Question about 2000 Mercury Grand Marquis

1 Answer

I just replaced the alternator and battery in my 2000 Grand Marquis and the other day it kept stalling but would always restart. Could it be my spark plugs?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 127 Answers

Removing the battery may have wiped the comupter's memory. If the engine has high miles it may run like that until it has run for five minutes or so. If you can get it to run and stay running (don't be afraid to give it some throttle for a minute or so and then try to let it idle) and if it runs ok after that, then you just wiped the memory. Also make sure the belt is on right, it will fit a few different ways but only one is right.

Posted on Oct 04, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 mercury grand marquis electrical problems


check the ground frrom neg batt to frame. clean connection and tightn it and make sure the batt cable clamps r tight n still good

Feb 28, 2013 | 1999 Mercury Grand Marquis

3 Answers

My car wont start. I replaced my battery but it still wont start. Tested the alternator and it is good. Something might be draining the battery but not sure what?


Does the engine spin over and not start? Or turn the key and nothing happens?
New spark plugs and wires won't have anything to do with the starter and battery keeping the engine from spinning when you turn the key.
Need more specific explanation. Thanks,
Scott

Jan 22, 2013 | 1987 Mercury Grand Marquis

1 Answer

What could make my 1986 Grand Marquis start hard,run very rough?


gas is only good for 30-60 days drain the old fuel out and put in fresh gas

Sep 30, 2012 | 1986 Mercury Grand Marquis

1 Answer

2000 grand marquis turned ac on and car died


The compressor could be locked up which would stop the engine when the a/c clutch engages.

Jun 23, 2012 | 2000 Mercury Grand Marquis

1 Answer

I have a 98' Grand Marquis with a 4.6 engine. as


have the alternator checked. if the alternator is not charging the vehicle is only supplied with what power is stored in the battery. once the battery is dead there is nothing to charge it

Jul 26, 2011 | 1998 Mercury Grand Marquis

2 Answers

2000 Mercury Grand Marquis Dome light stays on even with doors closed?


you need to check the door push buttons located in the door jams unscrew them one at a time and unplug the wire till the light goes out start with the driver door thats usually the first one to go hope this helps

Jul 31, 2010 | 2000 Mercury Grand Marquis

2 Answers

Where are the spark plugs located on a 2000 Mercury grand Marquis?


There are eight COPs (coil-on-plugs) to remove. Using a 7mm or 9/32" socket, remove each bolt securing each COP to the intake manifold on top of the engine. Remove all eight COPs, and the spark plugs are underneath. When replacing the spark plugs, use only the proper Ford/Motorcraft plugs, even if they cost twice as much as the aftermarket ones. You will avoid further headaches this way. Hope this helps.

Mar 30, 2010 | 2000 Mercury Grand Marquis

1 Answer

1992 Grand Marquis won't start after having starter, alternator and solenoid replaced


With the ignition on, underneath the plastic beauty cover on the fuel rail is a schrader valve to check the fuel pump pressure. Injectors need 31-36 psig to work properly.

Aug 18, 2008 | 1992 Mercury Grand Marquis

Not finding what you are looking for?
2000 Mercury Grand Marquis Logo

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

fordexpert

Level 3 Expert

5520 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...