Question about 1999 Dodge Durango

1 Answer

1998 dodge durango diagram of dash

1998 dodge durango changed heater out and now car heater knobs wont turn and the outside air constantly blows at my feet if its cold outside its cold air if its hot outside its hot air..

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The blower has debris in it. It need to be remove and clean out. How do you remove the dash board. See no screws.

Posted on May 08, 2012

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 7 Answers

SOURCE: 1998 Dodge Durango Turns over but wont start

could be Fuel Injectors, are bad ?
all you need is # 1 Fuel Injector, to go out that will not get Fire, and Fuel Mixture to Spark Plug.

Posted on Jun 03, 2009

  • 323 Answers

SOURCE: 1999 dodge durango heater core

It's a big job. Drain the coolant down, recover the freon in the ac system and disconnect the lines and heater hoses. Lower the steering column, remove the instrument panel assembly, remove the heater housing. Split the case halves on the housing and there you are. Usually around 500 to 700 dollars at a dealership.

Posted on May 29, 2009

  • 740 Answers

SOURCE: fan belt diagram 04 dodge durango

Here is a diagram of you vehicle. Good Luck please leave a FIX YA comment if I fixed ya.

Posted on Dec 27, 2008

  • 43 Answers

SOURCE: need a diagram of the cv joint and cv boot

If you are replacing cv joint the easiest thing is reman axle with two new cv joints and boots installed all you do is change axle good luck

Posted on Feb 21, 2010

  • 6826 Answers

SOURCE: Need a diagram for the

Firing Orders NOTE: To avoid confusion, remove and tag the spark plug wires one at a time, for replacement.
If a distributor is not keyed for installation with only one orientation, it could have been removed and installed improperly and then rewired. The new wiring arrangement would maintain the correct firing order, but could change the relative placement of the plug towers in relation to the engine. For this reason it is imperative that you label all wires before disconnecting any of them. Also, before removal, compare the current wiring with the accompanying illustrations. If the current wiring does not match, make notes of the current plug wire locations and orientation of the distributor cap.
3.9L Engine dod_trk_39firingorder.gif

5.2L Engine 1-8-4-3-6-5-7-2
5.9L Engine Firing order: 1-8-4-3-6-5-7-2
4.7L Engine chry_47_firingorder.gif

Firing order: 1-8-4-3-6-5-7-2
prev.gif next.gif

Posted on Oct 12, 2010

Testimonial: "Great!!"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1998 dodge durango air not blowing through vents

most likely your controls are bad or a vacuum leak in dash

Mar 21, 2012 | 1998 Dodge Durango

1 Answer

When running the heater on my 1998 dakota the air comes out of the defrost ports and not the vents on the dash r out on the floor

most likely you need to go to a dealer and ask them to show you the illustrated parts breakdown of the heater box, or you could get a repair manual. you will see that under your dash and behind the glove box is a heater box. the heater core sits in it, the fan blows through it. there is a temperature control
knob or slider which opens and shuts a door letting cool outside air into the flow, and there is another knob or slide which controls a diverter flap or valve which directs the flow according to your wishes. the diverter is awry in your car. this could be due to about 3 reasons, often a cable has become disconnected at the climate control or heater box end, it is a chrysler product and they made it more complex than necessary by operating it with vacuum instead of a cable, or the diverter has come loose or out of its hinge points. having a picture in your head of what you are dealing with is the place to start before you begin ripping the dash out. it is generally much easier to rule out the dash controls by removing them and making sure there is not something simple at that end.

Dec 09, 2010 | 1998 Dodge Dakota

1 Answer

Heater and frost build up

The direction of the air is controlled by vacuum, you may have a leak in one of the lines that control the doors. On the sides of the dash should be vents that blow on the door and the vacuum issue may be the culprit.
You can try looking for a leak/listening to narrow down the area. I will see if i can get ahold of a diagram and or testing proceedures to cure your ill.

Jan 05, 2010 | 2003 Dodge Durango

1 Answer

My dodge durango fan for the heater is not blowing

Check to see if the linkage has gotten disconnected behind the dash.....

Mar 29, 2009 | 2002 Dodge Durango

2 Answers

Low to No Heat in 1998 Dodge Durango

Provided you bled system good with rad cap off & coolant in rad isn't low, i suspect blend/air door may be malfunctioning, perhaps from a vacuum leak. You might be able to feel or see by reaching in behind dash from driver side, and look for vacuum lines & a plug going into the control. Listen for a "hiss" noise anywhere in that area as well. If you can follow the lines, would help, and pay special attention for vacuum line where it enters firewall on outside in engine area & follow it back to vacuum source too.

Mar 02, 2009 | 1998 Dodge Durango

1 Answer

2001durango vent only blows air through face vent and defroster.

the vent door is broke in the heater control box under dash

Feb 13, 2009 | 2002 Dodge Durango

1 Answer

I have no heat in my 1998 dodge durango it blows cold air i change threm and flush

The problem that has caused this cold air only issue is the Air Temerture Control Blend Door Actuator Motor, this motor is on the ouside of the air duct about center of the dash, in order to access and replace it u must remove the entire dash assembly.

Jan 23, 2009 | 1998 Dodge Durango

2 Answers

No heat can it be heater core

does the car run up to operaiting temp

Jan 23, 2009 | 1998 Dodge Durango

1 Answer

1998 Dodge Durango blows cold air when using heater

The problem that has caused this cold air only issue is the Air Temerture Control Blend Door Actuator Motor, this motor is on the ouside of the air duct about center of the dash, in order to access and replace it u must remove the entire dash assembly. this is about a 12-15 hour job.

Jan 09, 2009 | 1998 Dodge Durango

2 Answers

1998 Dodge Durango no heat when using heater.


Jan 08, 2009 | 1993 GMC Safari

Not finding what you are looking for?
1999 Dodge Durango Logo

555 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides