Have an mgmgt changed the battery for remote central locking but this has not worked dont want to open the door manuley in case the alarm goes off do i need to push the buttons in an order or something stupid like that to reactivate it
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Which fuse box ? under the hood in engine compartment or inside the passenger compartment ? The front electronic control module controls the power lock's . Fuse # F2.14 -10 amp located in the central junction box powers the FEM . Fuse # F2.6 - 15 amp located in the central junction box powers the keyless entry module. Did you try battery in the key fob (remote ) ? Take it to a qualified repair shop an have code's checked .
If a car has an on board computer there is always a risk of creating a problem when the battery is removed.
I would say the previous owner experienced this but chose to ignore it.
The solution is to have the central locking system re-programmed.
You can check with your Toyota dealer the cost for this (Approximately 5 to 10 minutes work) or search the internet for the sequence required.
The link to a forum may give you a better insight Programming Alarm Remote for Toyota HiLux
If central locking is ok by key then must be the plug from the keyless entry box,also it can be the inside relay (box defect).If the central locking does not work by key ceck fuses.
unlock car with key/hold over for 30 secs then lock car with key/hold over for 30 secs then unlock with remote hold button down for 30 secs.this should reset system.
Hi I wonder if you can advise me ,my central locking and alarm is very unreliable it keeps making a beep before the ignition goes on and clicking,it sometimes sets the alarm off,Ive had the AA round and theyve told me the car battery is dead,which I appreciate,but think the key hub central locking or alarm is running the battery low does the hand held button need a new battery,or can I take the fuse out for the central locking,dont want to pay 66 quid for a new battery if I can pay 2 quid for a new battery for the central locking button,or demobilize it
try locking and unlocking the car with the key 3 times slowly ,other than that i have no idea ?? another trick is to disconnect battery and join the cables together for a few minutes to discharge any capacitors that may be holding a charge in the computer..Only other thing i can think of is the main dealers who have the right connectors and software to re set it all .sorry i havent been of any help
hi this works on most voyagers disconect the possative terminal on the battery for ten minites excactly then reconnect and happy days your voyager centrol locking should work ok good luck
×