Question about 2004 Chrysler Sebring

1 Answer

The back window on my sebring convertible will not go down

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Master
  • 302 Answers

You need either a new motor or regulator, both repairs are probably shown in detail in the repair manual specific to your car

Posted on Oct 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Chrysler Sebring hard top convertible goes halfway back to open then stops in the middle of the cycle.


There are many possible causes of this problem on the convertible Sebrings, the most common problems are as follows;

1) The cargo platform in the trunk is in the wrong position which blocks the rear window from folding downward. Ensure that the cargo platform is in the down position before attempting to operate the top.
2) The Hydraulic pump is low on fluid, it is located in the trunk, in the left rear corner, underneath the carpet. Inspect the fluid level in the reservoir.
3) There is an electrical fault in the system.
4) There is physical damage to one of the panel pivots, inspect for panel binding while the top is moving.

A couple questions for you;

When the top stops moving can you still hear the pump running or does it go quiet?

When the top stops moving does the cluster display "convertible top in operation" or "convertible top malfunction" or something else?

Report back with anything you find or if you need further help.

Nate

Aug 26, 2015 | 2008 Chrysler Sebring Convertible

1 Answer

Power window making noise, but window won't go up or down


Need to take off the door card (the soft lining on the door) and take a good look at the levers in the window mechanism, one has jumped out of position and may need replacing.

Dec 21, 2013 | 2008 Chrysler Sebring Convertible

1 Answer

When i open the top on my 1996 chrysler sebring convertible i notice that the front windows go down but the rear windows don't. is this normal or do they have a reset so they could go down a bit.


I had the same car,when we put the top down we had to hold the botton for the top in the down posistion until the back windows were down.

Nov 15, 2012 | Cars & Trucks

1 Answer

When it rains my sebring convertible has water sloshing in the rear somewhere. is there a drain that empties this problem if so where is it exactly could you please tell me exactly were the drain holes are...


yes there are holes. the holes are on both sides of the back window. climb in back seat and look under the back window on the side rear quarter panel inside you will one on each side

Nov 04, 2012 | 1998 Chrysler Sebring

1 Answer

I have a 1997 Sebring convertible,and when i try to put the top down,the windows go down


the windows need to go down on this vehicle because if they don't there could be stress on the windows and they could break.

Feb 10, 2011 | 1997 Chrysler Sebring

1 Answer

2000 sebring passenger rear window won't close. No clicking noise or anything when either window switch is operated


I have a 2000 Sebring convertable, and my passanger window just went out. It was stuck in the down position. Mechanic said it was a relay switch, could be the same thing. Other things he thought it might be could be the motor of the window itself or the switch. Since both of your switches don't work, then you can count that out.

Jun 21, 2009 | 2000 Chrysler Sebring

1 Answer

2008 sebring hard top convertible top won't close.


This same thing has happened to me. Did you find an answer???

Apr 25, 2009 | 2008 Chrysler Sebring Convertible

1 Answer

Back window of my 2000 sebring convertible seperated from canvas


Simple fix. 3m Super weather adhesive, black. $4. Works great!

Mar 17, 2009 | 2002 Chrysler Sebring

Not finding what you are looking for?
2004 Chrysler Sebring Logo

Related Topics:

202 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...