Question about 2002 Buick Century

2 Answers

My 2002 Buick Century keeps blowing out the 20a fuse for the door locks. This dosn't happen right away but maybe the second or third time I use the remote switch.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 198 Answers

The circut is being overloaded.I beleive the cigarette lighter,the power mirrors and maybe the trunk release is connected to this circut.If there are any problems with any of these items the use of the doorlocks will overload it.GM always had problems with their cigarette lighters shorting.If none of these items are faulty.Have the door lock solenoids checked

Posted on Oct 03, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

There might be a fray in the wiring which could cause the crdut to over load also check your cigarette lighter a penny or dime might have fallen in and is causeing the circut to overload

Posted on Aug 18, 2010

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 201 Answers

SOURCE: Steering wheel removal buick century 2002

look on back side of center cushion arms,there are fastners there that hold this peice on then rest is easy..

Posted on May 09, 2009

bryan213
  • 8 Answers

SOURCE: my car is jerking while accelerating and reaching certain RPM

clean mass air flow sensor check for mil light

Posted on Jun 01, 2009

emissionwiz
  • 75030 Answers

SOURCE: 03 Buick Century DUal Climate problem

the problem is a part called the air temperature control blend door acuator motor, it is deep inside the dash and the dash must be removed to replace it.

Posted on Jul 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 02 buick century the pcm fuse keep blowing.


look for shorted or melted wires ,or grounded wires

Sep 27, 2014 | 2002 Buick Century

1 Answer

Blown fuse wont start


20A FUSE 8 feeds the starter and fuel pump.

Jul 14, 2017 | 2002 Chrysler Sebring

1 Answer

Have 2002 buick century custom, drivers power window - slid down on its own and would not go up - took door panel off and found it was cable off track and got the cable back on roller - window back up but...


maybe the bolt doesn't go anywhere, keep it with you, if it belongs anywhere something will happen sooner or later, could just be a lost bolt from another repair

Nov 24, 2010 | 2002 Buick Century

1 Answer

The driver's window on my 2002 Buick Century won't roll up and it's stuck down inside the door. How can I pull it up? This happened to one of the back windows a few weeks prior but it didn't fall all the...


remove the inner door pannel the screws securing it will be in the handel and hiden clips around the edge prise them away with a flat bladed screwdriver, once removed you will see the window glass that has come off its runners, undo the winding mech from its fixings and reposition the glass in its runners, you can lock the glass in the up position with a piece of thin wood or simillar if you cannot fix why it came off its runners,

Oct 29, 2009 | 1999 Buick Century

1 Answer

Where do I find the instructions for programing a buick century 1997 keyless remote?


METHOD 1 - NO TOOLS REQUIRED

  1. Sit in the vehicle driver's seat.
  2. Remove the ignition key from the ignition lock cylinder.
  3. Close all of the vehicle's doors.
  4. Press and HOLD the door "LOCK" switch to the "Unlock" position.
  5. Insert and remove the ignition key twice (without rotating the ignition lock cylinder).
  6. Insert the ignition key a third time leaving the key in the ignition lock cylinder. The ignition must be in the "OFF" position.
  7. Release the door "LOCK" switch from the "Unlock" position (three fast chimes will be heard when the remote control door lock receiver enters the programming/diagnostic mode).
  8. Press and HOLD the transmitter "LOCK" and "UNLOCK" buttons simultaneously for at least 12 seconds . Two fast chimes will be heard confirming successful programming.
  9. Repeat step 8 for each additional transmitter to be programmed.
  10. Remove the ignition key from the ignition lock cylinder

Sep 26, 2009 | 1997 Buick Century

2 Answers

2000 Buick Century lighter fuse blows when TomTom plugged in.


this is the cigar lighter receptacle causing the problem, take my word on this.

Aug 17, 2009 | 2000 Buick Century

2 Answers

2002 Buick Century locks its doors automatically and constantly


i dont see this as a major or even minor problem, why is it bothering you? if you wanna idle your car in drive whats the point? if your just waiting for someone to come in, put it in pak and the door will unlock BY THEMSELVES, sounds good to me, and then after the person jumps in put in in drive/reverse.... or u can simply leave it in gear THEN unlock it, the back doors dont have power lock button so they have to do it manually or if youre in park they dont have to do it at all. its a nice feature 1 in a million would actually not like this feature

May 01, 2009 | 2002 Buick Century

1 Answer

1989 honda accord headlight fuse blows as soon as replaced


you more than likely have a shorted wire in the headlight harness... you will have to check the wiring from the headlight bulbs to see if it has been pinched up against a sharp metal edge causing a grounded wire, or maybe the harness was crushed by an improper headlight installation.

Jan 12, 2009 | 1989 Honda Accord 4 Door

1 Answer

Turning Signal Fuse Keeps Blowing - 1998 Buick Century


one of the bulb holders is no good or wires trapped somewhere that feed indicator lights

Nov 16, 2008 | 1998 Buick Century

Not finding what you are looking for?
2002 Buick Century Logo

391 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...