel fron axle on a 2001 blazer


Chevy dealership parts dept will print it out for you.

Mar 23, 2015 | 2001 Chevrolet Blazer

1 Answer

98 jeep grand cherokee front diff loosing fluid thru vent hose and overheating


sounds like you have blown the internal heater matrix and the thermostat is not working or is blocked. you are going to need a new matrix and thermostat and a bloody good flush out of the system just in case there is something in the system means taking off the rad hoses flush them out from both ends. and doing the same to the engine. replacing the matrix as its not going to be able to fix it if its shooting water out of the vents change the thermostat check pipes for damage.

Mar 23, 2014 | 1998 Jeep Grand Cherokee

4 Answers

Clicking noise down by the front tires.


check your axles, for an open cv boot, this clicking is on straigth or turning, if turming to your rigth you hear noise to be louder on your left then your left axle is bad, do the same to your left and if noise exists then your rigth axle is bad.good luck

Feb 27, 2011 | 2003 Dodge Caravan

1 Answer

97 s10 blazer.. need to fill rear with gear oil. where is plug?


most axles fill plugs are located on the rear cover just fill until it starts coming out and your done. on some axles there will be a plug on the axle itself located on the fron side of the housing close to the driveline

Mar 05, 2010 | 1997 Chevrolet Blazer

1 Answer

I have a 1999 plymouth breeze a few months ago


it may be a worn out boot and since you let it go so long you may now have to replace the front axle. i had that happen on a sentra i used to own

Feb 22, 2010 | 1997 Plymouth Breeze

2 Answers

Clunking in fron end when turning left and accelerating


could possibly be a cv axel or could also be a balljoint

Aug 14, 2009 | Chrysler 300M Cars & Trucks

1 Answer

Fron axle replacement


Sometimes they can be on there really tight. If you don't have a good air-impact gun available, you can use an impact socket attached to a one piece breaker bar (no swivel or flex head ones...they will snap) with a five foot black pipe slipped over it for more leverage.

Apr 05, 2009 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1998 Chevrolet Cavalier Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...