Question about 1997 Pontiac Firebird

1 Answer

What wire color is the brights for my head lights

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 92 Answers

Light Green- High Beam, Tan- Low Beam, Black- Ground.

Posted on Oct 04, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

My 94 camaro turns over but wont start just replaced the heads plugs and wires


You need to run a fault code test on the engine control computer first, to do that follow the link below. FAQ How to read older GM codes for free

Mar 21, 2017 | 1994 Chevrolet Camaro

2 Answers

Headlight wiring help.


check for a loose dirty earth point for the lights. wire not earthed to a pint that is connected back to the battery.

Dec 06, 2014 | Nissan Cars & Trucks

1 Answer

2000 s10 what r. The colors of the wires for the fuel sensor


Dont know the colors off hand. But this is what i do know. You will find with a test light. And with the key on one wire will light the test light real dim...that will be the sending unit power out .now have some one turn the key off and on till.you find a wire that lights your test light real bright only for about three seconds then go off. This will be fuel pump relay wire

Nov 24, 2014 | Cars & Trucks

1 Answer

Head lights are not working only bright lights


It's more and likely your head light fuses or the head light relay if both of them check out okay then start testing the wireing there is more n likely a corroded wire or a break(short) in it sme where good luck wireing can be a night mare

Oct 10, 2013 | Cars & Trucks

1 Answer

3 head lights dim 1normal on dim or bright


I would say you have a bad ground wire. Im not sure about this car but most have a black ground wire fasten to the top of the fender or inside of the inner finder near the battery, Remove the wire and clean the metal and the wire connector with a wire brush, making sure the metal is shiny.
tighten securely and check your lights. Be sure you dont have a black wire going to each light, if so check each one.
I hope these suggestions help you find your problem.

Apr 02, 2013 | 1996 Chevrolet Cavalier

1 Answer

Drivers side head light is way dimmer than passenager light even after new bulb replacement


When looking from the outside of the headlight at the bulb, can you see the bulb clearly??
These lenses are notorious for dulling very badly. If it has you can use a regular headlight 'restoring' kit sold at most auto part locations.

If it is not a lens issue, you may have a wiring/supply issue.
Then you would need to find the troublesome wire/connection.
I am not the best at wiring issues, but I would try to find a power source wire with the same amperage rating, run a bypass jumper from a known good voltage source and see if the light changes. If no change, your problem may be the harness or plug at the rear of the headlight bulb.
Hope I could help
GL

Dec 31, 2011 | 1999 Plymouth Voyager

1 Answer

I have a 95 Nissan 4X4 pickup. I have had this


It seems like you have a bad ground wire or a short.

May 26, 2010 | 1995 Nissan Pickup

1 Answer

Can't turn on bright lights


The mechanic should check on the head light switch.and the wire connection of the head light or the bright connection because may be the problem could there in the connection of the wires, also with the fuse .where you'll have to replace or change the worn out or destroyed wires , fuse and bulb .If it is being loose then you'll have to re connect it . but some times check the module if still functioning good. most of the time the connection or wiring of the head light can be difficult to do that is why you need to use tester positive and negative or amp. tester.To see if the wires or the fuse and the bulb is still functioning or not any more . to use this equipment you'll have to connect the positive to the first wire and the negative to the second wire"The tester positive and negative. or the amp.tester".

Aug 28, 2009 | 1996 Jaguar Vanden Plas

1 Answer

Head Lights


The fuse is not the problem... it is likely a poor spade electrical connector by the back of the head lights, and a poor chassey ground near the head lights, also by the starter and the transmission. Be sure ALL the chassey grounds are wire brushed and cleaned... remove the bolts holding on the ground straps, wire brush then replace.

Sep 09, 2008 | 1987 Volkswagen agon

Not finding what you are looking for?
1997 Pontiac Firebird Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...