Question about Chevrolet C1500

1 Answer

Where is the crank sensor located on a 96 chev pick up 5ltr v8

Posted by on



1 Answer

It is located on the bottom of the timing chain cover. There is one 8mm that holds it in place

Posted on Oct 03, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

96 chev pickup w 4.3 engine has no spark,new crank sensor,coil,new dist,with cap and roter,and new plug wires,my scanner has rpms reading and i have no codes,???

Did you check primary voltage to ignition coil, pink wire, goes hot with key on. Use a test light to check for voltage. That circuit is fuse protected.
Does the rotor turn when you crank it?

Apr 19, 2018 | Cars & Trucks

1 Answer

2009 XF 4.2L Where is crankshaft position sensor located?

2009 JAGUAR XF 4.2L V8 Supercharged Auto Parts,carcode,1442330,d,2009_JAGUAR_XF_...
RockAuto has parts for your 2009 JAGUAR XF 4.2L V8 Supercharged and all ... XF 4.2L V8 Supercharged Ignition Parts, Camshaft Position Sensor Crankshaft ...

Jaguar XF Crank Position Sensor - > ... > Jaguar Crank Position Sensor > XF Parts
Oct 1, 2009 - They are available for the following Jaguar XF years: 2010, 2009, 10, 09. ... 10 2010 Jaguar XF Crank Position Sensor 4.2L V8 Intermotor.
Images for 2009 XF 4.2L crankshaft position sensor ...

Dec 11, 2015 | Jaguar Cars & Trucks

1 Answer

How much oil in berlina engine

engine oil refill quanity

3.8 v6 quanity required 4.8L

5ltr v8= 5.1litrees

GEN 3 V8= aprrox 5.0l

Jun 24, 2014 | 1999 Holden VT

1 Answer

Can you replace a 4.6 with a 5.0 in a 2003 mountaineer.

i would be very careful about changing these engines as they are from different series model , the 5ltr 1st gen , 4.6 ltr 2nd gen ,the 1st gen used 3 different chassis the 2nd gen only 1 so there may be a mismatch with the mountings , pipe routing etc, the 5ltr is a 'windsor v8 ' which will take up more room in the engine compartment and you have to be certain that the windsor v8 comes from a mountaineer as they were used in other vehicle's and will have differences , but if you like a challenge and don't mind doing a bit of research go for it , but don't expect it to just drop in and all will be in the right place first time ,keep me posted cheers steve

Jun 10, 2014 | Cars & Trucks

2 Answers

Engine diagram showing location of crank sensor on 2004 lincoln ls v8

Hi, be sure to oil the o-ring and twist the new sensor as you push it in.. Please let me know if you have more questions, and thanks for using FixYa.


Jan 15, 2011 | 2004 Lincoln LS

1 Answer

Hi we have a 1993 econoline 5ltr will not start

have you changed the spark plugs or cleaned with heat i would change them with new if you can afford it and be 4 putting them in i would crank engine over a few times then take a comparison reading ..if u cant do a reading then i would put several drops of oil in each cylinder put new spark plugs in and try again O when cranking over hold gas pedal all the way down and yes temp sensor can fluid if bad

Mar 10, 2010 | 1994 Ford Econoline

1 Answer

Check Engine light came on and car stalled

Crank Sensor usually have two function,1st the sensor sense the rotation of the flywheel and picks up by the sensor than the sensor send a sigle to your computer telling your computer to send sparks and fuel to to the engine. When sensor goes bad engine quits running, sometime check engine lights come on as computer is not sending no fuel or sparks. Some car has two sensor, one for the fuel and one for sparks. The sensor usually locate next to the flywheels near the main crank. Some are difficult to get to; others are easy. 4cyc on foreign are easy to get to compare to domestic. V6 front wheel drive I find it difficult and V8 rear wheel drive are better. If you plan to keep the car and fix it yourself, the best thing to do is invest and purchase Chilton Repair Manual if planning do it yourself, it will save you lots of money in the future. On 96' breeze should be a breeze to fix, from experience working on Dodge and Chrysler are fairly easy to work on.

Jul 08, 2009 | 1996 Plymouth Breeze

1 Answer

What Other Engines Can you Put In a 1988 landcruiser, mines tost

* Ford 5.0 windsor
* Ford 351 Windsor
* Chev 283, 304, 350
* Chev or Oldsmobile V8 diesel.
* Duramax V8 diesel.
Take your pick... Just about any engine between 275 and 400 cubic inches will be a good replacement.

Jun 25, 2009 | 1988 Toyota Land Cruiser

2 Answers

96 Chev Silverado having to crank 3 - 4 times before start

take an ohm meter reading on your spark plug outputs between the three coils (if this has that type) big difference replace it and maybe the controller also.

May 04, 2009 | 1996 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides