Question about Chevrolet Suburban 1500

1 Answer

Screw just spins on 1997 suburban headlight...cant get light out to replace bulb

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 49 Answers

Try pulling on or prying on screw as you turn it counter clockwise

Posted on Oct 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace the headlight bulb drivers side on a 2002 chevy suburban?


There is a 2 pins on the top of headlight, pull each pin tord you then pull pin up and out. push head light tord fender and push in pull the other side out by the grill. its kind of tricky. take light bulb and twist, lift clip on bulb pull. Reinstall

Feb 04, 2013 | Chevrolet Cars & Trucks

1 Answer

How to replace headlight on a 1997 chevey camaro


You will need a torx wrench to be able to replace your headlights. There is bracket that hold your headlights on. Unscrew the 4 screws (2 on the bottom and 2 on the top) of the bracket and pull the bracket off. Disconnect the wires from the old bulb.
Once you get the new bulb screwed in make sure to check the level located on the bracket is at it's optimal position.

Nov 06, 2010 | 1997 Chevrolet Camaro

1 Answer

2005 Suburban: how do you chang headlight bulb on 2005 chevy subu...


first see if you can reach behind the whole light and get to the connector, daytime running light is more towards the centre of the truck. if you can reach it, just turn it and pull the bulb out. if not then its either going to be bolts or long rods holding the light in place, remove those and then turn the connectors to expose the bulbs

May 17, 2010 | 2005 Chevrolet Suburban

1 Answer

How do I change a low beam headlight?


From under the hood, back side of head light assembly, will be the outer bulb, bulb part # 9006 low beam, turn outer ring around bulb counter clock wise, then turn bulb same way, disconnect harness and install new one, good luck, hope this was very helpfut.

May 14, 2010 | 1997 Chevrolet Suburban

1 Answer

How do I replace the passenger side corner light and front side turn signal light?


Front Turn Signal & Parking Lights


7ccc73e.gif
Remove the 2 parking light housing retaining screws ...


9898a80.gif
... then pull the housing away from the vehicle far enough to remove the bulb socket from behind the housing. Turn the socket counterclockwise and pull


a323ae9.gif
Push the bulb in the socket gently and turn clockwise, then pull the bulb out of the socket. Note the offset retaining ears on each side of the bulb


  1. Remove the screws from the lens and separate the lens from the headlight bezel.
  2. Remove the headlight bezel.
  3. Remove the screws from the turn signal housing and pull it out.
  4. Turn the bulb socket counterclockwise 1/3 turn and remove it.
  5. Installation is the reverse of removal.


Side Marker Lights
  1. Remove the screws from the marker lens and separate the lens from the headlight bezel.
  2. Pull the bulb from its socket in the back of the lens.
  3. Installation is the reverse of removal.

Feb 14, 2010 | 1997 Jeep Grand Cherokee

1 Answer

How to change rear signal light on a 1997 chevy suburban


LOWER REAR HATCH SHOULD BE TWO SCREWS ON SIDE OF LIGHT REMOVE AND TAKE LIGHT OFF MIDDLE LIGHT SHOULD BE SIGNAL LIGHT BULB PUSH TAB AND TURN LEFT TO REMOVE REPLACE BULB .

Jan 28, 2010 | 1997 Chevrolet Suburban

2 Answers

1997 Suburban. Turned on headlights and truck completely died


under the hood there is a fuse box with a 50 amp fuse in it this may need to be replaced

Nov 14, 2009 | 1997 Chevrolet Suburban

1 Answer

Replace headlight bulb--unplug from bulb--is there--95 sub-1500-l


Not sure for your model but most press in lightly and turn one way or the other about 1/2 to 3/4 inch. Never force it though as you might have to replace more than you want.

Oct 24, 2009 | 1995 GMC Suburban

2 Answers

Cant get parking light fixture off to replace bulb.


how do i replace parking bulb in front of impreza 2007

Apr 27, 2009 | Subaru Impreza Cars & Trucks

1 Answer

Left headlight replacement on 2004 suburban


no to un screw light pull out them replace bulb

Dec 30, 2008 | 2004 Chevrolet Suburban

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...