Question about Dodge Neon

1 Answer

Im not getting any spark i have changed the coils

Posted by on

  • carhob May 11, 2010

    did u check if u have 12v supply at coil pack,is cam and crank shaft sensors ok?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 811 Answers

Run scanner to get trouble codes, some auto parts stores will do this for free, check crank position sensor

Posted on Oct 04, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1999 suzuki grand vitara

Try moving the coils to see if the lack of spark moves cylinders. The cam sensor and PCM aren't going to affect single cylinders in most cases. If you decide that you have bad coils, make sure you buy good quality coils as COP ( coil over plug ) coils have a lot of components that can make them fail, particularly in the boot area. Make sure you get some dielectric grease for the inside of the boots as well so that the next time you need to service the plugs, the boots will slide off easily ( silicon paste works as well ). Airtex/Wells is a popular COP to replace these with and will run around $60/COP.

Jan 13, 2014 | Suzuki Grand Vitara Cars & Trucks

1 Answer

Not getting any fire from distributor to plugs

check that you're getting spark from the coil to the distributor. Could be a bad coil or bad wire.

Dec 30, 2013 | 2000 Honda Civic

1 Answer

Im having a problem getting spark

did you change the battery? Do you have power at the coil?

Apr 17, 2012 | 1993 Dodge Dakota

3 Answers

2007 nissan titan turns over but wont start no spark to the plugs .

The problem could be in the spark plugs. Usually if just one of the spark plugs is not producing the spark needed, the engine would still start. It may run rough, but will still start. If none of the spark plugs are producing a spark (or firing) then this could be the culprit.The spark plugs gets power to spark from coil packs.So check the coil pack first.If the coil pack checked ok then its faulty spark plugs causing this problem.Also remove the spark plug connection and clean it and reconnect it and recheck.In some cases this helps. ---------------That's it.

Nov 18, 2010 | 2007 Nissan Titan LE

1 Answer

I have a 2002 Toyota Camry with a 2.4L. It wont starts it tries but wont. I have checked gas and spark. It is getting the gas but issue with spark. Im getting spark to two plugs the outer two but not the...

start by checking to see if you have power and ground at the coil connection look for chewed wire rodents are known to chew on toyota wire harness due to what they are made of

May 02, 2010 | 2002 Toyota Camry

1 Answer

What fuse goes to the ignition coil? when i got this car, the fuel pump wasnt getting power from the fuse box and im not getting spark. im guessing the fusebox is the culprit on why im not getting spark....

You can take this off and have it checked out at you r local auto shop. Most likely if you're not getting spark, the coil is bad. You can check it yourself through a backyard mechanic way, but it can give you a shock if not careful. ( a screw driver in the end of a plug wire, holding it close to a metal ground while someone turns the engine over. If you see spark, then the coil is good. Be sure to use a screw driver with a good insulated handle.

Apr 20, 2010 | 1988 Volkswagen Jetta

1 Answer

Im getting no spark from the spark plugs,changed the rotor and distributer cap. whats next?

see if you have power going to the coil, in most cases on that vehicle the pick up coil is the culprit, it is under the rotor,

Dec 17, 2009 | 1999 Chrysler Cirrus

1 Answer

Im working on my friends car and it's not getting a spark. After i did a full tune up (Spark plugs, plug wires, oil change, air filter, fuel filter, pvc valve, ignition coil.) Now it will not get a spark...

have you unplugged a connector somewhere ,possible without knowing it ,like the pick up sensor when you changed the oil?? go back and check everything its got to be something stupid

Aug 17, 2009 | Oldsmobile Cutlass Ciera Cars & Trucks

1 Answer

No spark on # 5 cylender 1989 cavalier z24

change the control modul. that control voltage to the coils. it sound like it not bleeding off fast enough the control modul is under the coils. befoe changing any part remove ground off battery. befor change any coils u could of swop to see if this is still not firing

Feb 22, 2009 | 1988 Chevrolet Cavalier Z24

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides