Question about 2004 Buick Regal

1 Answer

Would like to know how to get old battery out to replace with new battery

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 60 Answers

Disconnect negative cable first ( black one ) then there is probably a battery holder or tie down that has a nut on top, remove the nut. at this point the tie down should move freely, disconnect red cable. remove battery and replace. Just go backwards of these instructions to put back together.

Posted on Oct 03, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to replace old battery with new in a 2002 oldsmobile silhouette

Take note of any radio codes. If you don't know them, get a small or another 12v battery, a set of small jumper leads, connect the leads clips to the matching cables on the car at the battery. You are now supplying a small current in parallel. Using a buddy to hold the battery terminals away from the bodywork remove the negative first, then the positive. Remove battery and replace with new battery. Reattach positive terminal first then negative, then remove small jumper cables and it should have preserved your codes etc.

Nov 17, 2016 | 2002 Oldsmobile Silhouette

1 Answer


123Mitch eazy ,its called wiring battery in PARALLEL that means positive to positive and negative to negative ,run new wire from old battery to new battery positive, now run a new wire from old battery to new battery negative, that's it. NEVER cross neg to pos. if this helped you please let me know ,good luck .

Sep 15, 2014 | Ford Transit Cars & Trucks

1 Answer

Replacing rear electronic module

will all things electrical i recommend having a mechanic do it. not the dealership because they are over priced. however you can unhook the positive battery cable and replace the part then re-attach the positive battery cable. this will reset it and prevent from short circuit

Oct 27, 2013 | 1999 Ford Windstar

1 Answer

Need new battery for Kia keys

Take the old battery out, and you'll know which kind of battery you need as a replacement.

Nov 14, 2012 | 1998 Kia Sportage

1 Answer

My 2003 Chev 2500 HD w/ Allison transmission having battery problems. The truck has two batteries. Replaced the first one yesterday when the truck would not start. Drove two hours home, and the second...

normal ,it could be as simple as yes old battery,but when you are dealing with two batterys charging you must have a deisel motor and their is a alternator that could be over charging or bad diode.if voltage regulator was the prob . you would have prob. whith new battery also

Jul 25, 2011 | Chevrolet Silverado 2500HD Cars & Trucks

1 Answer

Removed old honda battery due to age replaced with new battery. i get the guuages to illuminate but car will not turn over. i know the battery is new and i removed the protective terinal caps on the new...

No, it should immediately start if you have the battery connected properly. Are you sure this new battery is fully charged? It may just need charging. If the battery is fully charged and connected tightly then you have another problem.

Nov 27, 2010 | 2004 Honda Accord

1 Answer

How do i take out my alternator in 1989 crown vick ok i just found out my alternator is killn my battery so i would like to know how can i take the old one out and replace it with a new one

disconnect battery disconnect connector to altinator disconnect battery connection on altinator loosen serpenten belt from altinator loosen bolts and remove old altinator install new altinator and work back to start of unistalling

Sep 15, 2010 | 1989 Ford LTD

1 Answer

Trying to replace battery. The old battery is 900

Your new battery is rated close enough to your OEM battery to do the job.

Dec 12, 2009 | 1997 GMC Jimmy

1 Answer

Audi A4

There should be either an allen key or a 13mm head bolt holding the battery clamp at the front of the battery. If this is removed, it should come out ok with a shake. i would advise help to lift the battery out as it can damage your back due to the location near the bulkhead.


Jan 17, 2009 | 1998 Audi A4

1 Answer

New Alternator brushes, however battery light doesn't come on

using a mega on rectifiers can damage them
you should take the alternator to an auto electrician for a proper bench test

Jun 25, 2017 | 1987 Toyota Tercel Liftback

Not finding what you are looking for?
2004 Buick Regal Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides