Question about 1997 Toyota Corolla

1 Answer

Opening the side board of side door of my toyota corolla car. I have removed the clippings but how would I remove the window riser control?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 288 Answers

Manual window locking clip pops out from window handle shaft.

Power window rear door switch is held by four screws on onside of door panel. Remove panel to access.

Power window front door switch pops out of armrest.

Posted on Feb 23, 2010

  • Stanley Nov 15, 2011

    what I did was to push the side panel back and reach in with the small long nose plier to remove the clip locking the raiser control to the winder shaft.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Door lock assembly


Toyota Corolla 1988-1997 Repair Guide Door Locks - REMOVAL & INSTALLATION
(see Figure 1)
  1. Disconnect the negative battery cable.
  2. Remove the door panel and watershield. Remove the service hole cover.
  3. Disconnect the door outside opening linkage. Remove the two mounting bolts and remove the door handle if in need of replacement.
402f2b0.jpg

Fig. 1: Power door lock control system component locations
  1. Disconnect the lock cylinder control linkage.
  2. Remove the lock knob and the child protector lock lever knob.
  3. Remove the lock assembly retaining screws and remove the door lock. If equipped with power locks, disconnect the electrical harness.
  4. To remove the lock cylinder, remove the lock cylinder retaining clip and pull the cylinder from the door.
To install:
  1. Coat all the door lock sliding surfaces with multi-purpose grease.
  2. Install the outside handle with the two retaining bolts, if removed.
  3. Install the door lock solenoid linkage to the door lock.
  4. Connect the link to the outside handle.
  5. Install the lock knob and the child protector lock lever knob.
  6. Install the door opening control link tighten the mounting bolts to 48 inch lbs. (5 Nm).
  7. Install the door lock cylinder control linkage.
  8. Install the door panel and watershield.
  9. Reconnect the negative battery cable.

Hope help with this; remember rated this post and thank you for using Fixya.

May 20, 2010 | 1991 Toyota Corolla

1 Answer

1995 toyota corolla passenger side window will not close stuck open


Replace window regulator and motor. Procedure: Remove inside door panel, cut regulator wires, raise window manually and hold in place, undo bolts holding window glass to regulator, undo bolts holding regulator to door-frame, remove regulator. Reverse to install.

Feb 11, 2010 | 1995 Toyota Corolla

1 Answer

Removing the window crank 2004 corolla


Hello. Yes, it is behind the washer. You need a thin hooked tool to remove it. Pull out on the handle, and press in on the door panel to see it.

Nov 26, 2009 | 2005 Toyota Corolla

1 Answer

How do i replace interior door handle for my toyota corolla 2001 on the driver side


you must remove the door trim panel. the inside handle is bolted to the door with a lock and latch cable attached to it. screw at door hanle cover and another under window and lock master switch, then push clips holding around edge of panel. you will also need to remove small cover for inside of mirror

Oct 03, 2009 | 2001 Toyota Corolla

1 Answer

How do i remove the backdoor panel to replace window on 2003 toyota corolla le?


Remove the rear door armrest by prying upward (secured with 3 clips/claws)

Remove the rear window switch assembly by prying upward (secured with 4 clips/claws)

Remove one phillips head screw from behind the inside door release handle.

Remove two phillips screws from either side of the door pull pocket

Pry the bottom edge of the panel away from the door, releasing 7 pop-in fasteners

Lift up on the panel to remove it from the door.

Once inside there will be two 10mm bolts holding the glass onto the regulator.

Sep 10, 2009 | 2003 Toyota Corolla

2 Answers

My automaticdriver side window in my 2001 toyota corolla goes down, but won't go back up instantly. It usually takes 1-3 minutes to do so. Any ideas why?


It sounds like your motor is dying.

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to remove the motor which will be secured down by a few bolts

Sep 07, 2009 | 2001 Toyota Corolla

1 Answer

Remove a driver side door panel on a 2000 Toyota Limited 4 Runner


remove the screws that hold the inside door handle and clips behind the door panel

Jun 14, 2009 | 2000 Toyota Corolla

1 Answer

What are the steps to replace the passenger side, sideview mirror.


if not electric, remove the screw in the end of the adjustment lever inside the car, remove the cover, undo the three bolts & it should pretty much fall off. If its electric you may have to remove the door panel 1st to access the plug. To remove the door panel carefully remove the inner door opener surround (it will either have a screw in the middle or be clipped on) if its clipped on be very carefull, they break. remove the bungs & screws holding the inner door handle on & possibly the elec window switch or winder if its not electric (small circlip behind base of winder, use hook or small screwdriver) remove any other screws you can see. CAREFULLY pull on the door panel popping the clips behind bit by bit.

Apr 05, 2009 | 1989 Toyota Corolla 2 Door

1 Answer

Replacing a manual door mirror on 1999 toyota corolla


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Feb 27, 2009 | 1999 Toyota Corolla

1 Answer

Side view Mirror replacement


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door

Jun 18, 2008 | 1991 Toyota Corolla

Not finding what you are looking for?
1997 Toyota Corolla Logo

222 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...