Question about 2003 Chrysler PT Cruiser

1 Answer

I have Crysler PT Cruiser. It jump when I put the gear in drive. What part should I replace?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 736 Answers

Check the idle speed .. it probably should be around 600 rpm .. if its higher then the transmission will jump ... that is probably controlled by an idle speed sensor ..

Posted on Oct 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2007 pt cruiser wont work in reverse


Try to add LUCAS OIL transmission anti-slipp additive. It helps smooth the shifting. If this helps you need to replace transmission fluid with the filter and add fresh fluid with Lucas oil additive ..

May 02, 2014 | 2007 Chrysler PT Cruiser Touring Hatchback

1 Answer

03 pt cruiser makes rattling noise when put in drive


does it make the noise and goes away within 5 to 10 seconds then it drives and shift fine let me know ok

Nov 27, 2012 | 2003 Chrysler PT Cruiser

1 Answer

My Crysler PT Cruiser 2002 has a 'no bus' indicated on the odometer.


The message means there is a problem between the ECM computer and the BCM computer. Usually a problem with a harness or connector.

Sep 08, 2012 | 2002 Chrysler PT Cruiser

2 Answers

2002 PT Cruiser would not start.


Did they do a charging system check, check starter and alternator first more details plz and i may be more help.

Mar 08, 2012 | 2002 Chrysler PT Cruiser

1 Answer

I" have a 2006 Crysler


you have a code in the computer. take it to your local parts store they will plug into it and tell you which sensor it is

Jan 21, 2011 | 2006 Chrysler PT Cruiser

1 Answer

How to change headlight on crysler pt cruiser year 2000


You have to jackup the front where the headlight is burned out and look for a compartment door in the wheel well (front) to open and it will give you access to where the headlight is located.

Apr 08, 2010 | 2001 Chrysler PT Cruiser

1 Answer

How to put gear oil in a 2003 pt cruiser


you dont need gear oil. you just need trans fluid. the differential is part of trans and uses trans fluid from trans. just put it in though dip stick tube

Apr 08, 2010 | 2003 Chrysler PT Cruiser

1 Answer

Replaced timing belt and noticed the rubber bushings in the torque struts were broken. Right engine mount rubber also cracked, Did not replace them and the engine jumps up when put in drive.Do I need to...


hi yes it would be adviseable to replace all three, if they are broken its a sure sign they need replacing, if not you could cause more damage to other parts like exhaust and gear linkage and maybe fuel lines ( these suffer from bad fuel lines as it is ) so to save a lot of bucks spend a few..hope this helps

Feb 21, 2010 | 2002 Chrysler PT Cruiser

1 Answer

How do you change a timing belt on a 2001 crysler pt cruiser?


to change the belt on this vehicle you have to evacuate the a/c syst. disconnect the a/c lines on the right side of the eng compartment. Remove drive belts, remove balancer. Support eng with a jack, remove engine mount. remove timming covers. Time eng and proceed to remove belt.

Jul 07, 2009 | 2001 Chrysler PT Cruiser

2 Answers

2001 PT Cruiser quit running driving down highway


Most likely a cam sensor or a crank sensor. The timing belt didn't break did it? They also have an issue with the timing belt tensioner going bad and jumping a tooth.

Mar 05, 2009 | 2001 Chrysler PT Cruiser

Not finding what you are looking for?
2003 Chrysler PT Cruiser Logo

Related Topics:

330 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...