Question about 2000 Jeep Cherokee

1 Answer

Codes 300,302,303,306. replaced ignition coil and plugs. still misfiring

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 677 Answers

You have a misfire in all but some of your cylinders.The most common cause would be a new distributor cap is needed.Of all the problems it can be,I think this is it.hope this helps

Posted on Oct 04, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 grand prix gxp 5.3. When you are driving normally it will miss from 50mph and up. When you punch it it doesn't miss a beat. I cleaned the maf sensor and air filter, Plugs were replaced.


It's probably a coil breaking down , have a scan tool hooked up an have misfires checked to see which cylinder is missing .
Ignition Coils
Each ignition coil has an ignition 1 voltage feed and a ground. The engine control module (ECM) supplies a low reference and an ignition control (IC) circuit. Each ignition coil contains a solid state driver module. The ECM will command the IC circuit ON, this allows the current to flow through the primary coil windings for the appropriate time or dwell. When the ECM commands the IC circuit OFF, this will interrupt current flow through the primary coil windings. The magnetic field created by the primary coil windings will collapse across the secondary coil windings, which induces a high voltage across the spark plug electrodes. The coils are current limited to prevent overloading if the IC current is held high too long. The spark plugs are connected to their respective coils by a short secondary wire. The spark plugs are tipped with iridium for long life and efficiency.
Drive it long enough like that (with it misfiring ) the check engine light will flash . This is to warn that a catalytic converter damaging event is taking place . This would also set a DTC - diagnostic trouble code
DTC Descriptors ?€¢
DTC P0300 Engine Misfire Detected


?€¢
DTC P0301 Cylinder 1 Misfire Detected


?€¢
DTC P0302 Cylinder 2 Misfire Detected


?€¢
DTC P0303 Cylinder 3 Misfire Detected


?€¢
DTC P0304 Cylinder 4 Misfire Detected


?€¢
DTC P0305 Cylinder 5 Misfire Detected


?€¢
DTC P0306 Cylinder 6 Misfire Detected


?€¢
DTC P0307 Cylinder 7 Misfire Detected


?€¢
DTC P0308 Cylinder 8 Misfire Detected

Apr 26, 2016 | Cars & Trucks

1 Answer

Honda odessey engine code p3100


There is no p3100 code!!

I think you copied this wrong. the code is p0301, which is a common one.

The P0301 code means that the cylinder 1 is misfiring or is randomly misfiring. Start by checking for intake leaks an if no leaks are found the next step is to replace the spark plugs on cylinder 1. If the problem persist more tests needs to be done to diagnose problem.

Possible causes
- Faulty spark plug 1
- Clogged or faulty fuel injector 1
- Faulty ignition coil 1
- Fuel injector 1 harness is open or shorted
- Fuel injector 1 circuit poor electrical connection
- Ignition coil 1 harness is open or shorted
- Ignition coil 1 circuit poor electrical connection
- Insufficient cylinder 1 compression
- Incorrect fuel pressure
- Intake air leak

Most likely cause:
Faulty spark plug 1 or Faulty ignition coil 1 (Ignitor coil)

Either are easy fixes. Start with a new spark plug. If the problem continues replace the coil. Pic below. new about $30-$40.





25668053-d0khtfozkoi42lnxngz2bi0n-3-0.jpg

Apr 27, 2015 | 2005 Honda Odyssey

2 Answers

Still having problems will not run good. 1997 ford 2.0 escort;new plugs&wires coil;fuel pump still codes 0351;


From a reputable repair website:


P0351 - OBD-II Trouble Code

Auto Systems and Repair

Ignition Coil "A" Circuit Primary/Secondary Malfunction Our emissions expert has put together the following information about the P0351 fault code. We have also included diagnostic procedures you can take to your repair shop if the mechanic is having difficulty analyzing the code.
OBD II Fault Code
  • OBD II P0351 Ignition Coil "A" Circuit Primary/Secondary Malfunction
What does this mean? The ignition coil or coils are responsible for igniting the air/fuel mixture inside the combustion chambers. Without reliable performance from the ignition coil(s) the vehicle will stumble and misfire.
Code P0351 indicates there's an electrical problem in either the primary ( the computer side ) or the secondary ( the spark plug side ) of the Ignition Coil "A" Circuit.
Symptoms
  • Check Engine Light will illuminate
  • Engine idles rough
  • Engine misfires on acceleration
  • In rare cases, the engine may not exhibit noticeable symptoms
Common Problems That Trigger the P0351 Code
  • Defective Ignition Coil(s)
  • Defective Spark Plug(s)
  • Intake Manifold Vacuum leaks
  • Carbon buildup in the Throttle Body air passages
  • Defective Idle Air Control Valve or Electronic Body
Common Misdiagnosis
  • Ignition coil(s) replaced when cause of the malfunction was a vacuum leak
  • Spark Plugs replaced when cause of the malfunction was a vacuum leak

Dec 21, 2014 | Ford Cars & Trucks

1 Answer

Vehicle is hesitating, like it is going to cut off.


There are a few things that can cause an engine misfire and hesitation. Does your van have a CoP ignition system? (Separate ignition coils for each spark plug) Or coil pack? You may have bad ignition coil(s); that would cause a misfire. If you have a dirty/clogged/leaky fuel injector for cylinder 3, that could also cause a misfire condition. When you replaced all the spark plugs, did you look at the plug from cylinder 3? Did they all look the same? Sometimes you can get clues to what is going on in your cylinder by how the spark plug looks: if it's white or glazed you are running too lean and could indicate fuel injection problem, if it's got burnt oil on it and it's sludgy you may have a leaky gasket or worn piston ring that is letting oil up into the combustion chamber and fouling the plug, causing a misfire. If your check engine light comes back on and it's the same misfire code, have the coil for cylinder 3 checked to see if it's weak or bad. Or you can do a home remedy check and swap a known good ignition coil from another cylinder to 3, reset the code, and see if the misfire moves to another cylinder. If it does, you know the coil is bad. You can pick up an ignition coil for pretty cheap on the internet ($30-$70) if that's the problem and they're simple to install (a pain if they're on a cylinder that's under the intake manifold, but just because you have to unbolt a bunch of stuff to get to it...time consuming but not too difficult). I have a 2001 Mazda Tribute and had a couple of ignition coils go bad, causing misfires. This seems to be a semi-common problem for early 2000's Mazdas.

Apr 20, 2013 | 2005 Mazda MPV LX

2 Answers

NO POWER REVS UP REAL SLOW SHOWS CODES P0301 P0138 P1687 P0355 PO351


Hi, do you have the 4.7 liter engine with coils on every cylinder? 351 and 355 indicate bad coils on cylinders 1 and 5. You can try moving the coils to see if the problem is the coils themselves or the wiring. If the codes change after moving the coils, replace the coils. These misfires could be the cause of the other codes.


jturcotte_1090.gif

Feb 23, 2011 | 2000 Dodge Durango

1 Answer

6th cylinder misfire. replaced spark plug and ignition coil 6 months ago and already misfiring again.Is this a problem with 2000 toyota tundras or is this normal to have to change spark plugs and ignition...


Did u find code p0306 comes up ? Two things can cause this if the plug and coil have been replaced.the intake manifold may be leaking in the area of cyllinder 6 or its a mechanical issue.try doing a cyllinder misfire test and also check the compression on all cyllinders

Dec 16, 2010 | 2000 Toyota Tundra

1 Answer

2003 mercedes Benz C240 codes P0300, P0301, P0302 and P0303. Please, help me how to fix?.


P0300 Random Misfire Detected
P0301 Cylinder 1 Misfire Detected
P0302 Cylinder 2 Misfire Detected
P0303 Cylinder 3 Misfire Detected
according to this fault codes first mark ignition coils
3 ---------------- 6
2 ---------------- 5
1 ---------------- 4
RB-------------LB
this right banks and left bank, please remove Ignition coils with lids and spark plugs from right bank and swap with left bank, if fault code change as
P 0304 Cylinder 4 Misfire Detected
P 0305 Cylinder 5 Misfire Detected
P 0306 Cylinder 6 Misfire Detected
You can Identify it's a faulty ignition system then next swap ignition lids from ignition coils be careful each coils have two lids one short and other long bit deference and when you remove and fix it to the car keep in mind correct order because each coil two different fire for two spark plugs don't mix up, if you mix it can create the fault code.if you detect any fault ignition coils or spark plugs or lids replace that and also whether god or bad recommend to replace spark plugs, find the right that's most important thing, if this way couldn't found the any ignition fault next step is check fuel presser, when the engine running fuel presser must be around 4.5 bar without engine running must be 4 to 6 bar if the fuel presser too low need to check two different things one is fuel pump other is fuel injectors, in this case you can swap injectors from right bank to left bank and find is the injectors leaking, if not leaking faulty fuel pump.is this information helped you? if yes please leave a comment,

Oct 15, 2010 | 2007 Mercedes-Benz C230 Sedan

3 Answers

Misfiring


Have your ignition coils replaced

Sep 04, 2009 | 2002 Dodge Stratus

3 Answers

Cylinder misfire


Does it run bad? Both cylinders are on the same ignition coil.

Jun 08, 2009 | 1999 Plymouth Breeze

2 Answers

99 cougar v6 P0352 misfire cylinder 3 and 4 replaced igntn coil..


Had the same problem, car was misfiring on cylinder 3 and 4. replaced wires, plugs, and ignition coil. still misfired on the same cynlinders. turned out the main engine wiring harness plug in was coming loose. spent well over $150 on the unneccesary repairs and ultimately fixed the problem wit a $3 bag of wire ties to hold the plug in...

May 04, 2009 | 1999 Mercury Cougar

Not finding what you are looking for?
2000 Jeep Cherokee Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...