Question about 1997 Nissan Quest
Autodata Supply data like this on CD and in print, your local Garage may have access and be able to help for a fee. This kind of info may have to be paid for. Maybe there is a Haynes manual that covers it?
Posted on Oct 03, 2009
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I guess you have checked the sparkplug and power wires and they are ok. In that case the only thing left is the electronics module of the engine - go to a repair shop and connect it to a tester, it's most likely fried . You can't fix that, replace it
Posted on Oct 31, 2009
This is a major job and not advised for a beginner without guidence, If your dead set on doing it yourself, make sure you have someone to fall back on if you make mistakes. I would suggest that you buy a workshop manual from a parts store and follow the instructions from there, $20 well spent. Good luck and safe driving.
Posted on Jan 01, 2010
The Quest has a non interference engine meaning that should the belt break the engine would just die without breaking anything. Nissan recommends 105K for changing but that depends on the way the vehicle was driven (driving habits), road conditions etc. If driving on roads for e.g. that are hilly, it labors the engine more thus shortens the lifespan of the belt according to mfg.
Posted on Mar 18, 2010
The camshaft sensor is located inside the distributor and is part of it, in order to replace it you must replace the distributor,to replace remove the dist cap. mark the location of the rotor,by marking where its pointing to, then mark the dist housing, so now theres a mark on the rotor and housing to show where rotor points, next mark the location of dist going into housing, mark the shaft and the block,because it spins in block this way you can line back up.next remove hold down bolt and pull out,mark the new dist in exacat same spots as the old so you can install back the same,you may have to put it in and pull it out until your marks are lined up,this way the timing will be dead on, when done you can check timing. good luck
Posted on May 09, 2010
Tips for a great answer:
Apr 05, 2017 | 1997 Nissan Quest
Nov 16, 2016 | Nissan Cars & Trucks
Jan 31, 2011 | 1997 Nissan Quest
Jun 22, 2010 | 1997 Nissan Quest
May 09, 2010 | 2004 Nissan Quest
Jun 21, 2009 | 1997 Nissan Quest
Jan 31, 2009 | 1995 Nissan Quest
543 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: