Question about 1995 Ford Taurus

3 Answers

No spark installed new coil and had mogel for the distibutor checked

Posted by on

  • 1 more comment 
  • dmenace176 Oct 04, 2009

    No spark installed newno spark installed new coil and had mogel for the distibutor checked

  • dmenace176 Oct 04, 2009

    were is the cam sensor

  • dmenace176 Oct 08, 2009

    the gear was worn on the distributor, bad anought that it stop turning. have u seen this befor?

×

Ad

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 691 Answers

Assuming dist,cap,rotor,plugs, wires are good and their power to coil. the only thing will not make the plugs fire is the cam sensor is faulty. what cam sensor does is that it sense the turning of the cam and the sensor send single to ECU, than ECU tell the coil to released the charge from the coil to the plugs. The cam and crank sensor tend to go bad over time and due to ages and heat exposure, if you change out cam sensor I would also change out the crank sensor. The crank sensor does the same but it turn on your fuel pump. hope that help some

Posted on Oct 04, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Ford Master
  • 426 Answers

Check fuses relays and ground wires. The check inside the distributor cap and make sure the piece the rotor inside distributor is clean of oil and the area below hall effect is dry and without oil.The piece down below is also a item that can effect it from firing.it is a magneto and it controls the firing and fuel by sending signals to the ecm. If you check the above without finding an issue the best thing to do is see if you can borrow a scan tool to get any codes that could be helpful with diagnosing. Im sorry if this isnt exact help but it is trail and elimination that fixes issues like this instead of just replaceing parts.

Posted on Oct 03, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,865 Answers

Check either ignition switch or ECM

Posted on Oct 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What are all my possible problems if i have no spark?


Check power and ground at the coil with the key on. Always a possibility you bought a bad coil.

Jul 24, 2015 | 1997 Chevrolet C1500

1 Answer

No. spark will not start


check see if coil getting power.if no check ignition fuse if yes getting power at ignition coil.either ignition coil is bad or thick film module on distibutor faulty.ignition timing way off or you have worn distributor cap and rotor. worn spark plugs and wires.

Jul 10, 2013 | 1991 Ford F250

1 Answer

New spark plugs, new spark plug wires, new distibutor, new distibutor cap, new coil, new coil wire still not getting any spark why?


I know you list a new distributor, but the pick up coil (inside the distributor) is what will trigger the coil for spark. Located under the rotor, it needs to be checked at the harness for voltage (key on) and measure resistance in the PU coil itself using an ohm meter. Check the harness for breaks or damage, there really is nothing else that might cause this unless you have a complete failure in your engine computer (located next to the battery).

Oct 04, 2011 | 1987 Plymouth Sundance

1 Answer

Not firing on #1 cylinder. 2002 Chevy Trailblazer, In-line 6 cyl. Swapped ignition coil and installed new spark plug. Same error code. Where does the signal for the ignition coil to fire come from? Is...


{: ) It is the engine control module that gives signals to ignition coils . Visually inspect the wirings for the #1 cylinder. But I still suggest that your vehicle be thoroughly scanned to monitor the different parameters and data present on your vehicle.

Jan 20, 2011 | 2006 Chevrolet Trailblazer

2 Answers

There is no spark coming from the distibutor cap but there is spark coming from the coil.


if you have spark coming from the end of the coil wire and none coming from the cap you need to replace the rotor bug.

Jan 17, 2011 | 1987 Nissan Pathfinder

2 Answers

2000 dodge durango 318 v8 quit running while driving.cranks but won't start or fire.


Check to see if there is any spark coming to the spark plugs from the distributor,if so change out your plugs, if not check from the coil to the distibutor, if so then change distibutor cap and button( if that still dossn't get it try the entire distributor), if not than check the hot wire going into the coil and if that is hot try replacing the coil but if not then i think you may have an electronic or wireing issue

Aug 11, 2010 | Dodge Durango Cars & Trucks

2 Answers

1994 volvo 850 has no spark, was running and died. Have checked everything back to the computer. Is it possible to check Computers?


Yes,it is possible with diagnostic equipment.In your case you heed to check ignition amplifier and coil.They are together.

Dec 02, 2009 | 1994 Volvo 850

1 Answer

1993 5.2 litre dodge dakota with no spark. Replaced coil, replaced coil wire, replaced computer. Still no spark. Now what?


didyou check the cranck sensor? or the distibutor pick up coil, those sensors pick the ignition signal for the computer and send the spark of the coil if any of those sensors are broken dont work the engine and plus check the injection pulses of the fuel injectors too . i hope be help for you fellow

Oct 20, 2009 | 1993 Dodge Dakota

Not finding what you are looking for?
1995 Ford Taurus Logo

200 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5530 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...