Question about 2000 Dodge Grand Caravan

1 Answer

3.0 lit i have nosey velve lifters

3.0 lit i have nosey velve lifters

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 743 Answers

There is a lot of additives that people will tell you to add to stop your valves from rattling, but the truth of the matter is that there maybe some more things going on than an additive can cure. You need a tech to look at it to make sure that it is getting the proper oil supply to the valves because it seem like one time or another it was starving for oil and this is the aftermath. If nothing else shows up, that head can be overhauled and you will be quite once again.

Posted on Oct 03, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Nosiey start

nosey starter is bearing in the motor, starter motor should make a roaring sound, and if it goes away after a few seconds then the bearing is dry.. as for not as tight by window don't know what that means ?

Aug 13, 2017 | 2010 Mercury Grand Marquis

1 Answer

Front driver side makes noise I.think I have a tooth missing on drive shaft oo transmission I put it it to park and it rolled away like it wasn,t in park what do I have to do to fix it ?

if the car is rolling when in park their is a problem with the parking plaw; the trans is eather not all the way in park, or the parking plaw as a problem; is the nosey related unknow fix the parking plaw problem you may fix the nosey

Oct 16, 2012 | 2000 Ford Focus

1 Answer

I need to add fluid to my clutch reservoir and blled the line. How do I do this?

if you have lost fluid then you have a bad leak in the system ,,but fill the clutch up open up the bleed velve on the slave sylinder and get a friend to pump the clutch up and down you keep your finger on the bleed velve till no air come out only fluid

Nov 28, 2010 | Saturn SL1 Cars & Trucks

1 Answer

Witch timing marks do I use for my dohc 91 dodge stealth?

I don't know what you got there, but, the marks are just dots, or little arrows, they have to line up or else. I don't think the cam can go in but one way, all 4 valves opening at once doesn't make sense to me but I'll check it out.

Mar 06, 2010 | 1991 Dodge Stealth

1 Answer

My heater stopped working and I replaced the thermostat and checked fuse. What else could it be

if you drained all the water out the engine you may need to bleed the air out of the heater to get it to work right,
look for a plastic bleed velve on a rubber hose it will be high up above the rad or header tank fill rad with water open bleed velve and let water out till no air is in it, top up water in rad,,, do this with a cold engine,,

Oct 31, 2009 | 2005 Chevrolet Malibu Maxx

1 Answer

Fuel pump kicks on, but car won't start If I put fuel in the carb it starts right up, What could be the problem?

have you took the fule pipe off from the card to see if fule is getting to it? it could also be a blocked fule filter,, or an "emergency stop velve" in the closed poshion,, or even a blocked or sticking carburettor float velve???? if the pump is pumping fule to the carb its got to be inside the carb thats fulty?

Oct 27, 2009 | 1989 Pontiac Sunbird

3 Answers

Blowing blue smoke turbo works now and then on an

Sounds like you need a new turbo, the turbo is lubed by engine oil and shaft seals leaking into the intake.

Oct 24, 2009 | 1989 Ford Escort

2 Answers

Engine service soon lite on and a miss at idle goes away under power

Run in to an Autozone, or Pep boys, and get a free code scan. If not obvious by what codes come up, get back to us with the number(s) and we'll better be able to point you in right direction. Guessing now without codes would probably just cost more money.

Oct 24, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

Ford explorer tran. will not work in drive or rev. but will 1 2 3 low gears

its the auto box playing up,,,, the velve block has sticky pistons in it dont try fixing it yourself as you realy wont see any thing wrong with it it need proper test gear to fix it

Oct 24, 2009 | 2002 Ford Explorer

Not finding what you are looking for?
2000 Dodge Grand Caravan Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides