Question about 2006 Ford Focus
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
First remove the rear seat bottom cushion (grab the front edge roughly in the center of each seat position and pull up firmly, and it'll unclip and come out). Then fold down the rear seatbacks. Now, the side bolsters for the seats (between the seatbacks and the doors) have to come off. First, pull down strongly near the bottom (there's an upward-facing hook there that clips onto a ring and holds the bottom in place). Pull down and forward and it'll come off. Then slide your hand about 75% of the way up, and pop the bolster straight forward to pop out a retaining clip. Finally, you can remove the top of it from its mount, and you'll have the bolster out. Repeat for the other side.
Go into the trunk and look up at the bottom of the rear shelf. The harness plug for the third brake light is there - unplug it.
Now, back in the rear seat area, just grab the front edge of the parcel shelf and lift upward to pop it loose, and the whole thing will slide forward. Then you can remove your speakers.
Install is the reverse of disassembly.
Posted on Jul 30, 2008
SOURCE: Honda Accord brake light removal
It's a lot of work for just cleaning.
Fold the rear seat down and remove the two 12mm bolts on the bottom corners of the seat back, pull the seat out.
Between the seat bottom and the carpet you will find two tabs you need to pull and then pull the seat bottom up and out of the car.
Remove the two 10mm bolts securing the seat bolsters to the area the seat bottom was covering. Pull the seat bolsters up and out of the car.
Pop the "C" pillar trim off of the car (above the parcel shelf and beside the rear glass) (side airbag vehicles have a slightly different procedure.)
Pull up on the parcel shelf carefully and evenly. Remove clean and put everything back together.
Posted on Dec 25, 2008
SOURCE: loose steering wheel
Disconnect negative battery cable(10mm).
Insert key and rotate steering wheel until one of the mounting bolts for the airbag are visible from the backside (7/32 or 5.5 mm).Unscrew and rotate 180 degrees until the other is visible.Pry airbag off with a small screwdriver (being very careful) release yellow connector and place airbag aside with leather or vinyl pointing up.
Use a 24mm socket and tighten to 37 ft.pounds.
Reverse procedure to re-install airbag.
Connect cable and remember the computer will have to relearn its settings so car may run different for a while..
Posted on Oct 06, 2009
its quite quite simple;take your pipes of and block them off reconnect them to new pump and replace pump to in line belts.adrian;;;
Posted on Nov 14, 2009
-check the dimmer relay under the hood , in the fuse and relay box.
- check the tail light relay located passenger's side behind the glove box
Posted on Apr 26, 2010
Tips for a great answer:
Jul 08, 2014 | 2000 Ford Focus
Sep 05, 2012 | Ford Five Hundred Cars & Trucks
Feb 22, 2011 | 2007 Chevrolet Impala LS Sedan New Cars
Jun 05, 2010 | 2006 Ford Focus
Jan 23, 2010 | 2000 Ford Focus
Nov 16, 2009 | 2006 Ford Focus
Jan 15, 2009 | 2006 Ford Focus
Dec 15, 2008 | 2006 Ford F 350 Super Duty
39 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: