Question about 1996 Plymouth Grand Voyager

1 Answer

No battery power to the coil pack - 1996 Plymouth Grand Voyager

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 811 Answers

Check fuses or relay

Posted on Oct 04, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What supplies the voltage to the coil packs


the battery supplies power to the ECM and then the ECM supplies power 2 the coils

May 03, 2016 | Cars & Trucks

2 Answers

2001 beetle no power to the coil packs


The fuse that powers the coil also powers the pcm. Is power getting to the fuse? You may have a wiring issue. Trace back to where the power stops...
0900c152801be516-z51ydotzssbx3fkw4old43yo-5-0.gif

Jul 14, 2017 | Cars & Trucks

2 Answers

I dont have any spark. have power to the coil pack just nothing past that. what to do??


Check the crank shaft postioning sensor. If you are getting power to the coil pack and there is no power coming out of the coil pack the coil pack might be bad or have corrioson between the coil pack and the mount. Thanks

Mar 07, 2011 | 1999 Mitsubishi Eclipse

1 Answer

How come my 2002 ford focus keeps burning the coil pack out?


COIL PACK BATTERY POWER FEED WIRE SHORTING TO GROUND

Feb 15, 2011 | 2000 Ford Focus

1 Answer

No spark runns fine then loses spark wait 10 minutes starts


The spark plugs receives power to spark from coil pack.Check the power at the coil pack and also check the voltage at the coil pack with meter.If the coil pack shows proper power as well as voltage then its fault in spark plugs.Otherwise its faulty coil pack.The coil pack receives power from battery.so also check the voltage of the battery it should be exact 12 volt.
If the battery shows low voltage then the battery needs to be re-charged.
Then check out.
Thanks. you can rate this solution and show your appreciation.

May 20, 2010 | 1992 Pontiac Bonneville

1 Answer

Dont know how to take master cylinder off to replace coil pack


You shouldn't have to remove it....here are the steps from the tech manual:

Removal & Installation
  1. Disconnect the negative battery cable.
  2. Label and disconnect the spark plug wires from each of the coil pack towers.
3db79bc.gif
Ignition coil removal—2.4L engine

2f61688.gif
Ignition coil removal—3.3L and 3.8L engines


  1. Disengage the electrical connector from the ignition coil pack.
  2. Remove the coil pack mounting fasteners.
  3. Remove the coil pack from the vehicle. If equipped, remove the coil pack from the mounting bracket.
To install:
  1. Place the coil pack into position on top of the engine valve cover, or mounting bracket, if equipped.
  2. Install and tighten the coil pack mounting fasteners to 9 ft. lbs. (12 Nm).
  3. Plug in the electrical connector to the ignition coil pack.
  4. Connect each spark plug wire to each corresponding coil pack tower. The coil pack towers are numbered with the correct cylinder identification. Be sure that the spark plug wires snap firmly onto each coil tower.
  5. Connect the negative battery cable.

Jan 18, 2010 | 2001 Chrysler Voyager

1 Answer

Starts with no idle


When changing the coil pack it's an electronic reset. Disconnect the battery and allow the ECU to reset and reconnect the battery after 10-15 minutes or so and give it a restart try.

Ensure the radio and all power draws are turned off initially.

If it doesn't reset check to see that the pack is plugged in secure and it's the right one for your model.

Also try some fuel additive as it may be a diluted fuel issue that cropped up in the time it took you to replace the pack if it's set for a bit.

Also check your wires, plugs and main ground connection to ensure they're all secure.

Lastly ensure your fuel relay cube didn't short out when the coil pack went as well.

Aug 06, 2009 | 2001 Volkswagen Jetta TDI

1 Answer

Where is the ECM located on a 1993 Isuzu Trooper?


If you don't have a coil pack working, unplugging the ECM will do nothing to reset the coil pack. If you have power present at the plug, you need a new coil pack.

Jul 28, 2009 | 1993 Isuzu Trooper

1 Answer

1994 dodge intrepid has no spark unless temp is above 40 degrees


Check the connector at the coil pack/module. Four wire connector that supplies the coil pack with power and signal from crankshaft sensor.

Jan 12, 2009 | 1994 Dodge Intrepid

Not finding what you are looking for?
1996 Plymouth Grand Voyager Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...