Question about 2002 Hyundai Santa Fe

Open Question

The engine check warning light comes on and the Auto box goes into 3rd gear, the garage have checked and cannot find this intermittant fault. I have looked inthe users manual and it states it is a faulty sensor on the exhaust system ?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Would anybody have any ideas as to why I am having intermittent gear box jamming can't get into 1st, 3rd or 5th on my Peugeot 307 2006?


You most likely have two problems. 1. The throw out bearing is probably bad, and 2. This has caused some gear shearing within the gear box. Best fix is to have the gear box removed, cleaned, check for chipped, cracked gear teeth, and replace with good gears. Also, check the synchronizer , make sure it is in good working order.

Nov 09, 2017 | Peugeot Cars & Trucks

1 Answer

My 2004 Audi A6 tdi can only get up to 2nd gear in auto or tiptronic. Auto gearbox garage said it is the engine - VW/Audi garage said engine is ok. No fault codes or dash warnings. was on the motorway...


Is it not shifting into third gear (meaning you're at redline and the car won't shift), or is there not enough power to get the car going fast enough to warrant going into third gear? Have you checked to see if the car is in limp mode?

Sep 02, 2013 | 2004 Audi A6

1 Answer

Gear box fault warning light


that gear box fault light comes on, its pretty much game over for the transmission. It only a matter of time before performance of the transmission gets worse and worse. BUT that transmission is VERY easy to replace, i would check out a few trustworthy independentshops to give you a better price! I am usually a die-hard dealership, having been working at this jaguar land rover dealership for the last 2 years, but you are pretty much for sure going to be a cheaper price on the labor and like i said it is a pretty easy task.

My only precaution MAKE SURE IF YOU GETTING A USED TRANSMISSION THAT YOU GET SOME TYPE OF WARRANTY ON IT. Too many times have I seen customers loose thousands of dollars paying someone to put a used engine or transmission and have it fail almost right away

Sep 06, 2012 | Jaguar Cars & Trucks

1 Answer

Engine warning light keeps coming on, Have had 4 diagnostics but no fault is found. How do i currect the warning light??


if auto trans. check auto trans fault , if manual gear box , check vacum leakage ( smal hose ) intakmanufold carbon tank return valve

Jul 02, 2011 | 2000 Volkswagen GTI

1 Answer

I have an intermittent fault on my range rover hse 2006 automatic, seems to miss a gear revs then surges into the gear change, sometimes the dashboard warning reads transmission fault, limited gears...


It could very well be the gear box. Before I read that part of your question I was leaning that way. It could also be a malfunctioning computer chip. I would find another garage that will diagnose the problem independently. Just tell them the problem don't say you had another garage look at it already. If they have the same result go with the lower bid or ask if they can be the lower bid. If they are different diagnosis you may want a third opinion. Of course this is assuming that each diagnosis is free. Good luck.

Mar 09, 2011 | 2005 Land Rover LR3

1 Answer

AUTO warning light comes on - 2004 Renault Scenic Petrol Auto


Auto warning light comes on but goes off when car stopped and restarted. Temp also goes higher

Aug 17, 2009 | 2005 Renault R5

1 Answer

Can a replaced non programmed abs affect auto gearbox


The ABS control unit does need to be coded to the vehicle. After coding the control unit, an End-Belt run test must be performed. I know that you will also have transmission faults stored, because the Trans warning is set since the control unit has not been coded
and the control units communicate constantly during engine operation. The trans uses abs input for shift characteristics and helps with power reduction during evasive driving control. A dealer should be able to code and perform the end run test and usually charge about an 1hr fee. They will also need to quick delete other fault memories.

Mar 16, 2009 | 2001 BMW 5 Series

2 Answers

1997 isuzu wizard mu check light


Code 24 is a vehicle speed signal sensor fault, the sensor most likely does not provide a useable signal until about 25 MPH, when the computer doesn't see any signal after that speed it turns on the light. Make sense?

Sep 08, 2008 | 1997 Isuzu Oasis

Not finding what you are looking for?
2002 Hyundai Santa Fe Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...