Question about 1985 Chevrolet Chevy

1 Answer

Steering colunm diragram for a 89 chevy c 1500

I need a steering colunm diragram for a 89 chevy c 1500

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 432 Answers

Autozone ,Chilton manual for about 10.00 has this info

Posted on Oct 04, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 chevy cavalier ignition powered on every turn


it is your body control module. it is located under the dash on the drivers side next to the steering colunm

Jan 27, 2013 | Chevrolet Cavalier Cars & Trucks

1 Answer

Had to replace the steering colum in my 2002 olsmobile silouette and now my alarms activated and can't get it off


do you replace the steering colunm with a used one? what you need to do is found the car the used steering colunm came from and pull the BCM out of it because the steering colunm and key is programmed to that BCM. the body control module is located uder the dash on the drivers side where the steering colunm is. if you need more help. here is the link to my garage I am on facebook.https://www.facebook.com/TedsRepairs

Dec 21, 2012 | 2002 Oldsmobile Silhouette

1 Answer

My windshield wipers plugg is unplugged on my 1985 chevy camaro i dont know where to plug it back in on the steering colunm


Look under the dash on top of the steering column shaft.You can lay the wire connector out along the column shaft to give you an idea about where it is.

Jan 21, 2012 | Cars & Trucks

1 Answer

I need instructions on how to change out the ignition switch on a 2004 gmc 1500 pickup truck


Hello Steve...The lock cylinder will come out if you can turn the ignition switch. You have to remove the bezel around the steering colunm, the plastic trim behind the steering wheel. There is a small hole on top of the ignition lock housing, you need to turn the ignition to the run position, move the shifter to drive(so the starter does not enegage) use a small pick to push in the small hole and turn the ignition to the start position. The lock cylinder should now slide out.
I will post a schematic.
You do not need to remove the steering wheel.

Happy Holidays...good luck, i hope this helps, please rate me a fixya.

ce935df.gif

Dec 25, 2009 | 2004 GMC Sierra 1500 Crew Cab

3 Answers

'89 chevy k1500 sloppy steering wheel (HELP PLEASE)


Everyone always gravitates to the suspension but folks, it's 99% sure that it is the EVO. The EVO is the sensor built into the steering column that senses movement of the steering wheel then controls the power steering pump accordingly. When it goes out (which is all too frequently) you get sloppy and loose steering at lower speeds and it does tighten up a bit on the highway at higher speeds. This is the way it is supposed to work but when it fails it's downright scary trying to keep the truck straight on a narrow two lane road!

Jun 14, 2009 | 1998 Jeep Grand Cherokee

1 Answer

Power steering 89 chevy


well if you have power asisist it will run from the master down to the pump and ger box.if you feel you have the wrong line you can go to your local car dealership remember to copy vin # down they can print you a diagram with a part number on it. also autozone has z-net on line with repair info and how to info

Jan 15, 2009 | 1989 Chevrolet K1500

1 Answer

Reverse lights don't work


simple thing first... make sure the bulbs are not burnt out... check the fuse.... then there is a sensor/switch located either on the steering colunm or on the transmission. quick test... put it in reverse and jiggle the shifter... if they come on that takes care of the first two issues....

Robert

Sep 11, 2008 | 1993 Chevrolet C1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...