Question about 2004 Land Rover FreeLander

1 Answer

Cental locking wont lock - 2004 Land Rover FreeLander

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

The actuator is toast.this happens alot on these.replace the lock actuator.

Posted on Oct 04, 2009


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 67 Answers

SOURCE: cental locking on MK 3 GOLF

check wires and plastic vacumme lines in between all the doors.pull rubber boot back look for broken cracked wires and vac lines.same thing on hatch open hatch at the left hinge for the hatch and roof you will see the rubber boot.pull it back look for damaged wires vaclines

Posted on Jun 22, 2008

  • 350 Answers

SOURCE: cental locking

hi check your fuses before anything else if they are ok check your wiring in the drivers door as it seems the drivers door actuator is faulty be carfull if you try to see if you can test by by-passing the actuator all the switches need to be connected before you can test as one feeds the other and vise -versa if no live going to the switch and its not a fuse check the wiring loom where it passes through the door to the a-post as opening and closing the door breaks the wires yates210456

Posted on Oct 07, 2008

  • 22219 Answers

SOURCE: cental locking making 'clunking noise'

might just want door trim taking off and everything given a good squirt of engine oil.No wd 40 or spray stuff it dries out too quick

Posted on Feb 28, 2009

  • 1675 Answers

SOURCE: A3 window and cental locking fault

this could be a problem with the convenience control box aparently they suffer from water in and arround the area of the convenience control box First thing to do is lift the carpet and underlay in the passenger front footwell. then remove the plastic trims to make it easier.Locate a black plastic box and open it up to inspect the c/d/lock window control module.You may find it has water in it along with the wiring that runs along the floor to the n/s/f door pillar.Worth a look i suppose...hope that helps

Posted on Feb 04, 2010

  • 642 Answers

SOURCE: My Mitsubishi colt CZ1 (07

Central locking works by way of little electric motors that engages and disengages the door lock. The drivers door has an additional set of contacts in the actuator which signal the controller when it changes position. The controller activates the servo motors when a signal is received from the receiver or from the drivers door servo motor. So in your case I suspect the motor part of the drivers door actuator is done for.
To replace you will have to remove the inner driver's door panel to get at the actuator. The actuator itself cannot be repaired and needs to be replaced as a unit.

Posted on Apr 29, 2011

Testimonial: "Very helpful answer and a prompt response. Thanks"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2.0 2004 coupe wont reset on immobiliser, what can i do

You should be able to reset the system by locking and unlocking the drivers door with the key.

Sep 01, 2014 | Cars & Trucks

1 Answer

S type jaguar alarm problem

are you saying the front door does'nt lock with the central locking ? if so then the cental locking is usually controlled by the drivers door lock that sends signal to the othe door locks so depending which front door it is that will be the place to start , at least you know the alarm works

Jul 17, 2014 | Jaguar S-Type Cars & Trucks

1 Answer

Central locking unlocks the vehicle but does not lock

doors do not lock from the key

no way, all doors fail key?

Dec 04, 2013 | 2006 Toyota Fortuner 3,0

2 Answers

1994 pathfinder wont start, wont engage, wont turn over. think i activated the anti theft device

try disconnecting battery and when disconnected switch ignition on the reconnect with ignition on may reset system sounds like a cental lock problem try tailgate

Apr 21, 2013 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

Drivers side door cant lock

this case the driver door lock have problem , need to replace ,try dis connect battery while all doors are open .

Apr 08, 2013 | Skoda Fabia Cars & Trucks

1 Answer

My cental locking isnt working

you got to turn the key to unlock and lock twice in the same direction

Sep 22, 2012 | 2002 Kia Rio

1 Answer

Ford focus cental locking

if this is the problem i think it is then the only anser is to fit a new lock mechanism on the drivers door ,once it goes wrong then the whole lot stops working ,its all controlled from the drivers door lock .

Feb 25, 2011 | 2001 Ford Focus

1 Answer

I have a 99 vw jetta and the battery died we disconnected the battery to get a new 1 but he key wont open the door how do i get the door open to reconnect the new battery?

try this,reconnect the new battery and then lock/hold the key over for 30 secs,then unlock/hold the key over for 30 secs,the windows will go down if its trying to reset.then lock/hold over the key again,then press/hold the unlock button on the remote,this will fully reset the cental locking/alarm/immobiliser system.

Jan 09, 2011 | Volkswagen Jetta Cars & Trucks

1 Answer

Just got a ford ka as the ford ka got cental locking


Yes the ford has a central locking system, you can do that with your remote, and can do it when inside the car, the button is by the door which is at the driver side. You will see the central lock button, but central lock wont work if a door is open.

Take care and good luck

Dec 18, 2010 | 2008 Ford Edge

1 Answer

Cental locking, stopped working after batt failed

Relay was probably burnt out when battery went. Refer to manual for the relay location

Apr 06, 2010 | 2001 Volkswagen Eurovan

Not finding what you are looking for?
2004 Land Rover FreeLander Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

76649 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides