Question about 2000 Ford Econoline

1 Answer

Blows on cold air, engine water temp normal - 2000 Ford Econoline

Posted by on

  • thunderalley
    thunderalley May 11, 2010

    does it blow on any other setting????

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 881 Answers

Under the bonnet you have a vac air line going to a small switch on the inlet heater water pipe and either its come off or the valve is RS so when warm just put your hand on the 5/8" hoses and see if the hose is cold (it could be slightly warm up to the valve and cold after if so either remove the valve or find a vac pipe and join it to it and it will open and get hot as water will flow again Ron

Posted on Oct 03, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 caddy Seville ...after starting and engine warm turn on the heater and it blows cold air. Fan works / waiting for hot air and then all the sudden it kicks in. Engine at normal temp


Low coolant, if there is an air pocket in the engine it will make it to the heater core. Once there , the air coming out is cold/cool. Once the coolant fills the heater core, it gets hot. If the coolant is fine hot or cold, then have the HVAC system scanned.

Oct 09, 2016 | 2000 Cadillac Seville

1 Answer

The temp gauge on my 2008 ram 1500 jumps from normal temp to hot checked engine the temp is fine my heater them puts out cold air and I have no heat if I shut heater off and wait a few minutes temp gauge...


It probably low on coolant. The heater will blow cold when there is not enough water (coolant) to keep the heater core full. Check the radiator (not the overflow reservoir) when it's cool.

Nov 05, 2013 | 1996 Dodge Ram 1500 Club Cab

1 Answer

My heater fan turns on before the car has warmed up. It blows cold air? Any ideas why?


After warmup it still blows cold, or only when cold? Normally the fan will operate independently of engine temp except in some climate controlled vehicles. As long as it blows warm air after engine is at temp that's a good thing. the heater uses hot water from the engine. Obviously the heater can't be warm before the engine is. If it's cold after the engine is hot, there are vacuum controlled "motors" on top of the heater box under the dash that move doors that control heat. Either one of the control motors or one of the doors have stuck or failed. Many also have a control valve on one of the heater hoses under the hood as well. If the engine comes up to temp then the thermostat is good (should be at about 210f) Only remaining item is the core itself which may be internally or externally obstructed.
All this being said, if it's good when the engine is up to temp, leave it alone...it's fine.

Nov 30, 2009 | 1996 Jeep Grand Cherokee

2 Answers

Ford mondeo mk3, intermitent dumping of water from cooing system,found crack in header tank, changed same,ran car at idle, temp guage at normal & heater blowing hot , took car for run , temp guage off...


You may have an air pocket in your system which some times happens.  One way to get rid of it is to take the upper hose off on the engine side,  fill your system with water until it runs out from your engine block, replace the hose, start your car turn you heater on and set to hi keep the radiator cap loose until the temp start to rise then close tight.  Once the air pocket had been remover you can drain some of the water from the radiator using the lower drain plug and add antifreeze.   

Mar 09, 2009 | 2001 Ford Taurus

1 Answer

Engine overheats when heater pipes connected


I think you could be right about there being air trapped in the system.
Or the heater core(radiator) is plugged.
Either way you need a pressurized radiator coolant pump to put the coolant in without air being trapped.
Although,i have seen it done by jacking the vehicle up high enough that the radiator was now higher than the heater core level, and then the coolant was put in.
But this is dangerous to try.

Jan 29, 2009 | 1999 Ford Escort

2 Answers

2001 JEEP ..RADIATOR IS COLD


what is the water temp at the dash...leave the rad cap off until normal temp... might be an air lock. If the engine overheats fast and blows coolant out the filler then its a blocked radiator...why did you repace the thermostat

Dec 24, 2008 | 2001 Jeep Cherokee

1 Answer

1995 ford windstar overheat after replacing the thermostat


Let your engine warm up with the rad. cap off and see if the coolant level drops. and make sure your overflow is full. It blows cold air because there is no water getting to the heater core. And it shows a normal(ish) temp because the water needs to be touching the temp. sensor. I really do think there is air in the system and there is not enough coolant but hard to tell from here. Also as with overheating any time make sure to check your oil and look for any coolant as the head gasket seldomly holds together if the motor overheats.

Dec 22, 2008 | 1998 Ford Windstar

4 Answers

Heater blowing cold air


My 2005 Nissan Sentra 1.8s with 55,000 mi. blows cold air from the heater. Coolant not circulating in engine. Lower hose stays cool to touch. Both heater hoses cold. Changed thermostat - didn't fix it. Coolant not leaking or dirty. None in oil - no oil in radiator. Changed worn water pump belt - pump spins freely with no noise or resistance. Cooling fans come on after warm-up. Temperature gauge stays in normal range then jumps to hot and back again. Coolant good to 10 below - didn't freeze here yet. No other problems or repairs to car. Afraid to drive and make worse. Help!

Dec 22, 2008 | 2002 Nissan Sentra

Not finding what you are looking for?
2000 Ford Econoline Logo

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5530 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...