Question about 2006 BMW L7

1 Answer

SHUTTING OIL MAINTANACE LIGHT OFF 1986 BMW L7

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 23 Answers

You either have to go to a BMW dealer or a shop that has a reset tool. there's no trick

Posted on Oct 04, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bmw e46 problems


May need a new oil pressure switch,it's located next to oil filter,remove electrical connector then part.You may have to remove oil filter to remove part.

Jan 06, 2014 | 2001 BMW 318i

1 Answer

BMW 86 L7 key turns on all the lights on various gauges but the car does not turn over. Replaced the starter but still the same problem. Could it be an anti theft switch, or electrical problem? Help.


yes, if the security light is on, it would be the anti-theft system. If no light, maybe it's the safety interlock. Try starting in neutral or giggling the shifter. If neither of these, please see my tip at http://www.fixya.com/cars/r6222268-engine_doesnt_crank_turn_over . These are generic instructions. If you get stuck or need specific instructions for your car, please get back to me with model, year and engine info.

Oct 28, 2010 | 1986 BMW L7

1 Answer

On board computer just stopped working .but fuses are good


the computer must be changed it is usally located under the dashboard on the drivers side and just unplugs with some screws to remove it.

Mar 13, 2010 | 1986 BMW L7

2 Answers

The blower on my 1986 bmw l7 some times and some


check your switch first make sure it is having continuity with the switch removed second these motors did fail at the clips with corrosion from time to time. inspection guide.
1.Remove cowl ventilation grill
2 Remove hood seal and 12 screws holding intake cover
3.Mark and then disconnect vacuum servos
4Remove relay bracket and temp sensor
5.inspect wiring and connectors with key on lightly push on the wires to find the problem connector removal is quite difficult be very careful taking connector off and if connectors look good there is a short in the motor its self.

Feb 10, 2010 | 1986 BMW L7

1 Answer

Reset warning lights BMW 325


make abs sensor is properly plug in if they are not you will see that light

Jul 01, 2009 | 2006 BMW L7

1 Answer

86 Bmw 735i stops running when hot


check your crank shaft sensor if it did not move and the clearance is 1 mm gap i think this is to close and when the car gets hot the clearance closes

Jun 29, 2009 | 1986 BMW L7

1 Answer

HOW COULD I READ CHECK ENGINE CODE ON A 1986 BMW 325E???


You can't use a tool to pull codes from an '87 BMW 325(e). You have the 2.7 liter and your DME, or computer is a Motronic. If you had a 325i, then a tool could read the codes because the computer was upgraded that year to a Motronic 1.1 system with a round plug in under the screw cap on the driver's side under the hood. The only tool you can buy is the one for resetting the service interval light and resetting the oil change light. To answer your question about going about finding your driveability problem would be to get a BMW Bentley Manual. This manual shows you how to use a standard voltmeter to check everything from your computer plug in. Your computer is located above the glovebox.

Good Luck,

~Stillin~

Jun 05, 2009 | 1986 BMW 3 Series

1 Answer

Fuel pump won't come on. 86 BMW L7


check wires, and fuel pump, if those are fine it may be the electronic control unit

Apr 25, 2009 | 1986 BMW L7

1 Answer

How do I remove the dash board of BMW 735l


Are you loosing engine coolant? If so,maybe a heater core issue.This usually requires instrument panel removal. If so it is labor intensive.This is a job for a mechanic with at least a 7 to 8 skill level on a scale of 1 to 10.Good Luck..

Oct 18, 2008 | 1986 BMW L7

1 Answer

86 bmw L7


I think your problem might be your fuel relay which is situated next to the fuse box in the engine compartment.

Jul 13, 2008 | 1986 BMW L7

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers

Frankie B

Level 2 Expert

65 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...