Question about 2004 Honda CR-V

1 Answer

How to change backlight : how to disassembly?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Honda Expert
  • 268 Answers

If you're talking about the backlight on your radio you can contact your Honda dealer to see if your vehicle was one that they extended the warranty for with a free repair.

Posted on Oct 04, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


turn on the parking lights walk to the back of the car. no tail lights either? find what fuse burnt out and change it. hope this helped

Nov 21, 2013 | 1996 Ford Probe


How to change right boot (axle side)?

My boot is broken. I have disassembled the axel side of the driveshaft but when I tried to disassemble the CV joint I couldn’t find how to do it. Can somebody give me advice about it?
Thanks to everybody

on Jun 14, 2008 | 2000 Suzuki Esteem

1 Answer

The dash lights in my 2000 intrigue are very dim, and the fuse is still good. Do i need to change the dash bulbs?

Now in the dashboard is usually LED backlight, better brand panel to LED power supply from time to tome special points electric circuit, and not directly from the Vcc points down.
Directly from Vcc partial pressure of the backlight dimming, will directly affect the panel data output, if eliminate this phenomenon, the estimate is the first kind of circumstance using special power supply circuit.
DIY, you can check, whether the decoupling of the electrolytic capacitor failure?
maybe this web can help you

Feb 20, 2013 | 2000 Oldsmobile Intrigue

1 Answer

My backlight is not working and i dont know which fuse to change

not sure what you mean by backlight.. reverse light ? rear dome light? trunk light? brake light? most likely its a bulb that has blown not a fuse... if its reverse lights then you may have a bad reverse switch not sending the signal to the lights.

Jul 14, 2012 | Mercedes-Benz 190-Class Cars & Trucks

1 Answer

I have a 2005 mazda 3 and I think that the starter is buisted how can I fix this without going to a shop?

easy answer, you can't..
You may be able to get a second hand unit and then remove your existing starter and fit the replacement but I would NOT advise you to disassemble the starter motor yourself.
There are parts inside the motor (bushes and brushes) that will be damaged by incorrect disassembly. The springs which maintain contact between the brushes and the commutator can (and do) pop out and disappear into the wide world and replacing them can prove difficult.
The solenoid WILL be damaged if you attempt to disassemble it incorrectly and some solenoids have several small parts which will fly out and end up in the same place as the brush springs, the same place socks, earings and loose change go to.. the land of nowhere.
So, either change the starter yourself or bite the bullet and take the starter to a qualified person..
Remember, if you really want to remove the starter yourself, disconnect the negative battery cable at the battery BEFORE you do anything else..

Dec 19, 2010 | 2006 Mazda 3

1 Answer

How do I change front wheel bearings and ball joints on a 2003 chev truck

you need to take out the wheels
disassemble braking system by unscrewing the main bolt that is screwed on the shaft
and then you may have access to the bearing of the wheel
the ball joints are a little bit more tricky to change, you need to pull out the entire shaft from the gearbox to the wheels and then try to disassemble the joints that are cased with rubber protection, but you need to be very careful not to do any damage

Mar 13, 2010 | 2003 Chevrolet Silverado 1500

1 Answer

The panel lights, fog lights, and backlight will

if the vehicle starts then yes its most likely wiring or you mised a fuse or fusable linkor a faulty switch disconnected or bad ground could be a few things to look for

Aug 28, 2009 | Chevrolet Cavalier Cars & Trucks

1 Answer

Need to replace dash board backlights - 2004 hyundai elantra

trying to do the same on my 01. ready to change the bulb but can't find it anywhere.
anyhow, here's how you do it:

remove the dash by taking out 2 screws behind the ashtray and 2 above the instrument cluster
begin prying off the dash from the ashtray up, when you reach the heater vents stop. next take a flat head screwdriver and pry off the dash from the left side with the door open. work left to right till you reach the heater vents and it'll come right off. you don't necessarily have to unplug any of the electric connectors if you don't want to, but you;ll have to reach around the dash while working. all you need to do now is remove the heater control unit via the 4 screws around it, then unplug the electric harnesses from the back of it. make sure you remember which goes where. the bulbs are the 3 white (or is it 2 white and 1 grey) circles on the back of the control unit. just turn them with a flathead screwdriver and turn it over and give it a little bump to get 'em to fall out (or grab 'em with a needle nose pliers if necessary). anyhow, that's how it's done, question is, where do ya find the bulbs?

Dec 31, 2008 | 2004 Hyundai Elantra

Not finding what you are looking for?
2004 Honda CR-V Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides