Question about Peugeot 405

1 Answer

My 4yr old 206 wont start when cold and cuts out sometimes. Ive replaced battery the cold sensor,ignition coil pack, we even replaced the cat convecter and lamph cable think its called.theres nothing showing on diagnostic check machine. i leave for work at6am and most mornings it wont start.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 750 Answers

Check the spark plugs also if you can,do a compression test on engine

Posted on Oct 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

05 Hyundai sonata 2.7 started missing all the sudden and vibrates/shakes real bad when idling MIL on giving p0305 code why?


Possible causes
  • Faulty spark plug 5
  • Clogged or faulty fuel injector 5
  • Faulty ignition coil 5
  • Fuel injector 5 harness is open or shorted
  • Fuel injector 5 circuit poor electrical connection
  • Ignition coil 5 harness is open or shorted
  • Ignition coil 5 circuit poor electrical connection
  • Insufficient cylinder 5 compression
  • Incorrect fuel pressure
  • Intake air leak


you need an odb2

Jun 17, 2017 | Hyundai Cars & Trucks

1 Answer

Why wont my 2002 olds alero start when its cold out


One of the coil packs or the ignition module is probably bad. Test for spark when cold. If no spark on any coils suspect the ignition module or crank position sensor. If spark is gone on only one coil check the plugs and wires to that coil pack. If theplugs and wires are ok then replace thge coil pack. Don't forget the obvious load test the battery and clean the battery connections. If the check engine light is on run any diagnostic codes and repair

Dec 03, 2014 | 2002 Oldsmobile Alero

2 Answers

98 ford explorer replaced egnition. Now it wont start. Starting fluid does turn it over. But isn't getting feul


out of fueL, bad fuel , old fuel>?

replace what exactly , ignition parts t are many.
key switch.?
Igniton coil(or coils, or cops or coil packs)
Distributor.
spark wire, (not replaced 1 by 1 = fail..)
ok , the PCM monitors spark and that fails, (even if spark is good)
it will cut fuel. so what did you touch>?

i use a noid light, if pass I check fuel pressure
if noid fails, i find out why PCM is cutting fuel.
check fuses 1st. always. for ever. and ever

Jul 05, 2014 | Cars & Trucks

1 Answer

Ive got a 1995 toyota 4runner. PROBLEM: SPERATICALLY CUTS OFF WHILE DRIVING GIVING NO SIGN.Seems like ive got something getting hot nd killing the motor, after the truck sits for a little while whatever it...


replce temp sensors one by one and reset comp by disconnect battery and leave ignition in the on position for at least 30 mins the replace battery leads

Feb 28, 2014 | Toyota 4Runner Cars & Trucks

1 Answer

Car dies when it gets warm wont restart until it completely cools off


ignition module may be getting hot and cutting out..

Dec 15, 2013 | 2001 Buick Century

1 Answer

Peugeot 206 problems


Probably gas or spark related. Check for spark on a spark plug wire, or on a couple of plug wires would be better. If you have a strong blue spark, then the coils are good, ignition is good, and you will need to see if gas is getting up to the engine. Do you hear the fuel pump come on?

Nov 11, 2013 | Cars & Trucks

1 Answer

Wont start


Its old enough, how about the coil packs? Crank position sensor?

May 16, 2010 | 2000 Oldsmobile Intrigue

2 Answers

How do i knw if my timing chain is bad? i have changed the position sensor had a tune up my car just stoped running last wed its a 89 lesaber dnt usually have problems with it other than normal wear and...


Timing chains on 3800 engines do not go bad. The older 3.8 1987 back did. You need to put a crank sensor on it first also check the ign. module under coil pack for green gel that may be coming out of it. Clean the all three battery cables and replace the two bolts too. My 1990 lesabre 3800 has 295000 miles on its timing chain.

Jun 30, 2009 | 1989 Buick LeSabre

1 Answer

Car wont start


I noticed you replace the crankshaft sensor, but not the CAMshaft sensor.
The Ignition module takes the input of both sensors to tell the coil when to energize.
This sensor should come up as an error code when you attach a obd reader.
Even if your light is not on - there may be a code. If it is not your vehicle originally, some people pull the bulb!

Jan 21, 2009 | 1993 Pontiac Bonneville

2 Answers

Peugeot 206 2001 GTI


Check the alternator belt for proper tension. Also check alternator voltage output. If output is low the rest of the systems can fail.

Jul 05, 2008 | Peugeot 405 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

274 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...