Question about 1996 GMC Sierra

1 Answer

Rear wheel came off while driving!

My sons car, 1993 dodge dynasty drivers side rear wheel came off, drum and all. I haven't seen it but h tells me that there are some threads stripped in behind where the brake drum goes. Does the dynasty have a spindle?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

The answer is yes but it is held on by a clip ring located at the bottom of the shaft if replaced make shure that you feel it lock in and it should be fine also make sure to put grease on the end of the shaft

Posted on Oct 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1993 Ford Taurus drivers side rear wheel cylinder piston is popping out


Your description sounds like the brakes are WAY out of adjustment. The brake cylinders need the shoes to hit the drum or they will do exactly what you describe. I always adjust the shoes until they lock the wheel, then back off until the wheel spins freely, usually 8 to 20 clicks.

Nov 02, 2012 | Cars & Trucks

1 Answer

I have a 99 dodge ram that I haven't driven in a


Yes you can fix it. Jack wheel off ground after loosing lug nuts. Take off wheel. Pull drum if it wont come off hit it around the center with a hammer. If it has never been off there might be little washers on the studs break them off. If drum still won't come off there are holes in the plate behind the drum the shoes can't get past the ridge on the drum so you take two screwdrivers through the hole and lift up on the lever and use the other one to unscrew back off the shoes by moving the wheel up or down Remove drum take a bunch of pictures of the shoes so you can see how to put them on. Remove shoes. It would help to buy some cheap brake wrenches.Spray the brake line with some type of penetrant and remove brake line. Unbolt wheel cylinder and install new one. Replace brake shoes and springs Have drums turned or replaced if bad Install drums and bleed brakes.Start at the passenger rear fill it with brake fluid put cover on and have someone pump the brakes until the pedal is as hard as it will get Hold the pedal down and loosen bleeder screw on back of wheel cylinder brak fluid will squirt out and when it stops him holding his foot on the floor tighten the screw and pump the brakes up hard again bleed it about 8 more times go to the drivers rear and do the same there then the front passenger side and then the front drivers side make sure the brake fluid stays full if it empties out of the master cylinder to the bottom you will have to start over12_9_2011_6_45_35_pm.jpg

Oct 25, 2011 | 1988 Dodge D-Series Pickups

1 Answer

1989 dodge dynasty - rear driver side tire wobbles. Have replaced the bearings, but still not fixed. Any suggestions as to what might be wrong?


Assuming that you mean the wheel wobbles side to side when it turns, it could be a bent wheel flange - the part that holds the lug bolts on. If that is the case, you will need a new axle half. Has the car been skidded on the pavement or been run hard into a curb?

Check that the lug bolts are on tight and are the proper size.

Aug 06, 2011 | 1989 Dodge Dynasty

2 Answers

Is this car front or rear wheel drive?


That car is front wheel drive,

Tom

Feb 18, 2011 | 1993 Dodge Dynasty

2 Answers

Can you tell me where the fuel filter is located on a 1992 Dodge Dynasty? It is a front wheel drive 3.3 ltr V6. Thank you for helping me.


The filter is under the rear passengers right seat area bolted to the floor from under the car,near the fuel tank.

Oct 22, 2009 | 1992 Dodge Dynasty

1 Answer

1989 dodge dynasty brakes


its possible the brake booster is bad its the vacuum canister on the firewall behind the master cylinder it basically gives you the power in your power brakes

Feb 01, 2009 | 1993 Dodge Dynasty

1 Answer

Heater on 1993 dodge dynasty


Make sure the hoses aren't plugged up before you start tearing things apart. Also check any fuses or relays. The relays are in the engine compartment on the left side just above the battery. If you pop open that lid on the plain unmarked black box, it will tell you what each relay is for. Hope this helps.

Oct 22, 2008 | 1993 Dodge Dynasty

2 Answers

1993 dodge dynasty check egine light


I'm assuming the check engine light is on for no reason. My dad solved this problem very easily: He got a decoder form Ace Hardware (around $15-$20 I think; he told me it wasn't very expensive). He hooked it up to the left interior of his car (driver's side, near the steering wheel area), and it gave him a code, which he then used to consult the manual with. He is a mechanic, so if you aren't one, be careful before you do anything too drastic: you may do more harm than good. GOod luck; I hope I've been helpful.

Aug 01, 2008 | 1988 Dodge Dynasty

Not finding what you are looking for?
1996 GMC Sierra Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...