Question about 1999 Toyota Camry

1 Answer

Where is the motor oil sender switch? I have clean oil, new filter. but oil light still on.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 432 Answers

Your owners manual will tell you how to reset

Posted on Oct 04, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Shut down on low oil pressure.

check oil level if good possible need oil change --filter collapse, check valve malfunction in filter,---sludge ,oil sender bad ,screen (certain vehicles have a screen in under sender)clogged -some vehicles when started switch over to the oil circuit to stay running if oil pressure problem then shuts off to protect motor

Aug 28, 2015 | Cars & Trucks

1 Answer

How to fix an oil pump leak on a 2004 ford mustang?

more info is needed on this, but I'll try to help you I will assume that this may be a 4.6 Romeo/ Windsor motor and if it is the oil pump is behind the timing cover and would not show a visible leak unless there is oil leaking from the cover gasket this would be the problem not the pump/next if you jack up the car put it on jack stands safely and look under it at the bottom of the engine there are a couple of things that could cause the leaking oil (1) oil filter loose/or to tight if there is oil all over it clean it off with a rag and let the motor run with the oil at the proper level if its loose or a broken O ring on the filter you will see the oil coming out if so change the filter and tighten till a good snug fit is achieved (2) the oil sender unit could be leaking oil from it this sender is screwed into the oil filter adapter and has an electrical plug on it the sealer on the threads may be leaking and can be fixed by cleaning and applying new sealer or the sender may be bad and needs to be replaced is the oil light coming on steady or on and off at times (3) if you clean everything off and then take baby powder and throw it all over these areas the leak will show up in the powder if you can't find it , if you see oil and antifreeze the green stuff leaking from the same spot behind the oil filter the adapter gasket is leaking be careful here because your cooling system can be clogged causing this gasket to leak go slowly and post back to me what you have done a step by step procedure will narrow this down to the cause I'm a taxi mechanic in N.Y.C. and 4.6's are what the crown Victoria's and Lincoln town cars have it's the same motor you must tell me if this is your motor if not I will still be able to help you further good luck in your search for the leak and do it safely a good jack and stands no junk stuff you'll be under the car and need assurance that you will be safe LATER MAN!

Aug 24, 2014 | 2004 Ford Mustang

1 Answer

Hi can anyone point me in the right direction to find where the oil pressure switch is fitted on the Mk 5 golf Gti 2.litre petrol as would like to change the switch cos oil light intermittently comes on...

Hi Binny, The oil pressure sender unit should be close to the oi filter housing. If memory serves if should be in front of the engine (with you looking into the engine compartment from the front of the car. Regards John

Mar 28, 2012 | 2007 Volkswagen New Gti

1 Answer

Oil light on dashboard constantly shows even after changing oil and oil switch in my audi a4.

some engine have two oil pressure sender one on oil filter housing anther on cylinder head direct to camshaft cover case . if this indicator is yellow light there is oil level sender down the oil pan (some models)some time have carbon inside need remove and clean . if all pressure sender is OK .then you have to clean the oil pump strainer after you remove oil pan there is metal pipe with filter fix with two bolts remove and clean it

Jun 21, 2011 | Audi A4 Cars & Trucks

1 Answer

The oil light comes on when the van is in idle, but not all the time mostly after driving awhile. All the fluid levels are ok. The oil & filter was just changed a couple months ago.

Replace the oil pressure sender and the problem should be solved . Fortunately , the senders tend to go out more frequently than the oil pump. If you change oil pressure sender and the light keeps coming on , you may have to consider replacing the oil pump in the motor or risk getting stranded some where with a blown motor.

Dec 29, 2010 | 2000 Plymouth Voyager

2 Answers

Have an 04 lancer. Oil light comes on sometimes just flickers, but only after warmed up and at an idle. driving down the road the light stays off. Oil never low and just changed with filters, brand new...

Replace the oil pressure sender. The sender is what is turning the warning light on.If you replace the oil pressure sender it should fix the flickering light problem. If it does not , the light is an indication of more serious motor killing problem. Fortunately, the sender is under $10 and usually fails before the actual oil pump.

Nov 06, 2010 | 2004 Mitsubishi Lancer

1 Answer

How do I get to the oil sending unit

The oil pressure sender is a sensor connected to your engine block. It has two wires connected to it and one is directly linked to the oil pressure gauge located on your dashboard. The sender is typically located at the front of your engine block near the fuel filter and close to the intake manifold. Applications vary, so be sure to check your owner's manual to confirm its actual location. You should have easy access to it from the front of the engine block, but you may still need to remove some parts or components to reach and replace it like the fuel filter. You'll need to detach the two wires connected to the outside, unscrew the sender from its housing, clean the gunk out of the threads in the housing, pre-seed the threads of the new sender with a light film of oil, and then screw the new oil pressure sender back into the housing. The final steps include re-attaching the two wires and any removed components like the fuel filter.

Oct 14, 2010 | 1996 Volkswagen Jetta

1 Answer

My 1996 audi A6 has an oil sending unit problem...can you tell me what that might take to fix and why would this show leaking oil? I thought this part was inside the oil pan?

The oil pressure sender unit is located on the oil filter housing.These do tend to leak at times. The warning light for this switch is a red oil can and a buzzer. Replace the switch. If warning light still comes on, have the oil pressure checked. The oil level sender warning light is an orange oil can with oil level under it. This sender is fitted on the bottom of the oil sump and can leak past the seal. If warning light comes on, check oil level. If ok, check for damage to wiring under vehicle. Senders do some times become faulty.

May 20, 2010 | 1996 Audi A6

1 Answer

Car leaking oil around oil filter but it's not the filter itself.

Hello scolletti1: The part that sits directly above or just to the right of the oil filter is the oil pressure switch or sender unit. Depending on your dash. If you have a light it is called a switch, If you have a oil gage it is called a sender unit. The faster the RPM the faster the oil leak. Should you need any further help just ask? Thank You for using FixYa. Roger

Apr 15, 2009 | 1996 Plymouth Breeze

1 Answer

1992 Honda Accord Oil Leak

Check the threads on the new sender/switch. They should be slightly tapered. Some of the less expensive replacement parts have straight threads, try a new part from the Honda dealer. The grey/white stuff is teflon type pipe sealant, this is the correct material to use on the sender threads. Clean the threads in the block very well first.

Jan 10, 2009 | 1992 Honda Accord

Not finding what you are looking for?
1999 Toyota Camry Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

78936 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides