Question about 2001 Chrysler Town & Country

Open Question

How to replace sliding door handle town and country 2000.broken from the hinge.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: 2006 town and country passanger sliding door problem

I've leased two Town and Country vans over the past 4 years, and actually purchased the latest one after the lease. In both vans the sliding doors, normally the drivers side, reacted teh same way. If the door was closed it would open, stop a one point, and then return to the open position. At times I could get it close. But over time the doors stoped working all together.

It is not due to the switch or the motor. Most cases like this (in in both of mine) it is due to the repetitive use of that door, and the realitive inflexibility of the wire harness. Over time, and with more uses (in my case the driver side sliding door was used alot) the wire in the harness fails. Picture it as a willow branch. One snapped off of a tree it first is green and flexible, and bends pretty well into any form. But over time, with age and repetitive bending, it will break.

The only recourse is a new harness, as the wire/wires are broken somewhere in the harness (the belt chain in the lower track of the door). I was temped to take it apart and try to repair it myself, but as the parts were under warranty (I have the extended 85,000 mile), I opted to have the professionals handle it. The repair without the warranty is under $200 typically (parts and labor). Good luck.

Posted on Oct 09, 2008

Ad
  • 1861 Answers

SOURCE: The sliding door handles of my 1998 Toyota Sienna have both broken.

OK, here you go:

Pry out on the bottom of the cupholder bottom, relieve 2 clips, pull the bottom out & slide it down

Remove the door trim screw, and pry out on the door panel, relieve 10 clips, pull door trim off

Remove the horizontal upper trim cover at the top of the door; relieve 4 clips

Remove the vertical door trim cover; relieve 2 clips

Remove the window garnish around the handle; pull the small trim cover off; remove 3 screws
This exposes the inside handle

The inside handle is retained by 2 screws.

Posted on Sep 27, 2008

emissionwiz
  • 76673 Answers

SOURCE: i have a problem with power sliding doors on 2001 Chrysler Town and Country limited

do you mean they are sticking?

Posted on Oct 20, 2008

  • 508 Answers

SOURCE: How to replace '96 Ford Explorer driver side exterior door handle

You will need to remove the door panel to gain access to the handle. Roll the window up or down as needed to get to the nuts that attach the handle to the door. You will also need to remove a rod the goes to the door lock. You will see the rod after the door panel is removed. Good luck.

Posted on Feb 18, 2009

motor1258
  • 6674 Answers

SOURCE: Power door lock inoperable on passenger sliding door only

Not sure if they are same on 2006 but there should be a couple of small rounded metal contacts, or similar, on door that meet with door post to complete the connection. When you find them, clean them off with a little fine steel wool or SOS pad, minus the soap, and see if that doesn't cure it.

Posted on May 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

How To Install Replace Power Sliding Door Lock Actuator Chrysler Town and...


How To Install Replace Power Sliding Door Lock Actuator Chrysler Town and Country 01-07 1AAuto.com

on Apr 05, 2012 | 2001 Chrysler Town & Country

1 Answer

How to replace sliding door handle on a town and country limited 2000


You did not say whether the inside or outside, so here is the instructions to both.
3_21_2012_1_42_05_am.jpg

3_21_2012_1_44_00_am.jpgAnd here is for the outside door handle
3_21_2012_1_47_53_am.jpg

Mar 21, 2012 | 2000 Chrysler Town & Country

2 Answers

Rear passenger door will only open a few inches. Have to manually finish opening and closing.


I'd bet the motor burnt out. If you pull the handle and it opens a few inches, and makes a soun like the door is locked, you might have to get the motor replaced. You probably bought it defective. My 2005 Honda odessy has that same problem from wear and tear.

Aug 22, 2011 | 2005 Chrysler Town & Country

2 Answers

How do you change the cabin filter on a 2000 chrysler town and country


Below the glove box near the center console is a black plastic box that contains the filter. Slide the door toward rear of vehicle and then swing door down to get to the filter. You can see the filter after opening the door.

Jun 10, 2010 | 2000 Chrysler Town & Country

1 Answer

Right sliding door will not open


You could have a broken door handle or a broken power door lock actuator.

May 25, 2010 | 2001 Chrysler Town & Country

1 Answer

Power door lock on pass sliding door not working


I just had mine fixed at the dealer for the same problem. Their first response to me was "this happens ALL THE TIME". He said there is a little plastic pin in the door handle assembly and the pin has been known to slip out of the assembly. However, when they got inside, they said it was the actual door handle (inside) that was broken and had to replace the whole piece. So, the first step according to my dealer/servicer would be to check for the little plastic pin.

Jul 05, 2009 | 2006 Chrysler Town & Country

2 Answers

My 2005 Town and Country's right sliding door quit


i just fixed one. it had a broken wire in the harness that moves with the slider, you have to completly pull the harness apart to find it

Mar 18, 2009 | 2006 Chrysler Town & Country

2 Answers

2001 Chrysler Town & Country Sliding Door Harness


you need to remove the old harness and open it up then repair the broken wires this will save the old harness and what the other people are talking about

Nov 12, 2008 | 2006 Chrysler Town & Country

1 Answer

Sliding door


Saw this in an article:
2001 CHRYSLER TOWN AND COUNTRY - Campaign #01I003000 Summary: LATCHES/LOCKS/LINKAGES:DOORS:LATCH
Defect:
THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH THE SAFETY ACT. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. VEHICLE DESCRIPTION: 2001 PLYMOUTH VOYAGER, CHRYSLER TOWN & COUNTRY, AND DODGE CARAVAN/GRAND CARAVAN MINI VANS THAT ARE NOT EQUIPPED WITH THE REMOTE KEYLESS ENTRY OPTION. THE SLIDING DOOR LATCHES ON THESE VEHICLES COULD RELEASE DURING CERTAIN SEVERE ACCIDENT CONDITIONS THAT INVOLVE THE SLIDING DOOR.
Consequence:
THIS COULD ALLOW THE SLIDING DOOR TO PARTIALLY OPEN.
Corrective action:
DEALER WILL REPLACE BOTH SLIDING DOOR KEY CYLINDER-TO-BELL CRANK LINKS ON THE SLIDING DOORS FREE OF CHARGE (PARTS AND LABOR). DAIMLER-CHRYSLER HAS DECIDED TO CONDUCT A SERVICE CAMPAIGN TO REPLACE THE SLIDING DOOR KEY CYLINDER-TO-BELL CRANK LINKS. OWNERS CAN CONTACT DAIMLER-CHRYSLER AT 1-800-853-1403, CONCERNING THIS PROGRAM.
Try calling that number and see if they'll do a replacement for ya..
1-800-853-1403

Jun 23, 2008 | 1994 Chrysler Town & Country

Not finding what you are looking for?
2001 Chrysler Town & Country Logo

Related Topics:

783 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...